FSP FSP350-60EGN Specification describes a 350 watts power supply. Datasheet

PC PSU
FSP350-60EGN
DESCRIPTION
This specification describes a 350 watts power supply. With
6 output, and remote ON/OFF control for ATX-12V system
and a “Power factor correction (active PFC )” circuit at
100V-240Vac.
APPLICATION
Desktop
W ATTAGE
Wattage:
350W
SAFETY STANDARD APPAOVAL
DIMENSION
Dimension:
140mm(L) x 150mm(W) x
86mm(H)
GENERAL SPECIFICATION
PRODUCT HIGHLIGHT
Efficiency Level:
Erp Lot:
Input Voltage:
80PLUS Gold
<0.5W
100~240Vac
INPUT SPECIFICATION
Input Range:
Input Frequency:
Input Current:
100-240 Vac
47-63 Hz
115V@ < 6.0 Amps - rms
230V@ < 3.0 Amps - rms
Output Rise Time:
ENVIRONMENTAL SPECIFICATION
TEMP.Range:
MTBF:
OUTPUT SPECIFICATION
Hold up Time:
Efficiency:
80PLUS Gold
PWOK Delay Time: 500ms > PWOK > 100ms
EMC Performance: EN55022 class B
EN55024
EN 61000-3-2
EN 61000-3-3
115V/60Hz 17mSec.
Minimum@100% Load,
+3.3V 20mS (maximum)
+5V 20mS (maximum)
+12 V 20mS (maximum)
-12 V 20mS (maximum)
*Output Voltage and C urrent Rating
+3.3V
Ripple-Noise(R-P) mV
50mV
Regulation Load %
±5%
Output Max.(A)
21A
Output Min.(A)
0.1A
+5V
50mV
±5%
15A
0.2A
+12V1
120mV
±5%
16A
0.1A
+12V2
120mV
±5%
16A
0A
Storage Temperature: -40°C to +
70℃
The power supply reliability, when
calculated by “Bellcore” latest
revision are exceed 100,000 hours
with all output at maximum load and
an ambient temperature of 25℃.
-12V
200mV
±10%
0.3A
0A
+5Vsb
50mV
±5%
3A
0A
NOTES
(1) +3.3V & +5V total output not exceed 103W.
When +5V is load to 15A, the +3.3V maximum load is 8.5A.
When +3.3V is load to 21A, the +5V maximum load is 6.7A.
(2) +12V1 & +12V2 total output not exceed 336W(28A).
(3) All outputs shall be safety-isolated from the AC mains and share a common return. This common return must be
connected to supply chassis.
(4) Voltages and ripple are measured at the load side of mating connectors with a 0.1uF monolithic ceramic capacitor
paralleled by a 10uF electrolytic capacitor across the measuring terminals.
This content is subject to change, please refer to specification for m ore detail.
FSP reserve the right to change the content without prior notice
Similar pages