Microsemi CDLL938B Temperature compensated zener reference diode Datasheet

TECHNICAL DATA SHEET
6 Lake Street, Lawrence, MA 01841
1-800-446-1158 / (978) 620-2600 / Fax: (978) 689-0803
Website: http: //www.microsemi.com
Gort Road Business Park, Ennis, Co. Clare, Ireland
Tel: +353 (0) 65 6840044 Fax: +353 (0) 65 6822298
– TEMPERATURE COMPENSATED ZENER REFERENCE DIODES
– LEADLESS PACKAGE FOR SURFACE MOUNT
– 9.0 VOLT NOMINAL ZENER VOLTAGE
– METALLURGICALLY BONDED, DOUBLE PLUG CONSTRUCTION
ZENER
Qualified per MIL-PRF-19500/156
DEVICES
LEVELS
1N935BUR-1 thru 1N938BUR-1
CDLL935 thru CDLL938B
JAN
JANTX
JANTXV
JANS
MAXIMUM RATING AT 25°C
Operating Temperature:
-65°C to +175°C
Storage Temperature:
-65°C to +175°C
DC Power Dissipation:
500mW @ +50°C
Power Derating:
4mW / °C above +50°C
REVERSE LEAKAGE CURRENT
IR = 10μA @ 25°C & VR = 6Vdc
ELECTRICAL CHARACTERISTICS (TA = 25°C, unless otherwise specified)
MIL-PRF19500/156
MSC
TYPE
NUMBER
ZENER
VOLTAGE
VZ @ IZT
ZENER
TEST
CURRENT
IZT
MAXIMUM
ZENER
IMPEDACE
(Note 1)
ZZT
VOLTS
mA
OHMS
CDLL935
8.55 – 9.45
1N935BUR-1 CDLL935A 8.55 – 9.45
CDLL935B 8.55 – 9.45
7.5
7.5
7.5
CDLL936
8.55 – 9.45
1N936BUR-1 CDLL936A 8.55 – 9.45
CDLL936B 8.55 – 9.45
DO-213AA
TEMPERATURE
RANGE
EFFECTIVE
TEMPERATURE
COEFFICIENT
mV
°C
% / °C
20
20
20
67
139
184
0 to + 75
-55 to +100
-55 to +150
0.01
0.01
0.01
7.5
7.5
7.5
20
20
20
34
70
92
0 to + 75
-55 to +100
-55 to +150
0.005
0.005
0.005
CDLL937
8.55 – 9.45
1N937BUR-1 CDLL937A 8.55 – 9.45
CDLL937B 8.55 – 9.45
7.5
7.5
7.5
20
20
20
13
28
37
0 to + 75
-55 to +100
-55 to +150
0.002
0.002
0.002
CDLL938
8.55 – 9.45
1N938BUR-1 CDLL938A 8.55 – 9.45
CDLL938B 8.55 – 9.45
7.5
7.5
7.5
20
20
20
6.7
13.9
19
0 to + 75
-55 to +100
-55 to +150
0.001
0.001
0.001
VOLTAGE
TEMPERATURE
STABILITY
3
V ZT MAXIMUM
(Note 2)
NOTE 1: Zener impedance is derived by superimposing on IZT A 60Hz rms a.c. current equal to 10% of IZT
NOTE 2: The maximum allowable change observed over the entire temperature range i.e., the diode voltage
will not exceed the specified mV at any discrete temperature between the established limits, per JEDEC
standard No. 5.
LDS-0158 Rev. 1 (100346)
Page 1 of 3
TECHNICAL DATA SHEET
6 Lake Street, Lawrence, MA 01841
1-800-446-1158 / (978) 620-2600 / Fax: (978) 689-0803
Website: http: //www.microsemi.com
Gort Road Business Park, Ennis, Co. Clare, Ireland
Tel: +353 (0) 65 6840044 Fax: +353 (0) 65 6822298
GRAPHS
FIGURE 1
FIGURE 2
TL, Ambient temperature (C°)
POWER DERATING CURVE
ZENER IMPEDANCE VS. OPERATING CURRENT
FIGURE 3
TYPICAL CHANGE OF TEMPERATURE COEFFICIENT
WITH CHANGE IN OPERATING CURRENT
LDS-0158 Rev. 1 (100346)
Page 2 of 3
TECHNICAL DATA SHEET
6 Lake Street, Lawrence, MA 01841
1-800-446-1158 / (978) 620-2600 / Fax: (978) 689-0803
Website: http: //www.microsemi.com
Gort Road Business Park, Ennis, Co. Clare, Ireland
Tel: +353 (0) 65 6840044 Fax: +353 (0) 65 6822298
PACKAGE DIMENSIONS
NOTE:
1. Dimensions are in inches.
2. Millimeters are given for general information only.
3. In accordance with ASME Y14.5M, diameters are equivalent to Φx
symbology.
Symbol
BD
ECT
BL
S
Dimensions
Inches
Millimeters
Min
Max
Min
Max
.063
.067
1.60
1.70
.016
.022
0.41
0.56
.130
.146
3.30
3.70
.001 Min
0.03 Min
Notes
FIGURE 1. Physical dimensions 1N935BUR-1, 1N937BUR-1 through 1N940BUR-1 (DO-213AA).
DESIGN DATA
Case: DO-213AA, Hermetically sealed glass case. (MELF, SOD-80, LL34)
Lead Finish: Tin / Lead
Polarity: Diode to be operated with the banded (cathode) end postive.
Mounting Position: Any.
Mounting Surface Selection: The Axial coefficient of Expansion (COE) of this device is approximately +6PPM/°C. The COE of
the Mounting Surface System should be selected to provide A suitable match with this device.
LDS-0158 Rev. 1 (100346)
Page 3 of 3
Similar pages