A PLUS MAKE YOUR PRODUCTION A-PLUS ASM3106C DATA SHEET APLUS INTEGRATED CIRCUITS INC. Address: 3 F-10, No. 32, Sec. 1, Chenggung Rd., Taipei, Taiwan 115, R.O.C. (115)台北市南港區成功路㆒段 32 號 3 樓之 10. Sales E-mail: Mr. Jason [email protected] TEL: 886-2-2782-9266 Technology E-mail: Mr. George [email protected] FAX: 886-2-2782-9255 WEBSITE : http: //www.aplusinc.com.tw ASM3106C ASM3106C – VERY LOW-COST VOICE SYNTHESIZER WITH 4-BIT MICROPROCESSOR 1.0 General Description The ASM3106C is very low cost voice synthesizer with 4-bit microprocessor. It has various features including 4-bit ALU, ROM, RAM, I/O ports, timers, clock generator, watchdog timer(WDT), voice synthesizer, etc. It consists of 22 instructions in the device. With CMOS technology and halt function can minimize power dissipation. Its architecture is similar to RISC, with two stages of instruction pipeline. It allows all instructions to be executed in a single cycle, except for program branches and data table read instructions (which need two instruction cycles). 1.1 Feature Single power supply can operate from 2.4V through 5V Internal Program ROM: 4K x 10-bit 1 sets of 17-bit DPR can access up to 96K x 10 bits data memory space Data Registers: • 64 x 4-bit data RAM (00-1Fh plus 40h-5Fh) • Unbanked special function registers (SFR) range: 20h-3Fh I/O Ports: • PRA: 4-bit I/O Port A (2Bh) • PRB: 2-bit Output Port B (2Dh) On-chip clock generator: Resistive Clock Drive(RM) Timer: 1 • Timer0: a 9-bit auto-reload timer/counter Stack: 2-level subroutine nesting HALT and Release from HALT function to reduce power consumption Watch Dog Timer (WDT) Instruction: 1-cycle instruction except for table read and program branches which are 2-cycles Number of instruction: 22 The Voice function can be implemented by microprocessor instruction • One 8-bit COUT output for ASMXXXXX 1 ASM3106C FIGURE 1.1 : Block Diagram of ASM3106C Data Bus[3:0] ROM Latch PCLATCH(8) PCL(4) Stack(12) PC[11:0] (ADDR[16:12]) =00000b (2-Level) ADDR[16:0] Instruction Bus [9:0] 1 DPR3,2,1 Instruction Latch 0 ROM_ADDR[16:0] Program (Data) ROM DPR[16:0] Instruction Decoder Control Signal DLATCH(10) ROM_Data[9:0] Data Bus[3:0] Instruction Bus [9:0] Accumlator(4) SRAM ALU(4) Immediate(4) PRA(4) PRB(2) Timer0(9) (64 x 4) Instruction Bus [9:0] PCH(8) 00h-1Fh 40h-5Fh Register(4) enter test mode One-Channel ( Voice synthesizer ) Reset Chip Reset Chip Clock Generator Power on Reset RESET pin COUT OSC Test select COUT 2 VDD/GND PRA0 P1,P2,P3,P4 weak or strong pull-low for PRA, PRB, PRC PRASL(4) ASM3106C FIGURE 1.2 : External ROM Map of ASM3106C PC[11:0] 12bit x 2 STACK 17-bit Data Pointer Reset Vector 00000h 00080h Reserved for Testing 00080h-003FFh 00400h Program and data ROM 00000h-00FFFh 00FFFh(4K) Data ROM 00000h-17FFFh 17FFFh(96Kx10-bits) 3 ASM3106C 1.2 Pin-Out ASM3106C Pin-Out VDD PRA3-1 I I/O PRA0/RESET I/O OSC COUT GND TEST PRB0-1 I O I O O Power supply during operation STI I/O port with programmable strong pull-low or weak pull-low or Std./O.D. fix-input-floating capability Output type with standard or Open-Drain output STI I/O port with programmable strong pull-low or weak pull-low or Std./O.D. fix-input-floating capability Output type with standard or Open-Drain output Mask option selected as an external RESET pin with weak pull-low capability RM mode Oscillator input Current Output of Audio Circuit Ground Potential Enter Test Mode. ( TEST = High ) Std./O.D. Output type with standard or Open-Drain output 1.3 Application circuit 4 ASM3106C 1.4 Bonding Diagram 96K x 10 bit ROM Y= 2170+80(um) ASM3106C 1 11 CHIP SIZE: X= 1550+80(um) , Y= 2170+80(um) 10 2 3 4 5 6 7 8 9 X= 1550+80(um) Substrate must be connected to GND. ASM3106C Pad Location PAD # PAD Name 1 RA3 2 RA2 3 RA1 4 RA0 5 OSC 6 GND X -664.92 -664.92 -662.64 -468.24 -281.04 -111.72 Chip Size: X= 1550 + 80 (um), Y=2170 + 80 (um) Y PAD # PAD Name X Y -676.8 7 TEST 105.44 -1001.48 -804.92 8 COUT 303.96 -1001.48 -1001.48 9 VDD 683.04 -1001.48 -1001.48 10 RB0 664.92 -805.28 -1001.48 11 RB1 664.92 -682.08 -1001.48 5 ASM3106C 1.5 DC Characteristics for ASMxxxxx SYMBOL VDD Isb Iop PARAMETER OPERATING VOLTAGE SUPPLY CURRENT VDD STANDBY OPERATING INPUT CURRENT /Internal pull low Iih Ioh OUTPUT HIGH CURRENT Iol OUTPUT LOW CURRENT DA CURRENT OUT (FULL SCALE) FREQUENCY STABILITY Cout dF/F dF/F MIN. 2.4 TYP. 3 3 5 3 5 3 5 2 7 3 9 5 -5.2 3 5 3 5 3 5 -3 -8 7 20 4 5.2 Fosc VARIATION MAX. 5.0 1 1 UNIT V CONDITION depending on Freq. 4MHz, RM in HALT Mode 4MHz, RM IO Floating 4MHz, RM in HALT Mode (IO Ports with weak pull-high pull-low) uA mA uA mA -10 10 % -20 20 % 4MHz, RM (IO ports) Fosc(3v- 2.4v) Fosc (3v) VDD=3V, Rosc=820k, 4MHz FIGURE 1.3 : Frequency Range for Rosc in RM mode Resistor(k ohm) 3v Freq.(MHz) 1000 2.61 820 4.09 620 5.46 390 7.93 R o sc & Fre q . Freq. MHz 10 8 7 .9 3 6 5 .4 6 4 .0 9 4 2 .6 1 2 0 0 200 400 600 R o sc k o h m 6 800 1000 1200