SEMTECH FR601 Fast recovery rectifier Datasheet

FR601 THRU FR607
FAST RECOVERY RECTIFIERS
Voltage – 50 to 1000 Volts
Current – 6.0 Ampere
Features
• Low forward voltage drop
• Low leakage
• High current capability
• High reliability
• High current surge
• Fast switching
Mechanical Data
• Case: Molded plastic.
• Epoxy: UL 94V-0 rate flame retardant.
• Terminals: MIL-STD-202E, method 208C guaranteed.
• Polarity: Color band denotes cathode end.
• Mounting Position: Any.
Absolute Maximum Ratings and Characteristics @ 250C unless otherwise specified.
Single phase half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20%.
Symbols
FR601 FR602 FR603 FR604 FR605 FR606 FR607
Units
Maximum repetitive peak reverse voltage
VRRM
50
100
200
400
600
800
1000
Volts
Maximum RMS voltage
VRMS
35
70
140
280
420
560
700
Volts
Maximum DC blocking voltage
VDC
50
100
200
400
600
800
1000
Volts
Maximum Average forward rectified current
at TA = 75 OC
Peak forward surge current 8.3ms single half sine-wave,
superimposed on rated load (JEDEC method)
Maximum instantaneous forward voltage
at IFM = 6 A ,
Maximum DC reverse current
TA = 25 OC
at rated DC blocking voltage
TL = 55OC
I(AV)
6.0
Amps
IFSM
300
Amps
VF
1.3
Volts
10
IR
Maximum reverse recovery time (Note 1)
Trr
Typical junction capacitance (Note 2)
CJ
150
TJ ,TS
-65 to +150
Operating and storage temperature range
µA
150
150
250
500
nS
pF
O
1) Reverse recovery test conditions: IF = 0.5A, IR = 1A, Irr = 0.25A
2) Measured at 1MHZ and applied reverse voltage of 4volts D.C.
SEMTECH ELECTRONICS LTD.
®
(Subsidiary of Semtech International Holdings Limited, acompany
listed on the Hong Kong Stock Exchange, Stock Code: 724)
Dated : 12/04/2003
C
FR601 THRU FR607
MAXIMUM NON-REPETITIVE FORWARD
SURGE CURRENT
PEAK FORWARD SURGE CURRENT.(A)
AVERAGE FORWARD CURRENT.(A)
TYPICAL FORWARD CURRENT
DERATING CURVE
single phase,half wave 60Hz
resistive or inductive load
8.3 ms single half
sine wave
JEDEC method
NUMBER OF CYCLES AT 60Hz
Ambient Temperature Ta ( ℃ )
TYPICAL JUNCTION CAPACITANCE
JUNCTION CAPACITANCE.(pF)
INSTANTANEOUS FORWARD CURRENT.(A)
TYPICAL FORWARD CHARACTERISTICS
Tj=25 C
Pulse Width 300us
1% Duty Cycle
TJ=25 C
FORWARD VOLTAGE .(V)
REVERSE VOLTAGE.(V)
T E ST C IR C U IT D IA G R A M A N D R E V E R SE
R E C O V E R Y T IM E C H A R A C T E R IST IC S
50Ω
N O N -IN D U C T IV E
10 Ω
N O N -IN D U C TIV E
trr
+0.5A
0
pulse
generator
(N ote 2)
25V dc
(approx.)
Ω
noninductive
oscilliscope
(N ote 1)
N otes: 1.R ise tim e = 2ns m ax. Input im pedance= 1m egohm .22pF
2. R ise tim e= 10ns m ax. Source im pedance= 50ohm s.
-0.25A
-1.0A
1cm
set time base for
50/10ns/cm
SEMTECH ELECTRONICS LTD.
®
(Subsidiary of Semtech International Holdings Limited, acompany
listed on the Hong Kong Stock Exchange, Stock Code: 724)
Dated : 12/04/2003
Similar pages