01-Serie NK-A_01-Serie NK-A 21/11/12 18:26 Page2 NK series Subminiature slide switches ❑ The smallest changeover ❑ Flush and raised actuators ELECTRICALSPECIFICATIONS MATERIALS • Max. current/voltage rating with resistive load : 0,5A 12V • Minimum load : 1mA 10mV • Initial contact resistance : 20 mΩ max. • Insulation resistance : 10.000 MΩ min. at 500VDC • Dielectric strength : 250 Vrms. 50 Hz min. between terminals 2.000 Vrms 50 Hz min. between adjacent poles of switches placed side by side • Electrical life with nominal load : 2.000 cycles • Capacitance : < 1,5 pF • Case : PA6/6, glass filled, UL94-V0 • Actuator : PA6/6, glass filled, UL94-V0 • Contacts : gold over nickel EXAMPLESOFLAYOUT Ø1.00 (.039DIA) 2.54 (.100) 2.54 (.100) GENERALSPECIFICATIONS • Wave solderable : flux sealed • End stackable, 2,54 (.100) terminal to terminal pitch - 4 switches max., hole dia. 1 mm (.039) • Travel : 1,6 mm (.062) • Operating temperature : -40°C to +85°C • Soldering temperature : 250°C for 5 sec. max. • Moisture test : 21 days at 95 % RH (IEC 68-2-3) Ø0.80 - Ø1.00 (.031DIA - .039DIA) Straight PC terminals 1 Raised actuator NK236H ON - I ON II 2.54 (.100) 7.90 (.311) 2 3 2.60 (.102) I 6.50 (.256) Flush actuator NK236 II 3 1 2 2.54 (.100) 5.00 (.196) E II 1-2 0.50 (.019) I 1-3 2 1 3 Ø1.00 (.039 DIA) Ø0.60 (.023 DIA) 10.00 (.393) ON - ON Right angle terminals II 1-2 Raised actuator NK236WH ON - ON 3 1 2 2.54 (.100) 10.00 (.393) ON - I II 2.54 (.100) 7.90 (.311) 3.70 (.146) 0.70 (.027) 2 3 2.60 (.102) I 6.50 (.256) Flush actuator NK236W II Ø0.60 (.023 DIA) 1 0.50 (.019) I 1-3 2 1 3 Ø1.00 (.039 DIA) ON Dimensions : first dimensions are in mm while inches are shown as bracketed numbers. Packaging unit : 100 pieces. E-2 www.apem.com APEM