Website: www.kingtronics.com Email: [email protected] Tel: (852) 8106 7033 Fax: (852) 8106 7099 MB2S THRU MB10S Single Phase 0.8 AMPS. Glass Passivated Bridge Rectifiers Voltage Range 200 to 1000 Volts Current 0.8 Amperes FEATURES ◆Ideal for printed circuit board ◆Reliable low cost construction technique results in inexpensive product ◆High temperature soldering guaranteed: 260℃ / 10 seconds / 0.375” ( 9.5mm ) lead length at 5 lbs., ( 2.3 kg ) tension ◆UL Recognized File number: E347214 MECHANICAL DATA ◆Case: Molded plastic ◆Lead: solder plated ◆Polarity: As marked MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Rating at 25℃ ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, resistive or inductive load.For capacitive load, derate current by 20% SYMBOLS MB2S MB4S MB6S MB8S MB10S UNITS Maximum Repetitive Peak Reverse Voltage VRRM 200 400 600 800 1000 V Maximum RMS Voltage VRMS 140 280 420 560 700 V VDC 200 400 600 800 1000 V Maximum DC Blocking Voltage Maximum Average Forward Rectified Current On glass-epoxy P.C.B. I(AV) On aluminum substrate 0.5 0.8 A Peak Forward Surge Current, 8.3ms Single Half Sine-wave Superimposed on IFSM 35 A VF 1.0 V Rated Load (JEDEC method ) Maximum Instantaneous Forward Voltage at 0.4A Maximum DC Reverse Current @ TA=25℃ Rated DC Blocking voltage per leg TA=125℃ IR 5.0 500 μA Typical Thermal Resistance (Note1) RθJA 70 (Note2) RθJL 20 TJ -55 to +150 ℃ TSTG -55 to +150 ℃ Operating Temperature Range Storage Temperature Range ℃/W Note: 1.On aluminum suvstrate P.C.B. with an area of 0.8×0.8”(20×20mm) mounted on 0.05×0.05”(1.3×1.3mm) solder pad. 2. Thermal Resistance from Junction to Case with units Mounted on 2.6×1.4×0.06”Thick(6.5×3.5×0.15cm)Al.Plate. 1 Website: www.kingtronics.com Email: [email protected] Tel: (852) 8106 7033 Fax: (852) 8106 7099 MB2S THRU MB10S RATING AND CHARACTERISTIC CURVES MB2S THRU MB10S Note: Specifications are subject to change without notice. 2