1.0X0.5mm SMD CHIP LED LAMP APHS1005SURCK HYPER RED Description Features 1.0mmX0.5mm SMT LED, 0.5mm THICKNESS. The Hyper Red source color devices are made with DH LOW POWER CONSUMPTION. InGaAlP on GaAs substrate Light Emitting Diode. W IDE VIEW ING ANGLE. IDEAL FOR BACKLIGHT AND INDICATOR. VARIOUS COLORS AND LENS TYPES AVAILABLE. PACKAGE: 2000PCS / REEL . RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.1(0.004") unless otherwise noted. 3.Specifications are subject to change without notice. SPEC NO: DSAA8724 REV NO: V.7 DATE: MAR/14/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1203001480 Selection Guide Part No. Dice APHS1005SURCK Iv (mcd) @ 20mA Lens Type HYPER RED (InGaAlP) Viewing Angle Min. Typ. 2θ θ1/2 50 150 120° WATER CLEAR Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Hyper Red λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 650 nm IF=20mA Hyper Red 635 nm IF=20mA Spectral Line Half-width Hyper Red 28 nm IF=20mA C Capacitance Hyper Red 35 pF VF=0V;f=1MHz VF Forward Voltage Hyper Red 1.95 2.5 V IF=20mA IR Reverse Current Hyper Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Hyper Red Units Power dissipation 170 mW DC Forward Current 30 mA Peak Forward Current [1] 185 mA 5 V Reverse Voltage Operating / storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAA8724 REV NO: V.7 DATE: MAR/14/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1203001480 Hyper Red APHS1005SURCK SPEC NO: DSAA8724 REV NO: V.7 DATE: MAR/14/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1203001480 APHS1005SURCK Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAA8724 REV NO: V.7 DATE: MAR/14/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1203001480