Xeon 1 Power Fluorescent Green LED OSG7XNE1C1E VER.C.1 ■Features ■Outline ● Highest Luminous Flux ● Super Energy Efficiency ● Long Lifetime Operation ● Superior ESD protection Dimension Anode(+) 5 .1 1 3.6 2.0 Cathode(-) BackView ■Applications Read lights (car, bus, aircraft) .5 5 ● Portable (flashlight, bicycle) ● Bollards / Security / Garden ● Traffic signaling / Beacons ● In door / Out door Commercial lights ● Automotive Ext .10 14.5 ■Absolute Maximum Rating Item 0 .3 Value Unit DC Forward Current IF 400 mA Pulse Forward Current* IFP 500 mA Reverse Voltage VR 5 V Power Dissipation PD 1600 mW Operating Temperature Topr -30 ~ +85 Storage Temperature Tstg -40~ +100 Lead Soldering Temperature Tsol 260 0 - Duty ratio max 1/10 (Ta=25℃ (Ta=25℃) Item Symbol Condition Min. Typ. Max. Unit DC Forward Voltage VF IF=350mA 3.0 3.3 4.0 V DC Reverse Current IR Φv VR=5V - - 10 µA IF=350mA 90 100 - lm Chromaticity x IF=350mA - 0.35 - - Coordinates* y IF=350mA - 0.50 - - 2θ1/2 IF=350mA - 120 - deg 50% Power Angle ESD Protection Diode Unit:mm Tolerance:±0.30mm 0 ℃ ℃ ℃/5sec ■Electrical -Optical Characteristics Luminous Flux .2 0 Cathode ■Directivity (Ta=25℃) Symbol *Pulse width Max.10ms Anode 5 0 . 1 Note: Don’t drive at rated current more than 5s without heat sink for Xeon 1 emitter series. LED & Application Technologies Relative Spectral Power Distribution ● 5.5 Wavelength(nm) Xeon 1 Power Fluorescent Green LED OSG7XNE1C1E VER.C.1 ■ Soldering Heat Reliability : Reflow soldering Profile · Reflow soldering should not be done more than two times. · When soldering, do not put stress on the LEDs during heating. · After soldering, do not warp the circuit board. · Repairing should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used. It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing. Solder Average ramp-up rate = 3ºC/sec. max. Preheat temperature: 150º~180ºC Preheat time = 120 sec. max. Ramp-down rate = 6ºC/sec. max. Peak temperature = 220ºC max. Time within 3ºC of actual peak temperature = 25 sec. max. Duration above 200ºC is 40 sec. max. LED & Application Technologies