LDM-0980-050m-50 TECHNICAL DATA Infrared Laser Diode Features • CW Output Power: 50 mW • Typical 975 nm Emission Wavelength • High-efficiency Quantum Well Structure • TO18 or TO5 Package Applications • Solid-state Laser Pumping • Medical Usage • Infrared Night Vision Light Sources • Information to identify PIN CONNECTION 1. Laserdiode cathode 2. Laserdiode anode and photodiode cathode 3. Photodiode anode Specifications (25°C) Type Optical Specification CW Output Power PO Peak Wavelength Δ Spectral Width Δλ Emitting Area Wavelength Temperature Coefficient Beam Divergence θ┴×θ║ Polarization Electrical Specification Slope Efficiency ES Threshold Current Ith Operation Current IO Operation Voltage Vf Series Resistance Rd Package Style Absolute Maximum Ratings Reverse Voltage Vr Operating Temperature TO Storage Temperature Tstg 04.08.2010 LDM-0980-050m-50 Unit 50 975±15 ≤ 3.0 4x1 0.3 35x25 TE mW nm nm µm nm/°C Deg ≥ 0.6 ≤ 0.025 ≤ 0.12 ≤2 ≤5 TO18 (TO5) W/A A A V Ω 2.0 10 … 40 -40 … 85 V °C °C ldm_0980_050m_50.doc 1 of 3 Package Dimensons TO18 Package (Unit:mm) TO5 Package (Unit:mm) 04.08.2010 ldm_0980_050m_50.doc 2 of 3 Typical Performance Curves Notes 1. Caution! Don't look at the laser beam directly, because it's harmful to eyes. 2. The storage temperature is between –40 and 85 °C. 3. Under normal circumstances, the higher the temperature is, the shorter the life of semiconductor laser will be. It is recommended to use lasers under TEC cooling or in air-conditioned room. 4. To use a laser diode in following sequences: Turn on the power supply; connect to the laser diode; and then increase the current gradually to the specified operating value. To shut down the laser diode, please decrease the current to zero gradually, and then turn off the power. Please make sure that the power supply has no current overshoot at any time. The current overshoot can damage the laser diodes permanently. 5. The high power laser diode arrays are very sensitive to electrostatic. Please wear antistatic bracelet during operating with the laser diodes (arrays). 6. Be sure that the operating current does not exceed the specified operating current. Otherwise, it will accelerate laser aging, shorten lifetime or even damage devices permanently. 7. A clean, dry and ventilated environment should be available when storing and operating laser diodes (arrays). Dust may degrade the laser diodes (arrays). 8. Constant-current power supply with voltage regulator should be used to avoid surge. 04.08.2010 ldm_0980_050m_50.doc 3 of 3