DIGITRON SEMICONDUCTORS MAC6068C-MAC6075C SILICON BIDIRECTIONAL THYRISTORS Available Non-RoHS (standard) or RoHS compliant (add PBF suffix). Available as “HR” (high reliability) screened per MIL-PRF-19500, JANTX level. Add “HR” suffix to base part number. MAXIMUM RATINGS Rating Symbol Peak repetitive off-state voltage (TJ = 110°C) MAC6068C MAC6069C MAC6070C MAC6071C MAC6073C MAC6074C MAC6075C VDRM RMS on-state current (TC = 85°C) IT(RMS) Value Unit (1) 25 50 100 200 400 500 600 Volts 4.0 Amps Peak non-repetitive surge current (1 cycle, 60 Hz, TJ = -40 to +110°C) ITSM Circuit fusing considerations (TJ = -40 to +110°C, t = 1.0 to 8.3ms) I2t 3.6 A2s Peak gate power PGM 10 Watts PG(AV) 0.5 Watts TJ -40 to +110 °C Tstg -40 to +150 °C 8.0 In. lb. Average gate power Operating junction temperature range Storage temperature range Mounting torque (6-32 screw) Amps 30 (2) Note 1: Ratings apply for open gate conditions. Thyristor devices shall not be tested with a constant current source for blocking capability such that the voltage applied exceeds the rated blocking voltage. Note 2: Torque rating applies with use of torque washer. Mounting torque in excess of 6 in. lb. does not appreciably lower case to sink thermal resistance. Main terminal 2 and heatsink contact pad are common. * Soldering temperatures shall not exceed 200°C for 10 seconds. THERMAL CHARACTERISTICS Characteristic Symbol Maximum Unit Thermal resistance, junction to case RӨJC 3.5 °C/W Thermal resistance, junction to ambient RӨJA 60 °C/W ELECTRICAL CHARACTERISTICS (TC = 25°C and either polarity of MT2 to MT1 voltage, unless otherwise noted) Characteristic Symbol Peak blocking current (either direction) (Rated VDRM @ TJ = 125°C, gate open) IDRM Peak on-state voltage (either direction) (ITM = 6.0A peak) VTM Gate trigger voltage (VD = 12V, RL = 100Ω, TJ = -40°C) MT2(+),G(+); MT2(-),G(-), all types MT2(+),G(-); MT2(-),G(+), all types (VD = Rated VDRM, RL = 10kΩ, TJ = 110°C) MT2(+),G(+); MT2(-),G(-), all types MT2(+),G(-); MT2(-),G(+), all types VGT Holding current (either direction) (VD = 12V, gate open, TJ = -40°C, initiating current = 1A) MAC6068C-MAC6075C TJ = 25°C MAC6068C-MAC6075C 144 Market Street Kenilworth NJ 07033 USA phone +1.908.245-7200 fax +1.908.245-0555 IH Min Typ. Max - - 2.0 - - 2.0 - 1.4 1.4 2.5 2.5 0.2 0.2 - - - - 30 - - 15 [email protected] www.digitroncorp.com Rev. 20130213 Unit mA Volts Volts mA DIGITRON SEMICONDUCTORS MAC6068C-MAC6075C SILICON BIDIRECTIONAL THYRISTORS Characteristic Symbol Turn on time (either direction) (ITM = 14A peak, IGT = 100mA) ton Blocking voltage application rate at commutation @ VDRM (TJ = 85°C, gate open) dv/dt Min Typ. Max - 1.5 - - 5.0 - Unit µs V/µs Quadrant Characteristic Peak gate trigger current (Main terminal voltage = 12V, RL = 100Ω, TJ = 25°C) (Main terminal voltage = 12V, RL = 100Ω, TJ = -40°C) Symbol I mA II mA III mA IV mA IGTM 10 20 10 20 10 20 20 40 MECHANICAL CHARACTERISTIC Case TO-126 Marking Body painted, alpha-numeric Pin out See below TO-126 A B C D F G H J K M Q R S U V 144 Market Street Kenilworth NJ 07033 USA phone +1.908.245-7200 fax +1.908.245-0555 Inches Min Max 0.425 0.435 0.295 0.305 0.095 0.105 0.020 0.026 0.115 0.125 0.091 0.097 0.050 0.095 0.015 0.025 0.595 0.655 3° TYP 0.148 0.158 0.045 0.055 0.025 0.035 0.145 0.155 0.040 - Millimeters Min Max 10.80 11.050 7.490 7.750 2.410 2.670 0.510 0.660 2.920 3.180 2.310 2.460 1.270 2.410 0.380 0.640 15.110 16.640 3° TYP 3.760 4.010 1.140 1.400 0.640 0.890 3.680 3.940 1.020 - [email protected] www.digitroncorp.com Rev. 20130213 DIGITRON SEMICONDUCTORS MAC6068C-MAC6075C 144 Market Street Kenilworth NJ 07033 USA SILICON BIDIRECTIONAL THYRISTORS phone +1.908.245-7200 fax +1.908.245-0555 [email protected] www.digitroncorp.com Rev. 20130213 DIGITRON SEMICONDUCTORS MAC6068C-MAC6075C 144 Market Street Kenilworth NJ 07033 USA SILICON BIDIRECTIONAL THYRISTORS phone +1.908.245-7200 fax +1.908.245-0555 [email protected] www.digitroncorp.com Rev. 20130213