400W Single Output with PFC Function EPP-400 series Bauar t gepruft Sicherheit egel ma ge od o s be wac g www. tuv.com ID 2000000000 ■ ‧× ‧ ‧ ‧Ⅰ ■ ‧ ‧ ‧ ‧ Ⅱ ‧ ‧ ‧ ‧ ‧ ‧Standby 5V@1A with fan , 0.6A without fan ‧Built-in remote sense function ‧ ‧ ‧ ■ ⅠⅡ ■ File Name:EPP-400-SPEC 2017-08-11 EPP-400 400W Single Output with PFC Function series SPECIFICATION MODEL EPP-400-12 EPP-400-15 EPP-400-24 EPP-400-27 EPP-400-36 EPP-400-48 12V 15V 24V 27V 36V 48V 33.3A 26.7A 16.7A 14.9A 11.2A 8.4A 16.7A 10.5A 9.3A 7A 5.3A 399.6W 400.5W 400.8W 402.3W 403.2W 403.2W Convection 249.6W DC VOLTAGE CURRENT RATED POWER OUTPUT 25CFM Convection 20.8A 25CFM 250.5W 252W 251.1W 252W 254.4W RIPPLE & NOISE (max.) Note.2 120mVp-p 150mVp-p 200mVp-p 200mVp-p 250mVp-p 250mVp-p VOLTAGE ADJ. RANGE (MAIN OUTPUT) 11.4~12.6V 14.3~15.8V 22.8~25.2V 25.6 ~ 28.4V 34.2 ~37.8V 45.6 ~50.4V VOLTAGE TOLERANCE Note.3 ±3.0% ±3.0% ±2.0% ±1.0% ±1.0% ±1.0% LINE REGULATION ±0.5% ±0.5% ±0.5% ±0.5% ±0.5% ±0.5% LOAD REGULATION ±1.0% ±1.0% ±1.0% ±1.0% ±1.0% ±1.0% SETUP, RISE TIME 1000ms, 30ms/230VAC HOLD UP TIME (Typ.) 16ms/230VAC 93% 94% VOLTAGE RANGE Note.4 80 ~ 264VAC INPUT 113 ~ 370VDC FREQUENCY RANGE 47 ~ 63Hz POWER FACTOR PF>0.94/230VAC PF>0.98/115VAC at full load EFFICIENCY (Typ.) 91.5% 92% AC CURRENT (Typ.) 4.2A/115VAC 2.1A/230VAC INRUSH CURRENT (Typ.) COLD START 40A/115VAC LEAKAGE CURRENT <0.75mA / 240VAC OVERLOAD PROTECTION 1500ms, 30ms/115VAC at full load 12ms/115VAC at full load 93.5% 80A/230VAC 105 ~ 135% rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed 13.2 ~ 15.6V OVER VOLTAGE 93% 16.5 ~ 19.5V 26.4 ~ 31.2V 29.7 ~ 35.1V 39.6 ~ 46.8V Protection type : Shut down o/p voltage, re-power on to recover OVER TEMPERATURE Protection type : Shut down o/p voltage, recovers automatically after temperature goes down 5V STANDBY 5VSB : [email protected] without fan, 1A with fan 25CFM ; tolerance ±2%, ripple : 120mVp-p(max.) FAN SUPPLY [email protected] for driving a fan ; tolerance ±10% FUNCTION PS-ON INPUT SIGNAL 52.8 ~ 62.4V Power on: PS-ON = "Hi" or " > 2 ~ 5V" ; Power off: PS-ON = "Low" or " < 0 ~ 0.5V" POWER GOOD / POWER FAIL 500ms>PG>10ms ; The TTL signal goes high with 10ms to 500ms delay after power set up ; The TTL signal goes low at least 1ms before Vo below 90% of rated value WORKING TEMP. -30 ~ +70℃ (Refer to "Derating Curve") WORKING HUMIDITY 20 ~ 90% RH non-condensing ENVIRONMENT STORAGE TEMP., HUMIDITY -40 ~ +85℃, 10 ~ 95% RH TEMP. COEFFICIENT ±0.03%/℃ (0 ~ 50℃) VIBRATION 10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes SAFETY STANDARDS UL60950-1, TUV EN60950-1, IEC60950-1 approved I/P-O/P:3KVAC I/P-FG:2KVAC O/P-FG:0.5KVAC WITHSTAND VOLTAGE SAFETY & ISOLATION RESISTANCE I/P-O/P, I/P-FG:100M Ohms / 500VDC / 25℃/ 70% RH EMC Compliance to EN55032 (CISPR32) Class B, EN61000-3-2,-3 EMC EMISSION (Note 5) EMC IMMUNITY Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, EN61000-6-2, heavy industry level, criteria A MTBF 194.1Khrs min. OTHERS DIMENSION PACKING NOTE MIL-HDBK-217F (25℃) 127*76.2*35mm (L*W*H) 0.39Kg; 36pcs/15Kg/1.03CUFT ClassⅠ ClassⅡ File Name:EPP-400-SPEC 2017-08-11 EPP-400 400W Single Output with PFC Function series Block Diagram PFC fosc : 90KHz PWM fosc : 100KHz +5VSB DETECTION CIRCUIT RECTIFIERS & FILTER POWER SWITCHING PWM CONTROL +5VSB RECTIFIERS & FILTER RECTIFIERS & PFC EMI FILTER I/P +12V FAN SUPPLY +S RECTIFIERS & FILTER POWER SWITCHING +V -V -S PG PG DETECTION CIRCUIT FG CONTROL O.L.P. O.V.P. PS/ON CONTROL Derating Curve Output Derating VS Input Voltage 100 400 With 25CFM Fan 90 250 80 70 LOAD (%) LOAD (W) EPP-400:115VAC Converction 190 160 EPP-400:230VAC Converction 130 -30 PS-ON 0 10 20 30 40 50 60 AMBIENT TEMPERATURE (℃) 70 (HORIZONTAL) 60 50 40 80 90 100 115 120 140 160 180 200 220 240 264 INPUT VOLTAGE (VAC) 60Hz Without Fan Watt 250W With Fan Watt 400W File Name:EPP-400-SPEC 2017-08-11 EPP-400 400W Single Output with PFC Function Mechanical Specification series Unit:mm 127 5.6 HS3 HS2 1 2 F8A 250V FS1 CN12 +V ACL ACN 1 21 43 31 42 -V CN1 3 CN95 CN11 HS4 SVR1 HS1 64.8 76.2 5.7 115.8 4 -ψ 3.5 FG 5cm Air flow direction 25CFM 3 max. 35 FAN AC Input Connector (CN1) : JST B3P-VH or equivalent Pin No. 1 2 3 Assignment AC/N No Pin AC/L Mating Housing Terminal JST VHR or equivalent JST SVH-21T-P1.1 or equivalent DC Output Connector (CN2,CN3) Pin No. CN2 CN3 Assignment Output Terminals -V M3.5 Pan HD screw in 2 positions Torque to 8 lbs-in(90cNm)max. +V Function Connector(CN11): TKP DH2I-2X2 or equivalent Function Connector(CN95): TKP DH2L-2X2 or equivalent Pin No. 1 2,4 3 Assignment 5VSB DC COM PS-ON Mating Housing Terminal TKP DH2 or equivalent TKP or equivalent Pin No. 1 2 3 4 Assignment -S +S DC COM PG Mating Housing Terminal TKP DH2 or equivalent TKP or equivalent FAN Connector(CN12) : TKP 8812-2 or equivalent Pin No. 1 2 ※ Assignment DC COM +12V Mating Housing Terminal TKP 2502 or equivalent TKP 8811 or equivalent Note: When the input voltage is AC 230V the model delivers EMI Class B for both conducted emission and radiated emission for the power supply, When the input voltage is AC110V the model delivers EMI Class B for conducted emission ,Class A for radiated emission for the power supply. It delivers Class A for conduted emission and radiated emission, when configured into ClassⅡ (without FG) system. Installation Manual Please refer to : http://www.meanwell.com/webnet/search/InstallationSearch.html File Name:EPP-400-SPEC 2017-08-11