CLG-100 100W Single Output Switching Power Supply series Features : Universal AC input / Full range Protections:Short circuit/Over load/Over voltage/Over temperature Built-in active PFC function IP67 design for indoor or outdoor installations UL1310 Class 2 power unit Cooling by free air convection 100% full load burn-in test High realibility Suitable for LED lighting and moving sign applications 3 years warranty (Note.7) ( for 48V only) SPECIFICATION MODEL CLG-100-12 CLG-100-15 12V CLG-100-24 CLG-100-27 CLG-100-36 CLG-100-48 15V 20V 24V 48V 5A 4.8A 4A 27V 3.55A 36V Note.6 5A 2.65A 2A CURRENT RANGE Note.6 0 ~ 5A 0 ~ 5A 0 ~ 4.8A 0 ~ 4A 0 ~ 3.55A 0 ~ 2.65A 0 ~ 2A RATED POWER Note.6 60W 75W 96W 96W 95.85W 95.4W 96W 150mVp-p 150mVp-p 150mVp-p 150mVp-p 150mVp-p 200mVp-p RIPPLE & NOISE (max.) Note.2 150mVp-p VOLTAGE ADJ. RANGE Fixed. Can be modified between 0% ~ -15% rated output voltage CURRENT ADJ. RANGE Fixed. Can be modified between 3% ~ -25% rated output current VOLTAGE TOLERANCE Note.3 3.0% LINE REGULATION 1.0% LOAD REGULATION 2.0% 3.0% SETUP, RISE TIME 1200ms, 80ms / 230VAC HOLD TIME (Typ.) 60ms / 230VAC VOLTAGE RANGE INPUT IP67 RATED CURRENT DC VOLTAGE OUTPUT CLG-100-20 ( except for 48V ) 3.0% 3.0% 2.0% 2.0% 1200ms, 80ms / 115VAC at full load 30ms / 115VAC at full load Note.5 90 ~ 264VAC FREQUENCY RANGE 47 ~ 63Hz POWER FACTOR PF>0.95/230VAC EFFICIENCY (Typ.) 83% AC CURRENT INRUSH CURRENT(max.) 12V:0.8A/115VAC 0.4A/230VAC COLD START 40A/230VAC LEAKAGE CURRENT 0.5mA / 240VAC OVER CURRENT 3.0% Note.4 PROTECTION OVER VOLTAGE OVER TEMPERATURE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT PF>0.98/115VAC at full load 85% 87% 87% 15V:0.9A/115VAC 87% 0.45A/230VAC 87% 20V ~ 48V:1.1A/115VAC 87% 0.55A/230VAC 95 ~ 100% Protection type : Constant current limiting, recovers automatically after fault condition is removed 13 ~ 16V 16.5 ~ 20V 22 ~ 27V 27 ~ 34V 29 ~ 36V 39 ~ 48V 52 ~ 64V Protection type : Shut down and latch off o/p voltage, re-power on to recover 90 10 (RTH2) Protection type : Shut down o/p voltage, re-power on to recover -30 ~ +70 (Refer to output load derating curve), -40 possible 20 ~ 90% RH non-condensing -40 ~ +80 0.03%/ , 10 ~ 95% RH (0 ~ 50 ) VIBRATION 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes SAFETY STANDARDS UL1310 Class 2, TUV EN60950-1, CAN/CSA C22.2 No. 223-M91(except for 48V),IP67 Approved WITHSTAND VOLTAGE I/P-O/P:4.25KVDC SAFETY & ISOLATION RESISTANCE I/P-O/P:100M Ohms/500VDC EMC EMI CONDUCTION & RADIATION Compliance to EN55022 (CISPR22) Class B OTHERS HARMONIC CURRENT Compliance to EN61000-3-2,-3 EMS IMMUNITY MTBF Compliance to EN61000-4-2,3,4,5,6,8,11; ENV50204, EN55024, Light industry level, criteria A 301Khrs min. MIL-HDBK-217F (25 ) 222*68*39mm (L*W*H) 1.0Kg; 12pcs/13Kg/0.49CUFT DIMENSION PACKING NOTE 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Please refer to OLP characteristics. 5. Derating may be needed under low input voltages. Please check the derating curve for more details. 6. This is the maximum possible output current and power, over load protection may be activated slightly below this level to comply with the requirement of UL1310 class 2. 7. 3 years warranty is guaranteed for operating ambient temperature no higher than 68 . File Name:CLG-100-SPEC 2006-08-30 CLG-100 100W Single Output Switching Power Supply Mechanical Specification Case No. 954A series Unit:mm 222.2 198.2 12 9.4 9.6 34.2 300 20 +V(Red) -V(Black) 68 300 20 L(Brown) N(Blue) FG(Greed/Yellow) 18AWG 2C 9.4 18AWG 3C 38.75 4.2 4PL Fosc : 100KHz Block Diagram EMI FILTER & RECTIFIERS I/P POWER SWITCHING PFC CIRCUIT RECTIFIERS & FILTER +V -V O.L.P. FG O.L.P. DETECTION CIRCUIT PWM & PFC CONTROL PFC CONTROL O.V.P. OLP Characteristics VO (%) 100 50 (max.) 0 50 95 (Vo Io<100VA) IO(%) Derating Curve Static Characteristics fosc : 100KHz 100 100 90 80 80 70 LOAD (%) LOAD (%) 60 40 20 -30 -25 -5 0 15 30 50 AMBIENT TEMPERATURE ( ) 60 70 (HORIZONTAL) 60 50 40 90 100 125 135 145 155 165 175 180 200 230 264 INPUT VOLTAGE (V) 60Hz File Name:CLG-100-SPEC 2006-08-30