Xeon 5 Power White LED OSXXX2E5D1E VER C.0 ■ Features ● Highest Luminous Flux ● Super Energy Efficiency ● Long Lifetime Operation ● Superior ESD protection ● Superior UV Resistance 1.15 Anode(+) 3.6 2.0 Cathode(-) BackView ■ Applications 5.5 ● Read lights (car, bus, aircraft) ● Portable (flashlight, bicycle) ● Bollards / Security / Garden ● Traffic signaling / Beacons ● In door / Out door Commercial lights ● Cathode 14.5 Unit:mm Tolerance:±0.30mm 1.05 0.2 0.1 5.5 3.0 Anode Automotive Ext ■ Absolute (Ta=25℃) Maximum Rating Item ■Directivity Value Symbol White/ Warm white Unit DC Forward Current IF 1600 mA Pulse Forward Current* IFP 2000 mA Reverse Voltage VR 10 V Power Dissipation PD 6400 mW Operating Temperature Topr -30 ~ +85 ℃ Storage Temperature Tstg -40~ +100 ℃ Lead Soldering Temperature Tsol 260℃/5sec ℃ *Pulse width Max.10ms ■ Electrical 0 0 Duty ratio max 1/10 (Ta=25℃) VF (V) IR(µA) -Optical Characteristics Part Number Color Per Segment or (Dp) Min. Typ. Max. IF=1400mA OSW4X2E5D1E Pure White W4 OSM5X2E5D1E Warm White M5 6.5 6.5 7.0 7.0 Max. CCT (K) Typ 10 8.0 10 2θ1/2 Φv (lm) (deg) Min Typ. Max. Min. Typ. Max. VR=10V 8.0 λD(nm) Luminous Flux IF=1400mA 6500 300 320 - X=0.31 ,Y=0.33 3000 280 300 - X=0.45,Y=0.41 125 Note: Don’t drive at rated current more than 5s without heat sink for Xeon 3 emitter series. LED & Application Technologies http://www.optosupply.com VER A.0 Xeon 5 Power White LED OSXXX2E5D1E VER C.0 ■ Handling of Silicone Lens LEDs Notes for handling of silicone lens LEDs ● Please do not use a force of over 3kgf impact or pressure on the silicone lens, otherwise it will cause a catastrophic failure. ● The LEDs should only be picked up by making contact with the sides of the LED body. ● Avoid touching the silicone lens especially by sharp tools such as Tweezers. ● Avoid leaving fingerprints on the silicone lens. ● Please store the LEDs away from dusty areas or seal the product against dust. ● When populating boards in SMT production, there are basically no restrictions regarding the form of the pick and place nozzle, except that mechanical pressure on the silicone lens must be prevented. ● Please do not mold over the silicone lens with another resin. (epoxy, urethane, etc) LED & Application Technologies http://www.optosupply.com VER A.0