UNISONIC TECHNOLOGIES CO., LTD L1119 CMOS IC 1.5A LOW DROPOUT REGULATORS 1 1 DESCRIPTION TO-252 SOT-223 The UTC L1119 is a fast ultra low-dropout linear regulator that developed in CMOS process which allows low quiescent current operation independent of output load current. This CMOS process also allows the device to operate under extremely low dropout conditions. The UTC L1119 allows to operate from a 2.5V~7.0V input supply. Wide range of preset output voltage options are available and respond very fast to step changes in load which makes them suitable for low voltage microprocessor applications. FEATURES 1 SOT-89 *Pb-free plating product number: L1119L-xx * Low ground current * Load regulation of 0.04% * Output current of 1.5A DC is guaranteed * Accurate output voltage.(± 1.5%) * Extremely low output capacitor requirements * Over temperature/ Over current protection ORDERING INFORMATION Order Number Normal Lead Free Plating L1119-xx-AA3-A-R L1119L-xx-AA3-A-R L1119-xx-AA3-C-R L1119L-xx-AA3-C-R L1119-xx-AB3-A-R L1119L-xx-AB3-A-R L1119-xx-AB3-B-R L1119L-xx-AB3-B-R L1119-xx-AB3-C-R L1119L-xx-AB3-C-R L1119-xx-AB3-D-R L1119L-xx-AB3-D-R L1119-xx-TN3-D-R L1119L-xx-TN3-D-R L1119-xx-TN3-D-T L1119L-xx-TN3-D-T Note: Pin assignment: I: VIN O: VOUT G:GND L1119L-xx-AA3-A-R (1)Packing Type (2)Pin Assignment (3)Package Type (4)Output Voltage Code (5)Lead Plating www.unisonic.com.tw Copyright © 2005 Unisonic Technologies Co., Ltd Package SOT-223 SOT-223 SOT-89 SOT-89 SOT-89 SOT-89 TO-252 TO-252 Pin Assignment 1 2 3 G O I G I O G O I O G I G I O I G O I G O I G O Packing Tape Reel Tape Reel Tape Reel Tape Reel Tape Reel Tape Reel Tape Reel Tube (1) R: Tape Reel, T: Tube (2) refer to Pin Assignment (3) AA3: SOT-223, AB3: SOT-89, TN3: TO-252 (4) xx: refer to Marking Information (5) L: Lead Free Plating, Blank: Pb/Sn 1 of 7 QW-R502-051,B L1119 CMOS IC MARKING INFORMATION PACKAGE VOLTAGE CODE MARKING L1119 SOT-223 VOLTAGE CODE DATE CODE 1 SOT-89 LEAD PLATING PIN CODE 12 15 18 25 33 50 :1.2V :1.5V :1.8V :2.5V :3.3V :5.0V 2 3 PIN CODE VOLTAGE CODE DATE CODE L1119 1 2 LEAD PLATING 3 UTC L1119 TO-252 LEAD PLATING PIN CODE VOLTAGE CODE DATE CODE 1 UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 2 3 2 of 7 QW-R502-051,B L1119 CMOS IC BLOCK DIAGRAM VIN VOUT - + GND UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 3 of 7 QW-R502-051,B L1119 CMOS IC ABSOLUTE MAXIMUM RATINGS PARAMETER SYMBOL RATINGS UNIT Input Supply Voltage VIN -0.3 ~ +7.5 V Output Voltage VOUT -0.3 ~ +7.5 V Output Current IOUT Short Circuit Protected Power Dissipation PD Internally Limited ℃ Operating Junction Temperature TOPR -40 ~ +125 Storage Temperature TSTG -65 ~ +150 ℃ Note Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. RECOMMENDED OPERATING RATINGS PARAMETER SYMBOL RATINGS UNIT Input Supply Voltage VIN 2.5 ~ 7.0 V Maximum Operating Current (DC) IOPR(MAX) 1.5 A Operating Junction Temperature TJ -40 ~ +125 ℃ Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. ELECTRICAL CHARACTERISTICS (TJ=25°C, VIN =VOUT+1V, IL=10mA, COUT=33µF, unless otherwise specified.) PARAMETER Dropout Voltage (Note) Peak Output Current SYMBOL VD IPEAK Ground Pin Current IGND Output Voltage Tolerance VOUT Line Regulation Load Regulation SHORT CIRCUIT PROTECTION Short Circuit Current AC PARAMETERS Output Noise Density TEST CONDITIONS IL = 150 mA IL = 1.5 A ∆VOUT ∆VOUT 2.0 IL = 150 mA IL = 1.5 A 10 mA ≤ IL ≤ 1.5A VOUT +1 ≤ VIN≤ 7.0V VOUT+1V<VIN<7.0V 10 mA < IL < 1.5 A ISC ρN(l/f) Output Noise Voltage eN Ripple Rejection RR MIN f = 120Hz BW = 10Hz – 100kHz BW = 300Hz – 300kHz VIN = VOUT + 1.5V COUT =100uF, VOUT = 3.3V VIN = VOUT + 0.3V COUT =100uF, VOUT = 3.3V -1.5 TYP 38 870 2.5 4 5 MAX 45 UNIT 9 14 mA 0 +1.5 % mV A 0.1 1.5 % % 4.5 A 0.8 150 100 µV µV(rms) 60 dB 40 OVER TEMPERATURE PROTECTION Shutdown Threshold TSHDN 165 °C Thermal Shutdown Hysteresis THYS 10 °C Note: Dropout voltage is defined as the minimum input to output differential voltage at which the output drops 2% below the nominal value. Dropout voltage specification applies only to output voltages of 2.5V and above. For output voltages below 2.5V, the drop-out voltage is nothing but the input to output differential, since the minimum input voltage is 2.5V. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 4 of 7 QW-R502-051,B L1119 CMOS IC TYPICAL CHARACTERISTICS (VIN=VOUT+1V, VOUT=2.5V, COUT=33µF, IOUT =10mA, CIN=68µF, Ta=25°C.) Drop-Out Voltage vs Temperature (IL) Drop-Out Voltage vs Temperature (VOUT) 0.25 0.225 IOUT=800mA IL =800mA 0.2 VOUT=3.3V 0.2 Drop-Out (V) Drop-Out (V) VOUT=2.5V 0.15 0.1 0.175 VOUT=5V 0.15 0.05 IL =100mA 0 -40 -20 0 20 40 60 0.125 -40 -20 80 100 120 140 0 20 40 60 80 100 120 140 Temperature (℃) Temperature (℃) △VOUT vs Temperature Noise Density 0.00 10 VIN=3.5V, VOUT=2.5V, I L=10mA -0.10 -0.30 Noise (μV/ Hz ) Delta VOUT (%) -0.20 -0.40 -0.50 -0.60 1.000 0.100 -0.70 -0.80 0.010 -0.90 -75 -50 -25 0 25 50 75 100 125 10 100 1000 10000 100000 Frequency (Hz) Temperature (℃) Input Voltage vs Output Voltage 3 2.5 VOUT (V) 2 IL=100mA 1.5 1 I L=800mA 0.5 0 0 1 2 3 4 VIN (V) UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 5 of 7 QW-R502-051,B L1119 CMOS IC TYPICAL CHARACTERISTICS(Cont.) Output Noise Density 10 Output Noise Density 10 VOUT=2.5V VOUT=5V 1 0.1 1 Noise (μV/ Hz) Noise (μV/ Hz) COUT=33μF COUT=33μF 0.1 COUT=68μF 0.01 COUT=68μF 0.01 100 1000 10000 100 100000 1000 10000 100000 Frequency (Hz) Frequency (Hz) Ripple Rejection vs Frequency Load Transient Response 90 Ripple Rejection (dB) VOUT (V) COUT=100μF I L=800mA 70 3.5 3.4 3.3 3.2 2 I OUT (A) COUT=100μF IL =10mA 80 3.6 60 COUT=68μF IL =10mA 50 40 30 20 10 0 -10 0 10 20μs/DIV 100 1K 10K 100K 1M Frequency (Hz) 3.5 3.4 3.3 3.3 3.2 3.2 5.4 5.3 VIN (V) VIN (V) Line Transient Response VOUT (V) VOUT (V) Line Transient Response 4.4 10μs/DIV UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 4.3 10μs/DIV 6 of 7 QW-R502-051,B L1119 CMOS IC TYPICAL CHARACTERISTICS(Cont.) Line Transient Response Line Transient Response 3.45 I OUT=1.5A IOUT=1.5A 3.4 3.35 VOUT (V) VOUT (V) 3.35 3.3 3.25 3.3 3.25 3.2 VIN (V) VIN (V) 3.15 5.3 5.3 4.3 4.3 10μs/DIV 10μs/DIV UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 7 of 7 QW-R502-051,B