Magnetics Make Possible High Power High Performance Molded Surface Mount Inductors Model HA72T-06 Series Features Operating & Storage Temperature -55°C to +180°C Temperature Rise, Maximum 50°C Operating Frequency Up to 3MHz AEC-Q200 CERTIFIED Specification @ 25°C HA72T-06R10LF HA72T-06R20LF HA72T-06R33LF HA72T-06R47LF HA72T-06R68LF HA72T-061R0LF HA72T-061R5LF HA72T-062R2LF HA72T-063R3LF HA72T-064R7LF HA72T-066R8LF HA72T-068R2LF HA72T-06100LF HA72T-06330LF DCR (mΩ) Inductance μH±20% Heating Current(2) (Adc) Isat (Adc) Typ. Max. 0.10 0.20 0.33 0.47 0.68 1.00 1.50 2.20 3.30 4.70 6.80 8.20 10.0 33.0 26.2 20.3 18.0 16.1 14.4 10.3 8.4 8.3 6.6 5.4 4.1 3.5 3.2 1.8 45.0 34.0 22.0 19.0 16.5 15.0 10.0 8.5 8.0 6.5 5.0 4.2 4.0 2.5 1.5 2.5 3.2 4.0 5.0 9.0 13.0 18.0 26.5 39.0 62.0 80.0 100.0 302.0 1.7 2.8 3.9 4.2 5.5 10.0 14.0 20.0 30.0 42.0 68.0 100.0 105.0 332.0 (1) Part Number (3) Notes: (1) Inductance is measured at 100 kHz, 0.1Vac without DC current. (2) The Heating Current is the approximate DC current which causes the component temperature to increase by 50°C. This current is determined by soldering the component on a typical application PCB, and then applying the current to the device for 30 minutes. (3) The saturation current (Isat) is the approximate current at which the inductance will be decreased by 20% typical from its initial (zero DC) value. (4) The part temperature (ambient + temperature rise) should not exceed 180°C. Outline Dimensions (mm) General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. www.ttelectronicsmagnetics.com © TT Electronics plc Rev. 01 High Power High Performance Molded Surface Mount Inductors Make Possible Model HA72T-06 Series Electrical Characteristic @ 25°C Packaging / Ordering Information One reel (13”) 2000 pcs One shipping carton (6 reels) 12000 pcs Ordering Information General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. www.ttelectronicsmagnetics.com © TT Electronics plc Rev. 01