Internationally Approved Rockers Series JWS Distinctive Characteristics Rocker caps and housing available in a variety of colors. Protective barrier available to prevent accidental actuation. Constructed for dust resistance with interior cover of polyamide between actuator and contact area. Easy, crisp actuation. Small size well suited for telecommunication, measuring, automation, and consumer applications. Terminals are molded in to lock out flux, dust, and other contaminants. Outer case of heat resistant resin meets UL94V-0 flammability standard. Spot illuminated rocker available. Actual Size NKK Switches • email: [email protected] • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com 02-08 Internationally Approved Rockers Series JWS General Specifications Electrical Capacity (Resistive Load) Power Level: Other Ratings Contact Resistance: Insulation Resistance: Dielectric Strength: Mechanical Life: Electrical Life: Nominal Operating Force: Angle of Throw: Materials & Finishes Rocker: Housing/Case: Movable Contactor: Movable Contacts: Stationary Contacts: End Terminals: Common Terminals: Lamp Terminals: Environmental Data Operating Temp Range: Humidity: Vibration: Shock: Sealing: Installation Soldering: Cleaning: Standards & Certifications Flammability Standards: UL Recognized: C–UL Recognized: CSA Certified: VDE Approved: V D E R 10A @ 125/250V AC 10 milliohms maximum 500 megohms minimum @ 500V DC 2,000V AC minimum between contacts for 1 minute minimum; 4,000V AC minimum between contacts & case for 1 minute minimum 30,000 operations minimum 10,000 operations minimum Single Pole 3.92N & Double Pole 5.39N 30° Polyphenylene ether (UL94V-0) Polyamide (UL94V-0) Copper with silver plating Silver Silver Brass with silver plating Copper with silver plating Phosphor bronze with tin plating (illuminated models only) –25°C through +70°C (–13°F through +158°F) for nonilluminated models; –25°C through +50°C (–13°F through +122°F) for illuminated models 90 ~ 95% humidity for 96 hours @ 40°C (104°F) 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 15 minutes; 3 right angled directions for 2 hours 50G (490m/s2) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) Dust resistant inner seal Manual Soldering: See Profile A in Supplement section. These devices are not process sealed. Hand cleaning locally using alcohol based solution. UL94V-0 for rocker & housing/case All JWS models recognized at 6A @ 125/250V AC; UL File No. WOYR2.E44145 All JWS models recognized at 6A @ 125/250V AC; UL File No. WOYR8.E44145 All JWS models certified at 6A @ 125/250V AC; CSA File No. 023535-0-000 All JWS models approved at 5A (3A) @ 125/250V AC; VDE License No. 119153 NKK Switches • email: [email protected] • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com 02-08 Series JWS Internationally Approved Rockers TYPICAL SWITCH ORDERING EXAMPLE JW S 2 1 R RATING S A A BARRIER TYPES 10A @ 125/250V AC R No Barrier B With Barrier SPOT ILLUMINATION No Code Nonilluminated C Red LED D Amber LED F Green LED CAP COLORS POLES 1 SPST Nonilluminated & Illuminated A Black BARRIER COLOR *B Ivory A 2 DPST Nonilluminated only * For Nonilluminated only ON NONE Red HOUSING COLORS CIRCUIT 1 C OFF Black A Black *B Ivory * For Nonilluminated only IMPORTANT: Standard markings: UL, C–UL, & CSA on 6A models; VDE on 5A models. Specific models & ratings for international approvals noted on General Specifications page. DESCRIPTION FOR TYPICAL ORDERING EXAMPLE JWS21RAA Black Rocker Cap Black Housing/No Barrier DPST ON-NONE-OFF Circuit Rated 6A @ 125/250V AC NKK Switches • email: [email protected] • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com 02-08 Series JWS Internationally Approved Rockers RATING S Power Level 6A @ 125/250V AC POLES & CIRCUITS Rocker Position Connected Terminals Throw & Schematics Down Center Up Down Center Up Note: Terminal numbers are actually on the switch. Pole Model SP JWS11 ON NONE OFF 2-3 OPEN OPEN SPST DP JWS21 ON NONE OFF 1-3 4-6 OPEN OPEN DPST 2 1 3 3 INTERNAL CONNECTION 4 INTERNAL CONNECTION 6 BARRIER TYPES & COLORS R B No Barrier With Barrier Barrier Material: Polyamide Finish: Matte No-barrier type has a flat flange which is an integral part of the switch. Barrier AT219 is factory assembled. Dimensions for barrier are shown in the Accessories section. Barrier Color Available: A Black CAP COLORS Cap Material: Polyphenelene Oxide Rocker cap is an integral part of the switch and not available separately. * Ivory for nonilluminated models only. Cap Colors Available: Finish: Matte A Black B * Ivory C Red HOUSING Material: Polyamide Finish: Matte Colors Available: A Black B Ivory (for nonilluminated models only) TERMINALS (1.2) R .047 (0.65) R .026 (4.75) .187 (6.4) (4.4) .252 .173 (3.25) .128 Thk = (0.5) .020 Switch Solder Lug/.187” (4.75mm) Quick Connect Switch assembly with connectors is not UL, CSA, C-UL, or VDE approved. (5.0) .197 (3.0) (1.8) .118 .071 (1.0) .039 Thk = (0.25) .010 Lamp (spot illuminated models only) NKK Switches • email: [email protected] • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com 02-08 Internationally Approved Rockers Series JWS LED COLORS & SPECIFICATIONS FOR SPOT ILLUMINATED MODELS LEDs are supplied as an integral part of illuminated devices and are not available separately. LED polarity markings are on the bottom of the switch. (+) C D F Red Amber Green (-) Color Forward Peak Current I FM 25mA 20mA 20mA The electrical specifications shown here are determined at a basic temperature of 25°C. Continuous Forward Current IF 20mA 15mA 15mA Forward Voltage VF 2.0V 1.9V 1.95V If the source voltage exceeds the rated voltage, a ballast resistor is required. The resistor value can be calculated by using the formula in the Supplement section. Reverse Peak Voltage VRM 4V 5V 5V Current Reduction Rate Above 25°C ∆I F 0.42mA/°C 0.27mA/°C 0.27mA/°C Ambient Temperature Range –25°C ~ +50°C PANEL CUTOUT & PANEL THICKNESS RANGES Panel Thickness Ranges: Without Barrier: .030” ~ .079” (0.75mm ~ 2.0mm) (19.2) .756 With Barrier: .024” ~ .059” (0.6mm ~ 1.5mm) (12.9) .508 TYPICAL SWITCH DIMENSIONS Nonilluminated • No Barrier Single Pole (5.3) .209 Part No. (15.0) .591 3 (6.5) .256 30ϒ (2.0) .079 (16.0) .630 (21.0) .827 2 (19.0) .748 (12.3) .484 (10.2) .402 (15.0) .591 (4.75) .187 (0.5) Typ .020 (12.4) .488 (12.8) .504 (6.4) .252 JWS11RCA Nonilluminated • No Barrier Double Pole (15.0) .591 (5.5) .217 30ϒ (2.0) .079 (8.5) .335 (19.0) .748 (4.5) (4.75) Typ .177 .187 (12.3) .484 (10.2) .402 (15.0) .591 JWS21RAA (1.2)R Typ .047 (0.65)R Typ .026 (5.3) .209 Part No. (16.0) .630 (5.6) .220 (6.4) .252 6 4 (0.5) Typ .020 3 (21.0) .827 1 (12.4) .488 (12.8) .504 DPST models have IEC symbols for On-Off on the flange. NKK Switches • email: [email protected] • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com 02-08 Internationally Approved Rockers Series JWS TYPICAL SWITCH DIMENSIONS Nonilluminated • With Barrier Single Pole Part No. (10.2) .402 (15.0) .591 (16.5) .650 (7.0) .276 Nonilluminated • With Barrier 3 (6.5) .256 (19.0) .748 (19.5) .768 (15.0) .591 JWS11BBA-A (4.75) .187 (0.5) Typ .020 (13.5) .531 (24.0) .945 2 (21.0) .827 (12.4) .488 (12.8) .504 (20.5) .807 (6.4) .252 Double Pole (1.2)R Typ .047 (0.65)R Typ .026 Part No. (15.0) .591 (5.5) .217 (19.5) .768 (10.2) .402 (15.0) .591 (16.5) .650 (8.5) .335 6 (19.0) .748 (4.5) (4.75) Typ .177 .187 (7.0) .276 (13.5) .531 4 (0.5) Typ .020 3 (24.0) .945 (21.0) .827 1 (12.4) .488 (12.8) .504 (20.5) .807 (5.6) .220 (6.4) .252 DPST models have IEC symbols for On-Off on the flange. JWS21BAA-A Spot Illuminated • No Barrier Single Pole (15.0) .591 (2.1) .083 (6.4) .252 (5.3) .209 Part No. (2.0) .079 (16.0) .630 (5.0) .197 (9.2) .362 (0.25) 0.01 (4.75) .187 3 (6.5) Typ .256 (19.0) .748 (1.5) .059 30ϒ (12.3) .484 (6.0) .236 (10.2) .402 (15.0) .591 (12.4) .488 (0.5) Typ .020 (21.0) .827 2 (1.8) Typ .071 (12.0) .472 (12.8) .504 (4.0) .157 JWS11RCAF Spot Illuminated • With Barrier Single Pole (6.4) .252 (10.2) .402 Part No. (2.1) .083 (6.0) .236 (15.0) .591 (16.5) .650 (7.0) .276 (13.5) .531 (5.0) .197 (9.2) .362 (0.25) 0.01 (4.75) .187 3 (6.5) Typ .256 (19.0) .748 (1.5) .059 (19.5) .768 (15.0) .591 (12.4) .488 (0.5) Typ .020 2 (1.8) Typ .071 (12.8) .504 (20.5) .807 (24.0) .945 (21.0) .827 (4.0) .157 JWS11BAAF-A NKK Switches • email: [email protected] • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com 02-08