DC/DC Converters CTDD3120DF-D1K-3M Series Wide Input Isolated & Regulated 3W Output, Dual Output Not shown at actual size. RoHS Compliant ctparts.com SPECIFICATIONS Part Number Vin Nom. (VDC) Input Range (VDC) Vin Max.* (VDC) Vout (VDC) CTDD3120DF-1205-D1K-3M CTDD3120DF-1209-D1K-3M CTDD3120DF-1212-D1K-3M CTDD3120DF-1215-D1K-3M 12 12 12 12 9-18 9-18 9-18 9-18 22 22 22 22 ±5 ±9 ±12 ±15 CTDD3120DF-1505-D1K-3M CTDD3120DF-1509-D1K-3M CTDD3120DF-1512-D1K-3M CTDD3120DF-1515-D1K-3M 15 15 15 15 12-24 12-24 12-24 12-24 30 30 30 30 CTDD3120DF-2405-D1K-3M CTDD3120DF-2409-D1K-3M CTDD3120DF-2412-D1K-3M CTDD3120DF-2415-D1K-3M 24 24 24 24 18-36 18-36 18-36 18-36 CTDD3120DF-4805-D1K-3M CTDD3120DF-4809-D1K-3M CTDD3120DF-4812-D1K-3M CTDD3120DF-4815-D1K-3M 48 48 48 48 36-72 36-72 36-72 36-72 Iout Max. (mA) Iout Min. (mA) Effi. Typ. (%) 300 165 125 100 30 16 12 10 72 73 77 79 ±5 ±9 ±12 ±15 300 165 125 100 30 16 12 10 75 79 80 81 40 40 40 40 ±5 ±9 ±12 ±15 300 165 125 100 30 16 12 10 78 80 81 82 80 80 80 80 ±5 ±9 ±12 ±15 300 165 125 100 30 16 12 10 76 81 81 82 *If Input voltage above specified may cause permanent damage to the device ISOLATION SPECIFICATIONS Item Test Condition MIN Isolation Voltage Flash tested for 1 minute 1000 VDC Test at 500VDC 1000 MΩ Isolation Resistance TYP MAX Units FEATURES CHARACTERISTICS Output Short Circuit Protection: Continuous Temperature Rise at Full Load: 30°C (Typ.) Cooling: Free air convection No Load, Power Consumption: 100mW (typical) Operating Temperature Range: -40°C to +85°C Storage Temperature Range: -55°C to +125°C Lead Temperature: 300°C (1.5mm from case for 10 seconds) Storage Humidity Range: < 95% Case Material: Metal MTBF: >3,500,000 hours Miscellaneous: RoHS Compliant. OUTPUT SPECIFICATIONS Item Test Condition 3W Output Power MAX Units 3 W Refer to Recommended Circuit ±1 ±3 % Negative voltage accuracy Refer to Recommended Circuit ±3 ±5 % Load regulation From 10% to 100% load ±0.5 ±1 % Line regulation Input Voltage from low to high ±0.2 ±0.5 % Temperature drift (Vout) Refer to Temp. Derating Graph Ripple 20Hz to 300KHz Bandwidth Noise DC-20MHz Bandwidth Switching frequency 100% load, nominal input voltage 80 Switching frequency 10% load, nominal input voltage 250 0.03 %/°C 30 60 mVp-p 80 150 mVp-p 200 KHz 600 KHz Note: 1. All specifications measured at TA=25°C, humidity<75%, nominal input voltage and rated output unless otherwise specified. TYPICAL CHARACTERISTICS Temperature Derating Graph 120 100 80 60 Safe Operating Area 40 20 0 120 40 71 85 Ambient Temperature (°C) 12.21.06 Technologies TYP 0.3 0 -40 CENTRAL MIN Positive voltage accuracy Output Power (%) Efficiency: To 82% Temperature Range: -40°C to +85°C Isolation: 1KVDC Miscellaneous: Wide (2:1) Input Range. Dual Output. Metal Shielding Package. No heat sink required. Pinout compatible with ERICSSON PKV. Samples available. Manufacturer of Passive and Discrete Semiconductor Components 800-684-5322 Inside US 949-453-1811 Outside US Copyright © 2006 by CT Magnetics, DBA Central Technologies. All rights reserved. CT Magnetics reserves the right to make improvements or change specifications without notice DC/DC Converters ctparts.com CTDD3120DF-D1K-3M Series Wide Input Isolated & Regulated 3W Output, Dual Output OUTLINE DIMENSIONS & RECOMMENDED FOOTPRINT DETAILS CTDD3120DF-D1K-3M Package 2 Bottom View Side View 31.80 9.45 3 0.50 9 10 11 15.24 20.30 23 22 16 15 14 2.54 5.08 4.00 22.86 Note: All pins on a 2.54mm pitch; all pin diameters are 0.50mm; all dimensions in mm. (Tolerance:±0.25) PIN CONNECTIONS Pin Function 2, 3 10, 15 14 11 9, 16 22, 23 GND NC +Vo -Vo 0V Vin Bottom View 2 3 9 10 11 23 22 16 15 14 RECOMMENDED CIRCUIT All the CTDD3120DF-D1K-3M Series have been tested according to the following recommended testing circuit before leaving factory. This series should be tested under load. Never be tested under no load (See figure 1 & 2). If you want to further decrease the input/output ripple, you can increase capacitance properly or choose capacitors with low ESR. However, the capacitance should not be too high (See table 1). If you want to use the products in high EMI, please choose our metal packaged products. External Capacitor Table (table 1) Figure 2 5V & 12V 24V & 48V C in C out (0+70°C) C out (-40+85°C) lp Figure 1 100µF 100µF (electrolytic capacitor) 47µF (tantalum capacitor) Vin +Cin 10µF DC DC Cout + Cout + Vo 0V Input Current (A) Vin Vo GND Input Voltage (V) Technologies 12.21.06 CENTRAL Input Voltage Range Manufacturer of Passive and Discrete Semiconductor Components 800-684-5322 Inside US 949-453-1811 Outside US Copyright © 2006 by CT Magnetics, DBA Central Technologies. All rights reserved. CT Magnetics reserves the right to make improvements or change specifications without notice