5.0X6.0mm SURFACE MOUNT LED LAMP AA5060SURC/G HYPER RED Features Description z SINGLE The Hyper Red source color devices are made with DH COLOR. z SUITABLE FOR ALL SMT ASSEMBLY AND SOLDER InGaAlP on GaAs substrate Light Emitting Diode. PROCESS. z AVAILABLE z IDEAL FOR BACKLIGHTING. z PACKAGE zRoHS ON TAPE AND REEL. : 500PCS / REEL. COMPLIANT. . Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Specifications are subject to change without notice. SPEC NO: DSAD0898 APPROVED: J. Lu REV NO: V.3 CHECKED: Allen Liu DATE: MAR/09/2005 DRAWN: S.H.CHEN PAGE: 1 OF 4 ERP:1201000537 Selection Guide Part No. Dice AA5060SURC/G Iv (mcd) @ 50mA Lens Type HYPER RED (InGaAlP) WATER CLEAR Viewing Angle Min. Typ. 2θ1/2 480 750 100° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Hyper Red λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 640 nm IF=20mA Hyper Red 630 nm IF=20mA Spectral Line Half-width Hyper Red 22 nm IF=20mA C Capacitance Hyper Red 45 pF VF=0V;f=1MHz VF Forward Voltage Hyper Red 1.9 2.5 V IF=20mA IR Reverse Current Hyper Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Hyper Red Units Power dissipation 100 mW DC Forward Current 30 mA Peak Forward Current [1] 150 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD0898 APPROVED: J. Lu REV NO: V.3 CHECKED: Allen Liu DATE: MAR/09/2005 DRAWN: S.H.CHEN PAGE: 2 OF 4 ERP:1201000537 Hyper Red SPEC NO: DSAD0898 APPROVED: J. Lu AA5060SURC/G REV NO: V.3 CHECKED: Allen Liu DATE: MAR/09/2005 DRAWN: S.H.CHEN PAGE: 3 OF 4 ERP:1201000537 AA5060SURC/G Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength), the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAD0898 APPROVED: J. Lu REV NO: V.3 CHECKED: Allen Liu DATE: MAR/09/2005 DRAWN: S.H.CHEN PAGE: 4 OF 4 ERP:1201000537