EFRG-P657 DC 380V Input 650W with +12V and +5VSB Output High Efficiency > 94% 0~50℃ Working Temperature PMBus 1.2 The Best for Most efficient power distribution architectures in Data Center Input and Output Characteristics: Input Output Volt DC 360V~DC 400V Volt Max. Load Min. Load Ripple & Noise Load Reg. Line Reg. Current 2.0A~2.2A +12V 54A 1A 120mV ±5% ±1% Inrush 70A max @ 380VDC +5VSB 3A 0.1A 50mV ±5% ±1% **The charging current for X capacitors is not considered as in-rush current. Features: Hypothetical approach for distributing 380 VDC Dimension: 300.00x50.50x40.00 mm DC 380V nominal Input Voltage Hot-Swappable Redundancy configuration Slim-type form factor with N+1 Solution Efficiency: ≥94% at typical Load Short Circuit Protection Over Current Protection Over Voltage Protection Over Temperature Protection MTBF >100,000 Hours Operating Temperature: 0 to 50℃ Operating Humidity: 20 to 90 % Multi-display LED indicated Status PMBus 1.2 Support FAN Thermal control High Efficiency Mechanical Outline Drawing DC input Mating Power Cord (Recommeded): LS23/LS24 ST 3C 105 C 600V VW-1 (Reference: Linetek) DC Output mating Connector (Recommended): Molex 45984 Series or Equivalents ©ETASIS Electronic Corporation. All rights reserved. ETASIS Electronics Corporation reserves the right to make changes to their products, specification, or to discontinue any product and its service at anytime without notice. The information and specification from ETASIS is believed to be accurate and reliable. However, ETASIS assumes no responsibility for any business loss due to specification changes. ETASIS products are not designed to be used in system deemed to be critical, or in any system wherein failure or malfunction could result in injury or death.