GS1A M1 THRU GS1M M7 DC COMPONENTS CO., LTD. R RECTIFIER SPECIALISTS TECHNICAL SPECIFICATIONS OF SURFACE MOUNT SILICON RECTIFIER VOLTAGE RANGE 50 to 1000 Volts CURRENT 1.0 Ampere FEATURES * ldeal for surface mounted applications * Low leakage current * Glass passivated junction SMA ( DO-214AC ) MECHANICAL DATA * Case: Molded plastic * Epoxy: UL 94V-0 rate flame retardant *Terminals: Solder plated, solderable per MIL-STD-750, Method 2026 * Polarity: As marked * Mounting position: Any * Weight: 0.064 gram MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 o C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%. Dimensions in inches and (millimeters) Maximum Recurrent Peak Reverse Voltage VRRM GS1A M1 50 Maximum RMS Voltage VRMS 35 70 140 280 420 560 700 Volts VDC 50 100 200 400 600 800 1000 Volts SYMBOL Maximum DC Blocking Voltage Maximum Average Forward Rectified Current at T A = 75o C Peak Forward Surge Current I FM(surge): 8.3 ms single half sine-wave superimposed on rated load (JEDEC method) Maximum Forward Voltage at 1.0A DC Maximum DC Reverse Current at Rated DC Blocking Voltage Maximum Reverse Recovery Time (Note 3) Typical Thermal Resistance (Note 2) Typical Junction Capacitance (Note 1) Operating and Storage Temperature Range @T A = 25 o C @T A = 125 o C GS1B M2 100 GS1D M3 200 GS1G M4 400 GS1J M5 600 GS1K M6 800 GS1M UNITS M7 Volts 1000 IO 1.0 Amps I FSM 30 Amps VF 1.1 5.0 50 2.5 uAmps IR trr RθJL CJ T J , T STG Volts uSec 0 30 15 -65 to + 175 C/ W pF 0 C NOTES : 1. Measured at 1.0 MHz and applied reverse voltage of 4.0VDC 2. Thermal Resistance (Junction to Ambient), .24in2 (6.0mm 2 ) copper pads to each terminal. 3. Test Conditions: IF=0.5A, IR=1.0A, IRR=0.25A. 340 NEXT BACK NEXT EXIT BACK RATING AND CHARACTERISTIC CURVES ( GS1A GS1M THRU M1 M7 ) DC COMPONENTS CO., LTD. R 341 EXIT EXI BACK NEXT BACK EXIT NEXT BACK NEXT