DATA SHEET GBP200 THRU GBP2010 SEMICONDUCTOR IN-LINE GLASS PASSIVATED SINGLE-PHASE BRIDGE RECTIFIER GBP VOLTAGE - 50 to 1000 Volts CURRENT - 2 .0 Amperes Unit: inch ( mm ) FEATURES • Plastic material has Underwriters Laboratory Flammability Classification 94V-O .581(14.75) .561(14.25) C .111 (2.8) .044(1.10) .031(0.80) • Ideal for printed circuit board .414(10.50) .397(10.10) • Reliable low cost construction utilizing molded plastic .144(3.65) .131(3.35) .577(14.65) .557(14.15) MECHANICAL DATA Terminals: Leads solderable per MIL-STD-202, .057(1.45) .045(1.15) .099(2.5) .082(2.1) technique • Surge overload rating : 60 Amperes peak Method 208 .034(0.86) .026(0.66) Mounting position: Any Weight: 0.06 ounce, 1.7 grams .160(4.06) .140(3.56) .026(0.65) .013(0.35) .160(4.06) .140(3.56) .160(4.06) .140(3.56) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Rating at 25°Cambient temperature unless otherwise specified. Resistive or inductive load, 60Hz. For Capacitive load derate current by 20%. GBP200 GBP201 GBP202 GBP204 Maximum Recurrent Peak Reverse Voltage 50 100 200 400 Maximum RMS Input Voltage 35 70 140 Maximum DC Blocking Voltage 50 100 200 GBP206 UNIT GBP208 GBP2010 600 800 1000 V 280 420 560 700 V 400 600 800 1000 V Maximum Average Rectified Output Current at 50°C Ambient. 2.0 A Peak One Cycle Surge Overload Current 60.0 A Maximum Instantaneous Forward Voltage Drop per Bridge element at 1.5A dc 1.0 V Maximum ( Total Bridge) Reverse Leakage at rated T A=25° CDc Blocking Voltage per element TA=100°C 5.0 500 µA 20.0 A2 S I2t Rating for fusing ( t<8.35ms) Typical junction capacitance per leg (Note 1) 25.0 pF 32.0 13.0 °C / W Operating Temperature Range, TJ -55 to +125 °C Storage Temperature Range,TSTG -55 to +150 °C Typical Thermal Resistance per leg (Note 2) RθJA RθJL NOTES: 1. Measured at 1.0MHZ and applied reverse voltage of 4.0 volts 2. Thermal resistance from junction to ambient and from junction to lead mounted on P.C.B with 0.47 x 0.47"(12 x 12mm)copper pads. http://www.yeashin.com 1 REV.02 20120305 DEVICE CHARACTERISTICS INSTANTANEOUS FORWARD CURRENT, AMPERES GBP200 THRU GBP2010 B RIDGE OUTPUT FULL WAVE RECTIFIED CURRENT AVERES AMPERES 3.0 2.5 2.0 1.5 1.0 0.5 0 0 50 100 150 AMBIENT TEMPERATURE OC Fig. 1- DERATING CURVE FOR OUTPUT RECTIFIED CURRENT 5.0 4.0 3.0 2.0 1.0 .9 .8 .7 .5 .3 .2 .1 .07 .05 .03 .02 .01 0 0.2 0.4 0.6 0.8 1.0 1.2 INSTANTANEOUS FORWARD VOLTAGE, VOLTS Fig. 2- TYPICAL INSTANTANEOUS FORWARD O CHARACTERISITCS (25 C) INSTANTANEOUS REVERSE CURRENT, MICROAMPERES 10 O TA= 100 C 1.0 0.1 TA= 25 O C 0.01 0 20 40 60 80 100 120 140 FPRWARD SURGE CURRENT, AMPERES pk (HALF SINE-WAVE) PERCENT OF PEAK REVERSE VOLTAGE Fig. 3- TYPICAL REAK REVERSE CHARACTERISTICS 70 60 50 40 30 20 10 0 1 2 6 10 20 40 60 100 NO. OF CYCLES AT 60Hz Fig. 4- MAXIMUM NON-REPETITEVE PEAK FORWARD SURGE CURRENT http://www.yeashin.com 1.4 2 REV.02 20120305