The ACTF5031-746MHz-QCC8B is a low-loss, compact, and economical surface-acoustic-wave (SAW) RF filter in a surface-mount ceramic QCC8B case designed for GPS applications. 1. Package Dimensions (QCC8B) 2. Marking Pin Configuration 2 Input 6 Output 1, 3, 5, 7 to be grounded 4, 8 Case Ground Sign Data (unit: mm) Sign Data (unit: mm) A 1.00 D 1.50 B 1.27 E 3.80 C 0.60 F 3.80 3. Test Circuit Laser Marking 4. Typical Frequency Response 5. Performance 5-1. Maximum Ratings Rating Value Unit P 10 dBm DC Voltage VDC 10 V Operable Temperature Range TA -40 to +85 ℃ Storage Temperature Range Tstg -40 to +85 ℃ Input Power Level 5-2. Electronic Characteristics Characteristic Center Frequency Min. fC Insertion Loss IL 734 …. 758 MHz Amplitude Ripple (p-p) 734 …. 758 MHz Max. 746 Unit MHz -- 2.2 3.0 dB -- 0.6 1.0 dB 40 50 50 55 57 58 60 71 ----- dB dB dB dB 25 50 ns 1.5 2.0 dB α Absolute Attenuation fc±80 MHz ...... fc±149 MHz fc+149 MHz ...... fc+300 MHz 1 MHz ...... 200 MHz 200 MHz ...... fc-149MHz Group Delay Ripple (p-p) 734 …. 758 MHz VSWR Typ. Δτ 734 …. 758 MHz IIP3 35 dBm Input / Output Impedance 50 Ω Temperature coefficient of frequency -40 ppm/K CAUTION: Electrostatic Sensitive Device. Observe precautions for handling! C ACT All Rights Reserved. ○ E 1. 2. 3. 4. 5. 6. A The frequency fC is defined as the midpoint between the 3dB frequencies. Unless noted otherwise, all measurements are made with the filter installed in the specified test fixture that is connected to a 50Ω test system with VSWR≤1.2:1. The test fixture L and C are adjusted for minimum insertion loss at the filter center frequency, fC. Note that insertion loss, bandwidth, and passband shape are dependent on the impedance matching component values and quality. Unless noted otherwise, specifications apply over the entire specified operating temperature range. The specifications of this device are based on the test circuit shown above and subject to change or obsolescence without notice. All equipment designs utilizing this product must be approved by the appropriate government agency prior to manufacture or sale. Our liability is only assumed for the Surface Acoustic Wave (SAW) component(s) per se, not for applications, processes and circuits implemented within components or assemblies.