OP550, OP552, OP555, OP560, OP565, OP750 Series OP552 Features: OP555 OP565 OP550 OP560 OP750 OP770 Wide receiving angle Four sensitivity ranges Side-looking package Ideal for space-limited applications Ideal for PCBoard mounting Choice of clear, opaque or blue-tinted package Description: OP550, OP552, OP555, OP750, and OP770 series consists of a NPN silicon phototransistor molded in an epoxy package with a wide receiving angle that provides relatively even reception over a large area. The OP750 and OP770 have additional circuitry to enhance the operation of the device for stray light levels. OP560 and OP565 series consists of a NPN silicon photodarlington transistor molded in an epoxy package with a wide receiving angle that provides relatively even reception over a large area. The side-looking package design allows easy PCBoard mounting of slotted optical switches or optical interrupt detectors. The OP550, OP560, OP750 and OP770 devices have an external lens in a clear epoxy package. The OP552 device has an integral lens in an opaque plastic package that is optically transparent to infrared light but opaque to visible wavelengths. This feature allows the device to be used under high ambient light conditions – or anywhere external light sources could interfere with the intended sensing application (visible light immunity). The OP555 and OP565 devices have an internal lens in a blue-tinted package. The lensing effect of this package allows an acceptance half-angle of 28° when measured from the optical axis to the half-power point. These devices are 100% production tested using infrared light for close correlation with OPTEK’s GaAs and GaAIAs emitters. All of these sensors are mechanically and spectrally matched to the OP140, OP142, OP145, OP240 and OP245 series of infrared emitting diodes. Please refer to Application Bulletins 208 and 210 for additional design information and reliability (degradation) data. For custom versions please contact your OPTEK representative. Applications: OP __ __ __ __ Applications requiring wide receiving angle Applications requiring PCBoard mounting Space-limited applications Optical switches Optical interrupt detectors Optical encoders Non-contact position sensing Machine automation 55 = Phototransistor 56 = Photodarlington 75 = Phototransistor with RBE A = Highest sensitivity level B = Sensitivity Level with Min. Max. C = Middle Sensitivity Level 77 = Phototransistor with CCE D = Lowest Sensitivity Level 0 = Extended Lens - Clear Package 2 = Extended Lens - Blue Tinted Package 5 = Integral Lens - Blue Tinted Package OP550A OP550B OP550C OP550D OP552A OP552B OP552C OP552D OP555A OP555B OP555C OP555D Available Part Numbers OP560A OP565A OP750A OP560B OP565B OP750B OP560C OP565C OP750C OP750D OP755A OP755B OP755C OP755D OP770A OP770B OP770C OP770D OP775A OP775B OP775C OP775D RoHS General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. © TT electronics plc OPTEK Technology, Inc. 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www.ttelectronics.com Issue A 08/2016 Page 1 OP550, OP552, OP555, OP560, OP565, OP750 Series OP550, OP552, OP560, OP750, OP770 (A, B, C, D) DIMENSIONS ARE IN: [MILLIMETERS] INCHES OP555, OP565 (A, B, C, D) DIMENSIONS ARE IN: [MILLIMETERS] INCHES 2 Pin # Sensor 1 2 Emitter Collector OP555 - CONTAINS POLYSULFONE To avoid stress cracking, we suggest using ND Industries’ Vibra-Tite for thread-locking. Vibra-Tite evaporates fast without causing structural failure in OPTEK'S molded plastics. 1 Notes: 1. RMA flux is recommended. Duration can be extended to 10 seconds maximum when flow soldering. A maximum 20 grams force may be applied to the leads when soldering. 2. For OP550, OP560, OP555 and OP565, derate linearly 1.33 mW/° C above 25° C. For OP552, derate linearly 1.25 mW/° C above 25° C. 3. For all phototransistors in this series, the light source is an unfiltered GaAs LED with a peak emission wavelength of 935 nm. For OP550 and OP555 only, a radiometric intensity level that varies less than 10% over the entire lens surface of the phototransistor being tested applies. 4. To calculate typical collector dark current in µA, use the formula ICEO=10 (0.040 TA - 3.4), where TA is ambient temperature in °C. General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. © TT electronics plc OPTEK Technology, Inc. 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www.ttelectronics.com Issue A 08/2016 Page 2 OP550, OP552, OP555, OP560, OP565, OP750 Series Electrical Specifications Absolute Maximum Ratings (TA = 25° C unless otherwise noted) -40o C to +100o C Storage Temperature Range Operating Temperature Range -40o C to +100o C OP550, OP555, OP560, OP565, OP750 -40o C to +85o C OP552 Collector-Emitter Voltage OP550, OP552, OP555, OP560, OP750 30 V OP565 15 V Emitter-Collector Voltage 5V 260° C(1) Lead Soldering Temperature [1/16 inch (1.6 mm) from case for 5 seconds with soldering iron] Power Dissipation OP550, OP552, OP555, OP560, OP565 100 mW(2) OP750 200 mW(2) General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. © TT electronics plc OPTEK Technology, Inc. 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www.ttelectronics.com Issue A 08/2016 Page 3 OP550, OP552, OP555, OP560, OP565, OP750 Series Electrical Specifications Electrical Characteristics (TA = 25° C unless otherwise noted) SYMBOL PARAMETER MIN TYP MAX 2.55 1.30 0.25 0.25 - 4.70 2.40 - OP560A OP565B OP560C 6.6 3.3 1.1 - 9.8 - OP750A OP750B OP750D 2.25 1.50 0.85 - 7.00 4.20 7.00 On-State Collector Current OP550A, OP555A OP550B, OP555B OP550C, OP555C OP550D, OP552D IC(ON) UNITS TEST CONDITIONS VCE = 5.0 V, EE = 1.0 mW/cm2(3) VCE = 2.0 V, EE = 0.1 mW/cm2(3) mA VCE = 5.0 V, EE = 1.0 mW/cm2(3) OP770A IC/∆ T ICEO V(BR)CEO 2.25 - 7.00 Relative IC Charge with Temperature - 1.00 - %/°C Collector-Dark Current - - 100 nA 30 - - 15 - - 5.0 - - - - 0.40 - - 1.10 Collector-Emitter Breakdown Voltage OP550, OP552, OP555, OP750, OP770 OP560, OP565 V(BR)ECO Emitter-Collector Breakdown Voltage VCE(SAT) Collector-Emitter Saturation Voltage OP550, OP552, OP555, OP750, OP770 OP560, OP565 VCE = 5.0 V, EE = 1.0 mW/cm2, λ = 935 nm VCE = 10.0 V, EE = 0(4) IC = 100 µA, EE = 0(4) V IC = 1 mA, EE = 0(4) V IE = 100 µA IC = 100 µA, EE = 1.0 mW/cm2(3) V IC = 0.4 mA, EE = 0.1 mW/cm2(3) See page 2 for Notes General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. © TT electronics plc OPTEK Technology, Inc. 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www.ttelectronics.com Issue A 08/2016 Page 4 OP550, OP552, OP555, OP560, OP565, OP750 Series Performance Switching Test Circuit IF VCC = 5 V VRL 100 RL Adjust IF to obtain OP552 - On-State Collector Current vs Irradiance 100 12 80 10 On-State Collector Current (IC(ON)) (mA) Relative Collector Current (%) OP552 - Angular Response 60 40 20 -45 -30 -15 0 15 30 λ = 935 nm 8 6 4 λ = 880 nm 2 45 0 Angular Displacement (Degrees) General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. © TT electronics plc 0.5 1.0 1.5 2.0 2.5 3.0 3.5 Irradiance (EE) (mW/cm2) OPTEK Technology, Inc. 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www.ttelectronics.com Issue A 08/2016 Page 5 OP550, OP552, OP555, OP560, OP565, OP750 Series Performance OP552 - Rise and Fall Time vs Load Resistance OP552 - Output Vs Frequency 100 250 200 80 RL = 1 K Relative Collector Current (V) RL = 10 K Relative Output (%) VCC = 5 V VRL = 1 V f = 100 Hz PW = 1 ms 60 40 150 tr 100 20 50 1 10 100 1000 0 2K Frequency (KHz) 4K 6K 8K 10 K Load Resistance (Ohms) OP552 - Coupling Characteristic OP552 - Typical Spectral Response 100 100 80 80 Emitter: OP142 IF: 20mA VCE: 5V Relative Response (%) Relative Response (%) tf 60 40 20 60 40 20 600 700 800 900 1000 Wavelength (nm) General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. © TT electronics plc 1100 0 0.2 0.4 0.6 0.8 1.0 Distance (inches) OPTEK Technology, Inc. 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www.ttelectronics.com Issue A 08/2016 Page 6