YFWDIODE GBU804 Glass passivated single-phase bridge rectifier Datasheet

GBU8005 THRU GBU810
GLASS PASSIVATED SINGLE-PHASE BRIDGE RECTIFIER
REVERSE VOLTAGE:
50 to 1000 VOLTS
FORWARD CURRENT:
8.0 AMPERE
FEATURES
· Glass passivated chip junction
GBU
· Reliable low cost construction utilizing molded
plastic technique
7°
· Ideal for printed circuit board
3.2X45°
7°
· Low forward voltage drop
· Low reverse leakage current
R7,6
· High surge current capability
7°
7°
MECHANICAL DATA
Case: Molded plastic, GBU
Epoxy: UL 94V-O rate flame retardant
Terminals: Leads solderable per MIL-STD-202,
method 208 guaranteed
Mounting position: Any
Weight: 0.15ounce, 4.0gram
Dimensions in inches and (millimeters)
Maximum Ratings and Electrical Characteristics
Ratings at 25 ć ambient temperature unless otherwise specified.
Single phase, half wave, 60H Z, resistive or inductive load.
For capacitive load, derate current by 20%.
Symbols
GBU8005
GBU801
GBU802
GBU804
GBU806
GBU808
GBU810
Units
Units
100
200
400
600
800
1000
Volts
Maximum Recurrent Peak Reverse Voltage
VRRM
50
Maximum RMS Voltage
VRMS
35
70
140
280
420
560
700
Volts
Maximum DC Blocking Voltage
VDC
50
100
200
400
600
800
1000
Volts
Maximum Average Forward
TC=100ć
Rectified Current at
(Note 1)
I(AV)
8.0
Amp
IFSM
200
Amp
VF
1.0
Volts
Peak Forward Surge Current,
8.3ms single half-sine-wave
superimposed on rated load (JEDEC method)
Maximum Forward Voltage
at 8.0A DC and 25ć
Maximum Reverse Current
at TA=25ć
at Rated DC Blocking Voltage
T A=125ć
Typical Junction Capacitance (Note 3)
5.0
IR
CJ
uAmp
500
255
125
pF
Typical Thermal Resistance (Note 4)
RșJA
21
ć/W
Typical Thermal Resistance (Note 4)
RșJC
2.2
ć/W
TJˈTstg
-55 to +150
ć
Operating and Storage Temperature Range
NOTES: 1- Units case mounted on 3.2 x 3.2 x 0.12” thick (8.2 x 8.2 x 0.3cm) Al plate heatsink
2- Recommended mounting position is to bolt down on heatsink with silicone thermal compound for maximum heat transfer with #6 screws
3- Measured at 1 MHZ and applied reverse voltage of 4.0 VDC.
4- Units mounted in free air, no heatsink on P.C.B., 0.5 x 0.5” (12 x 12mm) copper pads, 0.375” lead length
GBU8005 THRU GBU810
GLASS PASSIVATED SINGLE-PHASE BRIDGE RECTIFIER
RATINGS AND CHARACTERISTIC CURVES
Similar pages