Green Power Solutions Srl Web: www.gpsemi.it e-mail: [email protected] Phone: +39-011-988 2251 Fax: +39-011-988 1358 http://gpsemi.it/pdf/GPTP3182.pdf GPTP3182 PHASE CONTROLLED SCR High reliability operation DC power supply AC drives VOLTAGE UP TO 2200 V AVERAGE CURRENT 1825 A SURGE CURRENT BLOCKING CHARACTERISTICS Characteristic Conditions 26 kA Value VRRM Repetitive peak reverse voltage 2200 V VRSM Non-repetitive peak reverse voltage 2200 V VDRM Repetitive peak off-state voltage IDRM IRRM Repetitive peak off-state current, max. Repetitive peak reverse current, max. 2300 V VDRM, single phase, half wave, Tj = Tjmax VRRM, single phase, half wave, Tj = Tjmax 150 mA 150 mA ON-STATE CHARACTERISTICS IT(AV) Average on-state current Sine wave,180° conduction, Th = 55 °C 1825 A IT(RMS) R:M:S on-state current Sine wave,180° conduction, Th = 55 °C 2865 A ITSM Surge on-state current Non rep. half sine wave, 50 Hz, VR = 0 V, Tj = Tjmax I²t I² t for fusing coordination VT(TO) Threshold voltage Tj = Tjmax 0.992 V rT On-state slope resistance Tj = Tjmax 0.206 mW VTM Peak on-state voltage, max On-state current IT = 2000 A , Tj = Tjmax 1.40 V IH IL Holding current, typ Latching current, typ Tj = 25 °C Tj = 25 °C 200 mA 450 mA 26 kA 3380 kA²s TRIGGERING CHARACTERISTICS VGT Gate trigger voltage Tj = 25 °C, VD = 5 V 3.0 V IGT Gate trigger current Tj = 25 °C, VD = 5 V 250 mA VGD Non-trigger voltage VD = 67% VRRM, Tj = Tjmax 0.3 V PGM Peak gate power dissipation Pulse width 100 µs 150 W PG(AV) Average gate power dissipation IFGM Peak gate current 10 A VFGM VRGM Peak gate voltage (forward) Peak gate voltage (reverse) 12 V 10 V 3 W SWITCHING CHARACTERISTICS di/dt Critical rate of rise of on-state current Tj = Tjmax 200 A/µs dV/dt Critical rate of rise of off-state voltage Tj = Tjmax 1000 V/µs tq Turn-off time, typ Tj = Tjmax, IT = 1000 A, di/dt = -20 A/µs µs VR = 50 V, VD = 67% VDRM, dV/dt = 20 V/µs THERMAL AND MECHANICAL CHARACTERISTICS Rth(j-c) Thermal resistance (junction to case) Double side cooled 0.015 °C/W Rth(c-h) Thermal resistance (case to heatsink) Double side cooled 0.006 °C/W Tjmax Max operating junction temperature Tstg Storage temperature F Clamping force ± 10% Mass Document GPTP3182T002 125 °C -40 / 125 °C 22 kN 520 g GPTP3182 PHASE CONTROLLED SCR Current rating - sine wave Power loss - sine wave 4000 120 180° 3500 110 90° 3000 100 PF [W] Heatsink temperature [°C] 130 90 80 70 60° 2500 30° 2000 1500 1000 60 30° 60° 90° 120° 500 180° 50 0 0 400 800 1200 1600 2000 0 400 800 IT [A] 1600 25 [A] ITIT[A] 20 15 10 5 0 10 100 4000 4000 3500 3500 3000 3000 2500 2500 2000 2000 1500 1500 1000 1000 500 500 00 0.5 0 Tj=Tjmax Tj=Tjmax 0.5 1 1 1.5 1.5 V VTT [V] [V] Number of cycle current pulses [n] Thermal impedance (j-c) 0.02 ZTH(j-c) [°C / W] 0.016 0.012 0.008 0.004 0 0.001 0.01 0.1 1 10 Time [s] Ordering information GPTP3182-VVGL VV: blocking voltage / 100 (e.g. 22 for 2200 V) G: trigger lead type (S = straight T = twisted blank = no leads) L: trigger lead lenght x 100mm (3 - 4 - 5 - 7 blank = no leads) dimensions mm In the interest of product improvement Green Power Solutions reserves the right to change any specification given in this data sheet without notice. Document GPTP3182T002 2000 On-state voltage drop 30 1 1200 IT[A] Maximum surge current d.s. cooled ITSM [A] 120° 2