February 12, 2007 SHIELDED SMD INDUCTOR DR358-2 SERIES Features z z z z z Low Profile Surface Mount Design Flat Top for Pick and Place Inductance Range from 1.2µH to 220.0µH Operating Temp. -20°C to +80°C Tinned Leads with Leaded Solder is Available (note 7) ELECTRICAL SPECIFICATIONS AT 25ºC Part No. DR358-2-122 DR358-2-182 DR358-2-222 DR358-2-272 DR358-2-332 DR358-2-392 DR358-2-472 DR358-2-562 DR358-2-682 DR358-2-822 DR358-2-103 DR358-2-123 DR358-2-153 DR358-2-183 DR358-2-223 DR358-2-273 DR358-2-333 DR358-2-393 DR358-2-473 DR358-2-563 DR358-2-683 DR358-2-823 DR358-2-104 DR358-2-124 DR358-2-154 DR358-2-184 DR358-2-224 Inductance (µH) ± 30% 1.2 1.8 2.2 2.7 3.3 3.9 4.7 5.6 6.8 8.2 10.0 12.0 15.0 18.0 22.0 27.0 33.0 39.0 47.0 56.0 68.0 82.0 100.0 120.0 150.0 180.0 220.0 DCR (Ω) Max. 0.023 0.027 0.031 0.043 0.049 0.064 0.072 0.100 0.108 0.117 0.128 0.131 0.149 0.166 0.235 0.261 0.378 0.383 0.587 0.624 0.699 0.914 1.020 1.270 1.350 1.540 1.650 I rated (A) Max. 2.56 2.20 2.04 1.60 1.57 1.44 1.32 1.17 1.12 1.04 1.00 0.84 0.76 0.72 0.70 0.58 0.56 0.50 0.48 0.41 0.35 0.32 0.29 0.27 0.24 0.22 0.18 MECHANICAL OUTLINES Notes: 1. 2. 3. 4. 5. 6. 7. 8. DATATRONIC: All dimensions are shown in millimeter “mm” General tolerance ±0.2mm, unless other specified Inductance Test: 100kHz, 0.1Vrms Irated for an approximate 40°C temperature rise Irated for an approximate 35% drop maximum of the initial value Tape and reel quantity, 2000 pcs/reel For non-RoHS parts replace DR prefix with 42(e.g. DR358-2 becomes 42-358-2) Terminal finish is compliant to RoHS requirements. Solder in accordance with J-STD020C. 28151Highway 74, Romoland, CA 92585 Tel: 951-928-7700 Toll Free Tel: 888-889-5391 Fax: 951-928-7701 Email: [email protected] 499 King’s Road, Hong KongTel: (852) 2562 3858, (852) 2564 8477 Fax: (852) 2565 7214, (852) 2563 1290 All specifications are subject to change without notice.