H HiTRON PCB-MOUNT DC-DC CONVERTER ENCAPSULATED MODULES 9 WATTS SINGLE & DUAL OUTPUT HDM09-S & HDM09-D SERIES FEATURES: LOW COST SINGLE & DUAL OUTPUT 2:1 INPUT RANGE 9W ISOLATED OUTPUT SIX-SIDED METAL SHIELD SPECIFICATION INPUT SPECIFICATION Input Range: 2:1 DC input range. See Ratings Chart. Input Voltage: Nominal 12/24/48 Vdc. Input Current: Various with input range & load. See Ratings Chart. Input Fuse: Use external fuse. Input Filter: Pi-Network. Isolation Resistance: 1,000 Mega Ohms. Isolation Voltage: 1,500Vdc. EMI: Six-sided metal shielding. OUTPUT SPECIFICATION Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Voltage Accuracy: Main O/P ±2.0% typical. Line Regulation: Various with output voltages. ±0.5% typ. Load Regulation: Various with output voltages. Single O/P ±1.0% typical. Dual O/P ±2.0% typical. Noise & Ripple: Typical 100mV for 3.3V/5.0V & 1.0% for others peak to peak. OVP: Built-in on main output. Adjustability: Not available. Overload Protection (OLP): Fully protected against output overload and short circuit. Typical 120-150% max. load. Consult the factory for special OLP setting. GENERAL SPECIFICATION Efficiency: 65-75% typical various with input. Switching Frequency: 40-70K Hz., various with input and loading condition. Circuit Topology: Free Running Flyback Circuit. Transient Response: Peak deviation 200mV. Recovery time < 3mS for a 25% load change. Case: Black coated steel with non-conductive metal base. Power Density: 5.6Watts. / Cubic inch. MTBF: 1,000,000 hours. Mil Std 217, 25°C. Operating Temperature: -10°C to +70°C range. 0°C to +60°C @ full load without derating. From+60°C, derating lineally to half load@ +70°C. (Refer to the Derating Chart). Temperature: -20°C to +85°C. Temperature Coefficient: ± 0.03% /°C. Cooling: Convection cooling up to +60°C @ full load. At least 100LFM moving air is recommended for Full load > +60°C in a confined area. Humidity: Up to 95%RH, Non-condensing. Commercial Grade only. NOTE: (1) All measurements are at nominal input, full load, and +25°C unless otherwise specified. (2) Line Regulation measured from High to Low Lines at full load. (3) Load Regulation measured from Full Load to 1/2 Full Load at nominal input. (4) Correct fuse size by calculating the max. DC current drain at low Line input & Load and then adding 20-25% for the desired fuse size. Due to requests in market and advances in technology, specifications subject to change without notice. -19- INPUT/ OUTPUT & VOLTAGE/ CURRENT RATINGS CHART SINGLE OUTPUT MODEL NO. HDM09-12B-S03 HDM09-12B-S05 HDM09-12B-S09 HDM09-12B-S12 HDM09-12B-S15 HDM09-12B-S24 HDM09-24B-S03 HDM09-24B-S05 HDM09-24B-S09 HDM09-24B-S12 HDM09-24B-S15 HDM09-24B-S24 HDM09-48B-S03 HDM09-48B-S05 HDM09-48B-S09 HDM09-48B-S12 HDM09-48B-S15 HDM09-48B-S24 INPUT Vdc 9.0- 18.0 9.0- 18.0 9.0- 18.0 9.0- 18.0 9.0- 18.0 9.0- 18.0 18.0- 36.0 18.0- 36.0 18.0- 36.0 18.0- 36.0 18.0- 36.0 18.0- 36.0 36.0- 72.0 36.0- 72.0 36.0- 72.0 36.0- 72.0 36.0- 72.0 36.0- 72.0 INPUT CURRENT N. L. (mA) F.L. 60 650 60 930 60 950 60 940 60 990 60 1060 35 325 35 465 35 475 35 470 35 495 35 530 20 163 20 233 20 238 20 235 20 247 20 265 OUTPUT ★ VO1(Vdc) 3.3V 5.0V 9.0V 12.0V 15.0V 24.0V 3.3V 5.0V 9.0V 12.0V 15.0V 24.0V 3.3V 5.0V 9.0V 12.0V 15.0V 24.0V OUTPUT VO1(A) 1.65A 1.65A 0.95A 0.70A 0.60A 0.40A 1.65A 1.65A 0.95A 0.70A 0.60A 0.40A 1.65A 1.65A 0.95A 0.70A 0.60A 0.40A CASE SIZE DM2B DM2B DM2B DM2B DM2B DM2B DM2B DM2B DM2B DM2B DM2B DM2B DM2B DM2B DM2B DM2B DM2B DM2B DUAL OUTPUT MODEL NO. HDM09-12B-D05 HDM09-12B-D12 HDM09-12B-D15 HDM09-24B-D05 HDM09-24B-D12 HDM09-24B-D15 HDM09-48B-D05 HDM09-48B-D12 HDM09-48B-D15 INPUT Vdc 9.0- 18.0 9.0- 18.0 9.0- 18.0 18.0- 36.0 18.0- 36.0 18.0- 36.0 36.0- 72.0 36.0- 72.0 36.0- 72.0 Symbols: "★" OVP built-in. INPUT CURRENT N. L. (mA) F.L. 50 960 50 970 50 990 30 480 30 485 30 495 20 240 20 243 20 248 OUTPUT (Vdc) +VO1 ★ -VO2 ║ +5.0V -5.0V +12.0V -12.0V +15.0V -15.0V +5.0V -5.0V +12.0V -12.0V +15.0V -15.0V +5.0V -5.0V +12.0V -12.0V +15.0V -15.0V OUTPUT (A) +VO1 -VO2 0.85A 0.85A 0.36A 0.36A 0.30A 0.30A 0.85A 0.85A 0.36A 0.36A 0.30A 0.30A 0.85A 0.85A 0.36A 0.36A 0.30A 0.30A CASE SIZE DM2B DM2B DM2B DM2B DM2B DM2B DM2B DM2B DM2B "║" Double Feedback. MECHANICAL DIMENSIONS: MM [INCHES] WEIGHT: 62.5g (2.2 Oz.) PIN ASSIGNMENT PIN NO. PIN #1 PIN #2 PIN #3 PIN #4 PIN #5 SINGLE -INPUT + INPUT DC-COM PO PIN VO1 DUAL -INPUT + INPUT -VO2 DC-COM + VO1 DERATING CHART CASE SIZE: DM2B -20-