Crydom DPA4119 16 pin dip ssr Datasheet

DPA Series
• 16 Pin DIP SSR
• Ratings to 1A @ 280 VAC
• SCR output
• Voltage or current-control input
• Zero-crossing (resistive loads) output
PRODUCT SELECTION
Control Voltage
3.5-10 VDC
10-35 mA
DPA4119
DPA4111
DPA6119
DPA6111
DPA41xx
DPA61xx
20-140
400
0.01
500
1.0
0.025
30
1.2
0.5
20-280
600
0.01
500
1.0
0.025
30
1.2
0.5
DPAxx11
DPAxx19
10-35 mA
1.0 mA
1/2 Cycle
1/2 Cycle
3.5-10 VDC
1.0 VDC
15 mAdc
270 Ohm
1/2 Cycle
1/2 Cycle
AVAILABLE OPTIONS
OUTPUT SPECIFICATIONS (1)
Description
Operating Voltage (47-63Hz) [Vrms]
Transient Overvoltage [Vpk]
Maximum Off-State Leakage Current @ Rated Voltage [mArms]
Minimum Off-State dv/dt @ Maximum Rated Voltage [V/µsec] (3)
Maximum Load Current [Arms]
Minimum Load Current [Arms]
Maximum Surge Current (16.6ms) [Apk]
Maximum On-State Voltage Drop @ Rated Current [Vpk]
Minimum Power Factor (with Maximum Load)
INPUT SPECIFICATIONS (1)
Description
Control Voltage Range
Control Current Range
Must Turn Off-State Current
Must Turn Off-State Voltage
Typical Input Current @ 5 VDC
Nominal Input Impedance
Maximum Turn-On Time [msec]
Maximum Turn-Off Time [msec]
GENERAL SPECIFICATIONS
Description
Parameters
Dielectric Strength, Input/Output/Base (50/60Hz)(2)
Minimum Insulation Resistance (@ 500 VDC)(2)
3750 Vrms
109 Ohm
Maximum Capacitance, Input/Output
Ambient Operating Temperature Range
Ambient Storage Temperature Range
Weight (typical)
Encapsulation
2.0 pF
-30 to 80°C
-30 to 125°C
0.1 oz. (2.9g)
Thermally Conductive Epoxy
GENERAL NOTES
1) All parameters at 25°C unless otherwise specified.
2) Dielectric and insulation resistance are measured between input and output
3) Off-State dv/dt test method per EIA/NARM standard RS
MECHANICAL SPECIFICATIONS
PIN 8: AC LOAD
PIN 10: AC LOAD
PIN 16: +DC CONTROL
PIN 1: -DC CONTROL
THERMAL DERATE INFORMATION
AGENCY APPROVALS
UL E116950
CSA LR81689
120210
WIRING DIAGRAM
ANNEX - ENVIROMENTAL INFORMATION
Similar pages