Inductors (Coils) > Chip Inductor (Chip Coil) > Power Inductor (Multilayer Type) Data Sheet 1 Chip Inductor (Chip Coil) Power Inductor (Multilayer Type) LQM2HP_J0 Series (1008 Size) c Dimensions c Packaging 1.1±0.1 0.6±0.2 Code Packaging Minimum Quantity L 180mm Embossed Tape 3000 B Bulk(Bag) 1000 2.0±0.2 2.5±0.2 (in mm) c Rated Value (p: packaging code) Part Number Inductance Rated Current DC Resistance Self Resonance Frequency (min.) LQM2HPN1R0MJ0p 1.0µH ±20% 1500mA 0.09ohm ±25% 70MHz LQM2HPN2R2MJ0p 2.2µH ±20% 1000mA 0.12ohm ±25% 40MHz 3.3µH ±20% 1000mA 0.12ohm ±25% 30MHz LQM2HPN3R3MJ0p Test Frequency: 1MHz Class of Magnetic Shield: Magnetic shield of ferrite c Inductance-Frequency Characteristics (Typ.) Operating Temperature Range: -55 to +125°C c Inductance-Current Characteristics (Typ.) 10 10 3.3μH 2.2μH Inductance (μH) Inductance (μH) 3.3μH 1.0μH 1 0.1 0.1 1 10 100 Frequency (MHz) 2.2μH 1 1.0μH 0.1 10 100 1000 10000 Current (mA) Continued on the following page. oThis data sheet is applied for CHIP INDUCTORS (CHIP COILS) used for General Electronics equipment for your design. !Note: 1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering. 2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering. 2012.11.8 http://www.murata.com/ Inductors (Coils) > Chip Inductor (Chip Coil) > Power Inductor (Multilayer Type) Data Sheet 2 Continued from the preceding page. c Temperature Rise Characteristics (Typ.) 40 2.2μH Temperature Rise (°C) 30 3.3μH 20 1.0μH 10 0 0 250 500 750 Current (mA) 1000 1250 1500 c !Caution/Notice !Caution (Rating) Do not use products beyond the rated current as this may create excessive heat. Notice Solderability of Tin plating termination chip might be deteriorated when low temperature soldering profile where peak solder temperature is below the Tin melting point is used. Please confirm the solderability of Tin plating termination chip before use. oThis data sheet is applied for CHIP INDUCTORS (CHIP COILS) used for General Electronics equipment for your design. !Note: 1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering. 2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering. 2012.11.8 http://www.murata.com/