OmniVision OV10625 Blind spot detection Datasheet

OV10625 HD HDR product brief
lead free
available in
a lead-free
package
Industry-Leading Sensitivity and High Dynamic Range
for Next-Generation Automotive Applications
OmniVision's new OV10625 image sensor is a high
performance OmniHDR imaging solution that brings
industry-leading sensitivity and best-in-class high
dynamic range (HDR) to advanced driver assistance
systems (ADAS).
The sensor's benefits enable a host of ADAS features,
including: pedestrian detection, lane-departure warning,
lane keeping assist, blind spot detection, and traffic
signal recognition, among others.
The 1/3.2-inch OV10625 delivers HDR performance of
up to 120 dB combined with best-in-class low-light
sensitivity of 15 V/Lux-sec ensures accurate scene
reproduction in a wide range of driving conditions.
The OV10625 supports digital RAW data output and fits
into one of the industry's most compact and efficient
7.3 x 7.8 mm package.
Find out more at www.ovt.com.
OV10625
Applications
¬ Automotive
- pedestrian detection
- lane-departure warning
- lane keeping assist
- blind spot detection
- traffic signal recognition
Ordering Information
¬ OV10625-N02V-1A-Z
(RCCC, lead-free, 102-pin aCSP™, rev 1A, in tray)
Product Features
¬ support for image size: WVGA, VGA,
QVGA and any cropped size
¬ supported output formats: RAW
¬ horizontal and vertical sub-sampling
¬ high dynamic range
Product Specifications
¬ serial camera control bus (SCCB)
for register programming
¬ high sensitivity
¬ safety features
¬ active array size: 752 x 548
¬ external frame synchronization
capability
¬ low power consumption
¬ power supply:
- core: 1.425 ~ 1.575V
- analog: 3.14 ~ 3.47V
- I/O: 1.7 ~ 3.47V
¬ 50/60 Hz flicker cancellation
¬ image sensor processor functions:
- automatic exposure/gain control
- lens correction
- defective pixel cancelation
- HDR combination and tone mapping
- automatic black level correction
¬ lens size:
- VGA: 1/3.7"
- WVGA: 1/3.2"
¬ parallel 16-bit DVP output
¬ lens chief ray angle: 9°
¬ input clock frequency: 6 ~ 27 MHz
¬ power requirements:
- active: TBD
- standby: TBD
¬ embedded temperature sensor
¬ one time programmable (OTP) memory
¬ maximum image transfer rate:
60 fps full resolution
¬ temperature range:
- operating: -40°C to +105°C
sensor ambient temperature and
-40°C to +125°C junction temperature
(operating sensor junction
temperatures above +60°C
may result in degraded image quality)
¬ dynamic range: ~120 dB
¬ output interfaces:
16-bit parallel DVP
¬ maximum exposure interval: TBD
¬ output formats: up to 20-bit combined
RAW, separated 8-/10-bit RAW
¬ sensitivity: 15 V/lux-sec
¬ scan mode: progressive
¬ shutter: rolling shutter
¬ pixel size: 6 µm x 6 µm
¬ image area: 4608 µm x 3384 µm
¬ package dimensions:
- aCSP: 7310 µm x 7810 µm
Functional Block Diagram
OV10625
+
-
-
10-bit
ADC
ISP
BLC
pixel
array
AEC
AGC
ADRC
control
register bank
temperature sensor
4275 Burton Drive
Santa Clara, CA 95054
USA
Version 1.1, October, 2014
SIOD
SIOC
SCCB
interface
ESO
SCK
ESI
GPIO[1:0]
PCLK
HREF
VSYNC
TM
PWDNB
RESETB
BPREG
FSIN
FLG
Tel: + 1 408 567 3000
Fax: + 1 408 567 3001
www.ovt.com
CS
SPI master
interface
timing generator and system control logic
TMCLK
PLLs
XVCLK
XO
XI
OSC
DVP
AMP
+
output
interface
encoder
row select
column
sample
& hold
image
processor
FIFO
sensor core
OmniVision reserves the right to make changes to their products or to discontinue any product or
service without further notice. OmniVision and the OmniVision logo are registered trademarks of
OmniVision Technologies, Inc. OmniBSI is a trademark of OmniVision Technologies, Inc. All other
trademarks are the property of their respective owners.
D[15:0]
Similar pages