8 Pin SIL 5 Tap TTL Compatible Active Delay Lines TAP DELAYS ±5% or ±2 nS† 1.0 1.5 2.0 2.5 3.0 4.0 5.0 6.0 7.0 8.0 9.0 10.0 12.0 ± 0.5 ± 0.5 ±1 ±1 ±1 ± 1.5 TOTAL DELAYS ±5% or ±2 nS† TAP DELAYS ±5% or ±2 nS† PART NUMBER *4 ± 0.5 *6 ± 0.5 *8 ± 1.0 *10 *12 *16 *20 30 35 40 45 50 60 TOTAL DELAYS ±5% or ±2 nS† 15 20 25 30 35 40 50 60 70 80 90 100 EPA600-4 EPA600-6 EPA600-8 EPA600-10 EPA600-12 EPA600-16 EPA600-20 EPA600-30 EPA600-35 EPA600-40 EPA600-45 EPA600-50 EPA600-60 PART NUMBER 75 100 125 150 175 200 250 300 350 400 450 500 EPA600-75 EPA600-100 EPA600-125 EPA600-150 EPA600-175 EPA600-200 EPA600-250 EPA600-300 EPA600-350 EPA600-400 EPA600-450 EPA600-500 †Whichever is greater. Delay times referenced from input to leading edges at 25°C, 5.0V, with no load. *Delay times referenced from 1st tap 1st tap is the inherent delay: approx. 7 nS DC Electrical Characteristics Parameter Test Conditions VOH VOL VIK IIH Schematic Min Max Unit High-Level Output Voltage Low-Level Output Voltage Input Clamp Voltage High-Level Input Current VCC = min. VIL = max. I OH = max VCC = min. VIH = min. I OL= max VCC = min. II = IIK VCC = max. VIN = 2.7V VCC = max. VIN = 5.25V IIL Low-Level Input Current VCC = max. VIN = 0.5V IOS Short Circuit Output Current VCC = max. VOUT = 0. (One output at a time) I CCH High-Level Supply Current VCC = max. VIN = OPEN I CCL Low-Level Supply Current VCC = max. VIN = 0 TRO Output Rise Time Td ≤ 500 nS (0.75 to 2.4 Volts) NH Fanout High-Level Output VCC = max. VOH = 2.7V NL Fanout Low-Level Output VCC = max. VOL = 0.5V Recommended Operating Conditions VCC VIH VIL IIK IOH IOL PW* d* TA Supply Voltage High-Level Input Voltage Low-Level Input Voltage Input Clamp Current High-Level Output Current Low-Level Output Current Pulse Width of Total Delay Duty Cycle Operating Free-Air Temperature 2.7 -40 0.5 -1.2V 50 1.0 -2 -100 V V V µA mA mA mA 1 3 VCC 4 5 6 8 GROUND Package Dimensions Min Max Unit 4.75 2.0 5.25 V V V mA mA mA % % °C 0.8 -18 -1.0 20 40 0 40 +70 .200 . Max .820 Max. .350 Max. PCA EPA600-4 Date Code .015 Min. .150 Min. Input Pulse Test Conditions @ 25° C VCC DSA600 Pulse Input Voltage Pulse Width % of Total Delay Pulse Rise Time (0.75 - 2.4 Volts) Pulse Repetition Rate @ Td ≤ 200 nS Pulse Repetition Rate @ Td > 200 nS Supply Voltage Unit 3.2 110 2.0 1.0 100 5.0 .010 Typ. .035 .020 Typ. .100 Typ. Volts % nS MHz KHz Volts QAF-CSO1 Rev. B 8/25/94 Rev. A 2/5/96 Unless Otherwise Noted Dimensions in Inches Tolerances: Fractional = ± 1/32 .XX = ± .030 .XXX = ± .010 OUTPUT INPUT 2 115 mA 115 mA 4 nS 20 TTL LOAD 10 TTL LOAD *These two values are inter-dependent. EIN PW TRI PRR 7 ELECTRONICS INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 TEL: (818) 892-0761 FAX: (818) 894-5791