SF301 - SF304 30A SUPER-FAST RECTIFIER Features · · · · · Plastic Package - UL Flamability Classification 94V-0 High Current Capability High Surge Capacity High Fast Switching Capability < 35 ns Low Switching Noise and High Reliability A B H J S K R · · · · · L P Mechanical Data C G N Case: TO-3P Molded Plastic Terminals: Solderable per MIL-STD-202, Method 208 Mounting Position: Any Polarity: As marked Approx. Weight: 5.6 gram D E M M Common Cathode (no Suffix) shown Add Suffix ‘A’ for Common Anode & change ‘+’ to ‘-’ in illustration above TO-3P Dim Min Max A 3.2 3.5 B 4.5 5.4 C 21.6 22.5 D 18.9 21.7 E 2.4 2.8 G 0.55 0.81 H 15.8 16.2 J 1.7 2.7 K 3.1Ø 3.3Ø 4.5 L 4.2 M 5.1 5.7 N 0.89 1.5 P 2.9 3.3 R 11.7 12.8 S 5.0 6.0 Maximum Ratings and Electrical Characteristics Rating at 25°C ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load, derate current 20%. Symbol SF301 SF302 SF303 SF304 Unit Maximum Recurrent Peak Reverse Voltage Characteristic VRRM 50 100 150 200 V Maximum RMS Voltage VRSM 35 70 105 140 V Maximum DC Blocking Voltage VDC 50 100 150 200 V Maximum Average Forward Rectified Current (Total Device) @ TC = 120°C I(AV) 30 A IFSM 300 A 0.975 0.880 V IR 10 500 mA Typical Junction Capacitance (Note 1) CJ 80 pF Maximum Reverse Recovery Time (Note 2) Trr 35 ns RqJC 1.0 °C/W TJ, TSTG -65 to +175 °C Peak forward Surge Current 8.3ms half sine-wave superimposed on rated load (JEDEC Method) Maximum Instantaneous Forward Voltage per leg at IF = 15A (Note 3) @ TJ = 25°C @ TJ = 150°C Maximum Instantaneous Reverse Current at @ TJ = 25°C Rated DC Blocking Voltage per leg (Note 3) @ TJ = 150°C Typical Thermal Resistance, Junction to Case Storage and Operating Temperature Range Notes: VF (1) Measured at 1MHz and applied reverse voltage of 4.0 volts. (2) Reverse recovery test conditions: IF = +0.5A, IR = 1.0A, di/dt = 50A/ms. (3) Pulse width = 300 mS, 2% duty cycle. DS24007 Rev. D-3 1 of 3 SF301-SF301 15 10 5 0 0 25 50 75 100 125 150 TEMPERATURE (°C) Fig. 1, TC, Forward Current Derating Curve IF, INSTANTANEOUS FWD RECTIFIED CURRENT (A) Per Leg IAV, AVERAGE FWD RECTIFIED CURRENT (A) 20 10 1.0 0.1 1.2 1.6 2.0 0 0.4 0.8 VF, INSTANTANEOUS FORWARD VOLTAGE (VOLTS) Fig. 2 Typical Forward Characteristics 400 IFSM, PEAK FWD SURGE CURRENT (A) CJ, JUNCTION CAPACITANCE (pF) 1000 100 100 10 1 10 100 VR, REVERSE VOLTAGE (VOLTS) 300 250 200 150 100 50 1 10 NUMBER OF CYCLES AT 60 Hz 100 Fig. 4 Peak Forward Surge Current Fig. 3 Typical Junction Capacitance DA24007 Rev. D-3 350 2 of 3 SF301-SF301 IR, INSTANTANEOUS REVERSE CURRENT (µA) 10 1.0 0.1 0.01 0 40 80 120 160 VR, REVERSE VOLTAGE (VOLTS) Fig. 5, Typical Reverse Characteristics 200 10W Non Inductive 50W Non Inductive trr +0.5A Device under test - + 25Vdc (approx) - 0 Pulse Generator (Note 2) 1W Non Inductive -0.25A Oscilloscope (Note 1) + -1.0A 1cm Notes: 1. Rise Time = 7ns max, nce = 1MW 22pF 2. Rise Time = 10ns max Source Impedence = 50W DS24007 Rev. D-3 3 of 3 SET TIME BASE FOR 5/10 ns/cm SF301-SF301