MPS-45 45W Single Output Medical Type series Features : Universal AC input / Full range Low leakage current 0.3mA Protections: Short circuit / Overload / Over voltage Cooling by free air convection 100% full load burn-in test Fixed switching frequency at 45KHz 3 years warranty SPECIFICATION MODEL OUTPUT MPS-45-3.3 MPS-45-5 MPS-45-7.5 MPS-45-12 MPS-45-13.5 MPS-45-15 MPS-45-24 MPS-45-27 DC VOLTAGE 3.3V 5V 7.5V 12V 13.5V 15V 24V 27V 48V RATED CURRENT 8A 8A 5.4A 3.7A 3.3A 3A 1.9A 1.7A 1A CURRENT RANGE 0 ~ 10.7A 0 ~ 10.5A 0 ~ 7A 0 ~ 4.4A 0 ~ 3.9A 0 ~ 3.5A 0 ~ 2.2A 0 ~ 1.95A 0 ~ 1.1A RATED POWER 26.4W 40W 40.5W 44.4W 44.55W 45W 45.6W 45.9W 48W OUTPUT POWER (max.) 52W(+3.3V:35W)with 18CFM min. Forced air convection 100mVp-p 100mVp-p 100mVp-p 100mVp-p 100mVp-p RIPPLE & NOISE (max.) Note.2 80mVp-p 2.97 ~ 3.63V 4.5 ~ 5.5V VOLTAGE TOLERANCE Note.3 3.0% 3.0% 1.0% 1.0% 1.0% 1.0% 1.0% 1.0% 1.0% 1.0% 1.0% 3.0% 3.0% 3.0% 2.0% 2.0% 2.0% 2.0% 2.0% 2.0% 800ms, 30ms/230VAC HOLD UP TIME (Typ.) 50ms/230VAC VOLTAGE RANGE 90 ~ 264VAC FREQUENCY RANGE 47 ~ 440Hz 16ms/115VAC at full load 65% AC CURRENT (Typ.) 1.2A/115VAC INRUSH CURRENT (Typ.) LEAKAGE CURRENT COLD START 17A/115VAC <0.3mA / 264VAC OVER VOLTAGE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS SAFETY & WITHSTAND VOLTAGE ISOLATION RESISTANCE EMC (Note 4) EMC EMISSION EMC IMMUNITY MTBF DIMENSION PACKING 1200ms, 30ms/115VAC at full load 127 ~ 370VDC EFFICIENCY(Typ.) PROTECTION NOTE 100mVp-p 6.75 ~ 8.25V 10.8 ~ 13.2V 12.2 ~ 14.85V 13.5 ~ 16.5V 21.6 ~ 26.4V 24.3 ~ 29.7V 43.2 ~ 52.8V 3.0% 2.0% 2.0% 2.0% 2.0% 2.0% 2.0% LOAD REGULATION OVERLOAD OTHERS 100mVp-p LINE REGULATION SETUP, RISE TIME INPUT 100mVp-p VOLTAGE ADJ. RANGE MPS-45-48 72% 75% 76% 76% 77% 78% 78% 78% 0.7A/230VAC 35A/230VAC 53 ~ 75W (3.3V:36 ~ 55W) rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed 3.8 ~ 4.46V 5.75 ~ 6.75V 8.63 ~ 10.1V 13.8 ~ 16.2V 15.5 ~ 18.2V 17.25 ~ 20.25V 27.6 ~ 32.4V 31 ~ 36.45V 55.2 ~ 64.8V Protection type : Hiccup mode, recovers automatically after fault condition is removed -10 ~ +60 (Refer to "Derating Curve") 20 ~ 90% RH non-condensing -20 ~ +85 , 10 ~ 95% RH 0.04%/ (0 ~ 50 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes ANSI/AAMI ES60601-1, TUV EN60601-1, IEC60601-1 approved I/P-O/P:4KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC I/P-O/P, I/P-FG:100M Ohms / 500VDC / 25 / 70% RH Compliance to EN55011 (CISPR11) Class B, EN61000-3-2,-3 Compliance to EN61000-4-2,3,4,5,6,8,11, EN60601-1-2, medical level, criteria A 366.1Khrs min. MIL-HDBK-217F (25 127*76*28mm (L*W*H) 0.18Kg; 72pcs/15.1Kg/1.35CUFT ) 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. For guidance on how to perform these EMC tests, please refer to EMI testing of component power supplies. (as available on http://www.meanwell.com) 5. Mounting holes M1 and M2 should be grounded for EMI purposes. 6. Heat Sink HS1,HS2 can not be shorted. File Name:MPS-45-SPEC 2011-12-15 MPS-45 45W Single Output Medical Type Mechanical Specification series Unit:mm 127 115.8 5.6 5.6 FG HS1 M1 M2 76 64.8 CN2 FS1 1 2 3 4 5 6 AC FUSE T2A/250V 1 HS2 2 CN1 FS2 AC FUSE T2A/250V SVR1 4- LED 3. 2 max. 28 8 AC Input Connector (CN1) : Molex 5277-02 or equivalent Assignment AC/N AC/L Pin No. 1 2 Mating Housing Terminal Molex 5195 or equivalent Molex 5194 or equivalent DC Output Connector (CN2) : Molex 5273-06 or equivalent Pin No. 1,2,3 4,5,6 Terminal Molex 5194 or equivalent Mating Housing Molex 5195 or equivalent Assignment +V -V HS1,HS2 can not be shorted Block Diagram fosc : 45KHz RECTIFIERS & FILTER EMI FILTER I/P RECTIFIERS & FILTER POWER SWITCHING FG O.L.P. DETECTION CIRCUIT PWM CONTROL Derating Curve +V -V O.V.P. Static Characteristics 100 100 Others 90 80 80 70 3.3V,5V LOAD(%) LOAD (%) 60 40 20 -10 0 10 20 30 40 50 AMBIENT TEMPERATURE ( ) 60 (HORIZONTAL) 60 50 40 90 100 110 135 155 230 264 INPUT VOLTAGE (V) 60Hz File Name:MPS-45-SPEC 2011-12-15