POWER NTS500 Series 500 Watts Data Sheet Total Power: 200 - 500 Watts Input Voltage: 85 - 264 Vac 120 - 300 Vdc # of Outputs: Single SPECIAL FEATURES Active power factor correction IEC EN61000-3-2 compliance Remote sense Power fail and remote inhibit Single wire current sharing Built-in EMI filter Low output ripple 5 V standby 12 V fan output Overvoltage protection Overload protection Thermal overload protection DC power good Built in OR-ing diode/FET Optional fan cover (-CF suffix) Optional end fan cover (-CEF suffix) PM Bus compliant RoHS compliant Digital I2C interface Two year warranty POE isolation on NTS508 SAFETY TUV: cCSAus: NEMKO: CB: CE: 60950 60950 60950 Certificate & report Mark (LVD) Electrical Specifications Input Input range 85 - 264 Vac (wide range) Frequency 47 - 440 Hz Inrush current 50 A max., cold start @ 25 °C Efficiency 85% typical at full load, nominal line EMI filter FCC Class B conducted and radiated; CISPR22 Class B conducted and radiated; EN55022 Class B conducted and radiated; VDE0878PT3 Class B conducted and radiated. Safety ground leakage current < 0.5 mA @ 50/60 Hz, 264 Vac input Output Maximum power 200 W for convection; 500 W with 30 CFM forced air Adjustment range ± 5% Standby output 5 V @ 1 A convection, 2 A forced air, regulated, ± 5% Fan output 12 V @ 1 A, -5 %, +7%, 0.5 A for -CF version Hold-up time 20 ms @ 500 W load, 115 VAC nominal line at factory voltage setting Overload protection Short circuit protection on all outputs. Case overload protected @ 115 - 130% above peak rating Overvoltage protection 20 - 35% above nominal output NTS500 Series Data Sheet Environmental Specifications Operating temperature 0° to 50 °C ambient derate each output as 2.5% per degree from 50° to 70 °C Storage temperature -40 °C to +85 °C Electromagnetic susceptibility Designed to meet EN61000-4; -2, -3, -4, -5, -6, -8, -11 Level 3 Humidity Operating; non-condensing 10% to 90% RH Vibration Three orthogonal axes, sweep at 1 oct/min, 5 min. dwell at four major resonances 2 G peak 8 Hz to 500 Hz, operational Ordering Information Output Voltage Minimum Load Maximum Load with Convection Cooling Maximum Load with 30CFM Forced Air Peak Load1 Regulation2 Ripple P/P (PARD)3 NTS503 12 V 0A 16.6 A 41.7 A 47 A ± 2% 120 mV NTS505 24 V 0A 8.3 A 20.8 A 23.4 A ± 2% 240 mV NTS506 18 V 0A 11.1 A 27.7 A 30 A ± 2% 180 mV NTS508 48 V 0A 4.2 A 10.4 A 11.7 A ± 2% 480 mV Model Number 1. Peak current lasting < 30 seconds with a maximum 10% duty cycle. 2. At 25 °C including initial tolerance, line voltage, load currents and output voltages adjusted to factory settings. 3. Peak-to-peak with 20 MHz bandwidth and 10 µF (tantalum capacitor) in parallel with a 0.1 µF capacitor at rated line voltage and load ranges. 4. 12 V fan output cannot be used above 50 °C with convection cooling. 5. -CF suffix added to the model number indicates cover with top fan. -CEF suffix added to the model number indicates cover with end mounted fan cover and AC inlet. 6. This product is a Component Power Supply and is only for inclusion by professional installers within other equipment and must not be operated as a standalone product. EMC compliance to appropriate standards must be verified at the system level. This product is for sale to OEMs and System Integrators, including through Distribution Channels. It is not intended for sale to End Users. Logic Control Power failure TTL logic signal goes high 100 - 500 msec after main output. It goes low 10msec before loss of regulation. Remote on/off Requires an external contact closure to inhibit outputs DC OK TTL logic goes high after the output is in regulation. It goes low when there is loss of regulation. Remote sense Compensates for 0.5 V lead drop min. Will operate without remote sense connected. Reverse connection protected. NTS500 Series Data Sheet Pin Assignments Adjustment Potentiometers Connector P1 CN1 SK7 1 5 6 10 SK8 CN403 1 5 6 10 +V1 Output adjust PIN 1 Line Mating Connectors PIN 3 Neutral SK4, 5, 6 Molex 19141-0058 PIN 5 Ground SK7 Molex 90142-0010 PIN 1 V1 SWP PIN 2 - Remote Sense PIN 3 + Remote Sense PIN 4 5 VSB (standby) PIN 5 5 VSB return PIN 6 +12 V PIN 7 Common PIN 8 Inhibit PIN 9 DC power good (DC OK) PIN10 Power Fail (POK) PIN 1 +12 V Fan PIN 2 Common PIN 1 5 V_I2C PIN 2 Ground Notes: PIN 3 A2 PIN 4 A0 PIN 5 SVCC2_OR PIN 6 I2C_SDA PIN 7 I2C_SLC PIN 8 A1 PIN 9 N/C 1. Specifications subject to change without notice. 2. All dimensions in inches (mm), tolerance is ± 0.2”. 3. Specifications are at factory settings 4. Mounting maximum insertion depth is 0.12”. 5. Warranty: 2 year 6. Weight: NTS50X - 1.66 lbs/0.75 kg NTS50X-CF - 2.00 lbs/0.9 kg NTS50X-CEF - 2.26 lbs/1.03 kg PIN 10 +12 V_RTN_CTRL PINS: 90119-2110 Or Amp: 87977-3 PINS: 87309-8 Or *Landwin: 2580S1003 PINS: 2583T011R SK8 JST PHR-2 Pins: SPH-002T-PO.5S CN403 JST PHDR-10VS Pins: JST 5PHD-002T-PO.5-L/P Or *Landwin 2050 S1000 Pins: 2053T011P * Where available Artesyn Connector Kit #70-841-024 includes all of the above (Molex for SK7) NTS500 Series Data Sheet Mechanical Drawing +V OR-ing out +V out Common L AC Input N (CN1) PE 5 10 1 6 Signal Output (SK7) -CF option V out adj 12C Header (CN403) 1 5 1 2 6 10 Fan Header SK8 1.24[31.5] a 1.15[29.1] b 0.75[19.1] (3X) 1.5[38.1] 5.85[148.7] 0.3[6.4] 6.25[158.7] a b b a 4[101.6] 2.5 [63.5] (4X) b a a b 4.7 [119.6] (2X) 5.5 [139.7] (2X) 7 [177.8] #6-32 (8 places) M3 (8 places) NTS500 Series Data Sheet Mechanical Drawing - CEF option a a b a b b AIR FLOW DIRECTION 1.61" (40.9) 1.255" (31.9) 0.862" (21.9) 0.862" (21.9) 4.0" (101.6) 9.15" (232.3) b a 5.85" (148.6) 2.40" (61) 6.244" (158.6) a a b b a a b 2.9" (73.6) 4.7" (119.6) 0.752" (19.1) 6.437" (63.5) b 5.5" (139.7) #6-32 (8 places) M3 (8 places) WORLDWIDE OFFICES Americas Europe (UK) Asia (HK) 2900 S.Diablo Way Tempe, AZ 85282 USA +1 888 412 7832 Waterfront Business Park Merry Hill, Dudley West Midlands, DY5 1LX United Kingdom +44 (0) 1384 842 211 14/F, Lu Plaza 2 Wing Yip Street Kwun Tong, Kowloon Hong Kong +852 2176 3333 Artesyn Embedded Technologies, Artesyn and the Artesyn Embedded Technologies logo are trademarks and service marks of Artesyn Embedded Technologies, Inc. All other names and logos referred to are trade names, trademarks, or registered trademarks of their respective owners. © 2016 Artesyn Embedded Technologies, Inc. All rights reserved. For full legal terms and conditions, please visit www.artesyn.com/legal. www.artesyn.com For more information: www.artesyn.com/power For support: [email protected] NTS500 DS 21Mar2016