RoHS BR805-810 SINGLE-PHASE BRIDGE RECTIFIER FEATURES Low cost This series is UL recognized under component index, file number E127707 High forward surge current capability Ideal for printed circult board High isolation voltage from case to leads. High temperature soldering guaranteed: 260/10 second, at 5 lbs. (2.3kg) tension. MECHANICAL DATA Case: Molded plastic body Terminal: Lead solderable per MIL - STD - 202E method 208C Polarity: Polarity symbols marked on case. Mounting: Thru hole for #6 screw, 5 in,- lbs. Torqute Max. Weight: 0.20 ounce, 5.62 gram O MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 ambient temperature unless otherwise specified Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load derate current by 20% C E L Maximum Repetitive Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average TC = 50(Note1) Forward Rectified Output TC= 100 (Note1) Current, at TA = 50(Note2) Peak Forward Surge Current 8.3ms single half sine - wave superimposed on rated load (JEDEC method ) Rating for Fusing (t<8.3ms) J E R T E W Maximum Instantaneous Forward Voltage Drop per bridge element at 4.0A Maximum DC Reverse Current at rated TA = 25 DC blocking voltage per element TA Isolation Voltage from case to leads. Typical Thermal Resistance (Note 1) Operating Temperature Range Storage Temperature Range IC C D T ,. L O N KBPC KBPC KBPC KBPC KBPC KBPC KBPC 801 802 804 806 808 810 UNIT SYMBOLS 8005 BR805 BR81 BR82 BR84 BR86 BR88 BR810 VRRM Volts VRMS Volts VDC Volts I(AV) Amps IFSM Amps It As VF Volts A mA VAC /W 2 IR VISO R TJ TSTG 6.0 (-55 to +125) (-55 to +150) 1. Unit mounted on 8.7" X 8.7" X 0.24" thick (22 X 22 X 0.6cm) Al. Plate. 2. Unit mounted on P.C. Borad 0.375" (9.5mm) lead length with 0.47" X 0.47" (12 X 12mm) copper pads. WEJ ELECTRONIC CO. Http:// www.wej.cn E-mail:[email protected] 2 RoHS BR805-810 OUTPUT RECTIFIED CURRENT FORWARD SURGE CURRENT PER ELEMENT 60Hz Resistive or Inductive Load Heat-Sink Mounting. PEAK FORWARD SURGE CURRENT, (A) AVERAGE FORWARD OUTPUT CURRENT,(A) 12 5.5" X 6.0" X 0.11" Cas (14 X 15 X 0.3cm) e Te 8.0 mp era AL.Plate. ture TC 4.0 A Te mb m ien pe t ra tu r P.C.B Mounting. 0.47" X 0.47" (12mm X 12mm) 2.0 e TA Copper Pads 0.375"(9.5mm) Lead Length 150 8.3ms Single Half Sine-Wave Tj =T (JEDEC Method) 100 50 1 Cycle 0 0 75 50 25 125 100 150 175 0 1 2 TEMPERATURE, ( ° C) 4 C 6 8 20 10 j max 40 60 80 100 NUMBER OF CYCLES AT 60 Hz FORWARD CHARACTERISTICS FIG.3-TYPICAL D T ,. L O FIG.2-MAXIMUM NON-REPETITIVE PEAK FIG.1-DERATING CURVE FOR PER BRIDGE ELEMENT IC FIG.4-TYPICAL REVERSE 100 CHARACTERISTICS PER BRIDGE ELEMENT N R T 1.0 0.1 T j=25 ° C C E L Pulse Width=300uS 1% Duty Cycle 0.01 1.0 0.8 0.6 0.4 1.2 1.4 1.6 O 1.0 (uA) (A) 10 INSTANTANEOUS REVERSE CURRENT, INSTANTANEOUS FORWARD CURRENT, 10 1.8 0.1 T j =25 ° C 0.01 0 20 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE,(%) INSTANTANEOUS FORWARD VOLTAGE,(V) E FIG.5-TYPICAL JUNCTION CAPACITANCE PER BRIDGE ELEMENT JUNCTION CAPACITANCE,(pF) 1000 W J E 100 T =25 ° C j f=1MHz V sig =50mV 10 0.1 p-p 1.0 10 100 REVRESE VOLTAGE,(V) WEJ ELECTRONIC CO. Http:// www.wej.cn E-mail:[email protected]