DIGITRON SEMICONDUCTORS BRY55 SERIES SILICON CONTROLLED RECTIFIER Available Non-RoHS (standard) or RoHS compliant (add PBF suffix). Available as “HR” (high reliability) screened per MIL-PRF-19500, JANTX level. Add “HR” suffix to base part number. MAXIMUM RATINGS Rating Symbol Peak repetitive forward and reverse blocking voltage (RGK = 1000Ω, TJ = 25-125°C) BRY55-30 BRY55-60 BRY55-100 BRY55-200 BRY55-400 BRY55-500 BRY55-600 Value Unit (1) Forward current RMS (all conduction angles) 30 60 100 200 400 500 600 VRRM, VDRM IT(RMS) Peak forward surge current, TA = 25°C (1/2 cycle, sine wave, 60Hz) ITSM Circuit fusing considerations, TA = 25°C (t = 8.3ms) I2t Forward peak gate power, TA = 25°C PGM Forward peak gate current , TA = 25°C (300µs, 120 PPS) Operating junction temperature range @ rated VRRM and VDRM Storage temperature range Volts 0.8 Amps Amps 8 A2s 0.15 0.1 Watts IGFM 1 Amps TJ -40 to +125 °C Tstg -40 to +150 °C +230 °C Lead solder temperature (<1.5mm from case, 10s max) Note 1: VDRM and VRRM for all types can be applied on a continuous basis. Ratings apply for zero or negative gate voltage; however, positive gate voltage shall not be applied concurrent with negative potential on the anode. Blocking voltages shall not be tested with a constant current source such that the voltage ratings of the devices are exceeded. THERMAL CHARACTERISTICS Symbol Maximum Unit Thermal resistance, junction to case Characteristic RӨJC 75 °C/W Thermal resistance, junction to ambient RӨJA 200 °C/W ELECTRICAL CHARACTERISTICS (TC 25°C, RGK = 1000Ω unless otherwise noted) Characteristic Symbol Peak forward blocking current (VD = rated VDRM @ TC = 125°C) IDRM Peak reverse blocking current (VR = rated VRRM @ TC = 125°C) IRRM Forward “on” voltage(2) ITM = 1A peak @ TA = 25°C) VTM Gate trigger current (continuous dc)(3) (Anode voltage = 7Vdc, RL = 100 Ω) IGT Gate trigger voltage (continuous dc) (Anode voltage = 7Vdc, RL = 100 Ω) (Anode voltage = rated VDRM, RL = 100 Ω) TC = 25°C TC = -40°C TC = 125°C VGT Holding current (Anode voltage = 7Vdc, initiating current = 20mA) TC = 25°C TC = -40°C IH Min. Max. - 100 - 100 - 1.7 - 200 0.1 0.8 1.2 - - 5 10 µA µA Volts µA Volts mA Note 2: Forward current applied for 1ms maximum duration, duty cycle ≤ 1%. Note 3: RGK current is not included in measurement. 144 Market Street Kenilworth NJ 07033 USA phone +1.908.245-7200 fax +1.908.245-0555 Unit [email protected] www.digitroncorp.com Rev. 20130117 DIGITRON SEMICONDUCTORS BRY55 SERIES SILICON CONTROLLED RECTIFIER MECHANICAL CHARACTERISTICS Case TO-92 Marking Body painted, alpha-numeric Pin out See below TO-92 A B C D F G H J K L N P R V 144 Market Street Kenilworth NJ 07033 USA phone +1.908.245-7200 fax +1.908.245-0555 Inches Min Max 0.175 0.205 0.170 0.210 0.125 0.165 0.016 0.022 0.016 0.019 0.045 0.055 0.095 0.105 0.015 0.020 0.500 0.250 0.080 0.105 0.100 0.115 0.135 - Millimeters Min Max 4.450 5.200 4.320 5.330 3.180 4.190 0.410 0.550 0.410 0.480 1.150 1.390 2.420 2.660 0.390 0.500 12.700 6.350 2.040 2.660 2.540 2.930 3.430 - [email protected] www.digitroncorp.com Rev. 20130117