POWER LPX200 Enclosure Installation Notes LPX200 • Cover Enclosure Kit LPX200 will fit the LPX20X-M and LPS36X-M power supplies. Materials 1 Base 1 Cover 4 M3x6mm Pan head screws with spring washer 4 M3x6mm countersunk screws 1 M4 nut 1 M4 star washer 1 M4 spring washer 1 Plastic insulator sheet OUTPUT CONNECTOR INPUT CONNECTOR INSULATOR GROUND STUD (4X)STANDOFF Installation Instructions and Notes 1 Place the insulator over the chassis as shown. 2 Place the power supply over the insulator as shown. 3 Align the power supply to the chassis standoff. 4 Secure 4 pan head screws with washer provided with in kit as shown. 5 Place the cover over the power supply as shown. 6 Align the cover to the U-bracket countersink holes. 7 Secure 4 countersink screws provided with in kit as shown. 8 Overall dimensions: 5.9” (150mm) x 3.85” (98mm) x 1.85” (46.9mm). 9 Base plate has three sets of customer mountings: a. Bottom mounting (4X) M3 inserts. Max. screw penetration 0.0787 (2mm) plus 2 key ways. (See keyway detail) b. Side mounting (4X) M3 inserts. Max. screw penetration 0.236 (6mm) 10 Ensure insulator is correctly fitted in base under PCB to maintain safety creepage and clearances. 11 Ensure base is firmly connected to supply earth via the earth stud marked 12 When using this enclosure, ensure that relevant safety standards (e.g. EN60950) are complied with, in respect to creepage and clearance distances, and distances through insulation. 13 All dimensions are in inches (mm) LPX200 Data Sheet Mechanical Drawing (2X)M3 INSERT 5.9 [150] 2.56 [65] 3.85 [98] 0.98 [25] 1.18 [30] 0.98 [25] 4.33 [110] (2X)M3 INSERT 1.85 [46.9] 0.59 [15] 0.78 [19.9] 3.54 [90] 1.08 [27.6] 0.36 [9.3] 3.15 [80] 0.35 [9] 3.14 [80] 3.75 [70] 0.55 [14.0] WORLDWIDE OFFICES Americas Europe (UK) Asia (HK) 2900 S.Diablo Way Tempe, AZ 85282 USA +1 888 412 7832 Waterfront Business Park Merry Hill, Dudley West Midlands, DY5 1LX United Kingdom +44 (0) 1384 842 211 14/F, Lu Plaza 2 Wing Yip Street Kwun Tong, Kowloon Hong Kong +852 2176 3333 While every precaution has been taken to ensure accuracy and completeness in this literature, Artesyn Embedded Technologies assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or omissions. Artesyn Embedded Technologies, Artesyn and the Artesyn Embedded Technologies logo are trademarks and service marks of Artesyn Embedded Technologies, Inc. All other names and logos referred to are trade names, trademarks, or registered trademarks of their respective owners. © 2014 Artesyn Embedded Technologies, Inc. www.artesyn.com For more information: www.artesyn.com/power For support: [email protected] LPX200 Rev. 10.15.14