H HiTRON PCB-MOUNT DC-DC CONVERTER ENCAPSULATED MODULES INDUSTRIAL GRADE 10 WATTS SINGLE & DUAL OUTPUT HDM11-S & HDM11-D SERIES FEATURES: VERY LOW PROFILE 7 MM HIGH SINGLE & DUAL OUTPUT WIDE 4:1 INPUT RANGE 10W ISOLATED OUTPUT SIX-SIDED METAL SHIELD SPECIFICATION INPUT SPECIFICATION OUTPUT SPECIFICATION Input Range: Wide 4:1 DC input range. See Ratings Chart. Input Voltage: Nominal 12/24/48Vdc. Input Current: Various with input range and load. See Ratings Chart. Input Fuse: Use external fuse. Input Filter: Pi-Network. Undervoltage Shutdown: 8Vdc. Isolation Resistor: 1,000 Mega Ohms. Isolation Voltage: 1,500Vdc. EMI: Six-sided metal shielding. Remote On/Off: TTL/CMOS-Compatible Input Control. Positive Logic version for Standard set up: ON(Enable)=Open(or 2.5-5.0Vdc above-Vin) OFF(Disable)=Short(or 0-0.8Vdc above-Vin) Negative Logic version option available by adding a “N” suffix to the end of Model #. Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Voltage Accuracy: Main O/P ±2.0% typical. Line Regulation: Various with output voltages ±0.5% typ. Load Regulation: Various with output voltages. Single O/P ±1.0 typical. Dual O/P ±2.0 typical. Noise & Ripple: Typical 100mV for 3.3V/5.0V & 1.0% for others peak to peak. OVP: Built-in on main output. Adjustability: Not available. Overload Protection (OLP): Fully protected against output overload and short circuit. OLP set t about 120-150% of rating output load. Consult the factory for special OLP setting. Remark: Logic voltage refer to –Input(Vin). GENERAL SPECIFICATION Efficiency: 78% typical various with input. Switching Frequency: Fixed frequency 450K Hz. Circuit Topology: 450K Hz. Forward Circuit. Transient Response: Peak deviation 200mV. Recovery time < 3mS for a 25% load change. Case: Black coated aluminum with non-conductive metal base. Power Density: 17.2Watts. / Cubic inch. MTBF: 1,000,000 hours. Mil. Std. 217, 25°C. Operating Temperature: -25°C to +85°C range. –10°C to+70°C @ full load without derating. From+70°C, derating linearly to half load @+85°C. (Refer to Derating Chart). Storage Temperature: -40°C to +105°C. Humidity: Up to 95% RH, Non-condensing. Temperature Coefficient: 0.02% /°C. Cooling: Convection cooling up to 70°C @ full load. At least 100LFM moving air is recommended for full load >+70°C in a confined area. Industrial Grade only. NOTE:(1) All measurements are at nominal input, full load and +25°C unless otherwise specified. (2) Line Regulation measured from High to Low Lines at full load. (3) Load Regulation measured from Full Load (F-L) to Half-Load (H-L) at nominal input. (4) Correct fuse size by calculating the max. DC current drains at low Line input & Load and then adding 20-25% for the desired fuse size. Due to requests in market and advances in technology, specifications subject to change without notice. -21- INPUT/ OUTPUT & VOLTAGE/ CURRENT RATINGS CHART SINGLE OUTPUT MODEL NO. HDM11-12D-S03 HDM11-12D-S05 HDM11-12D-S09 HDM11-12D-S12 HDM11-12D-S15 HDM11-24D-S03 HDM11-24D-S05 HDM11-24D-S09 HDM11-24D-S12 HDM11-24D-S15 HDM11-48D-S03 HDM11-48D-S05 HDM11-48D-S09 HDM11-48D-S12 HDM11-48D-S15 INPUT Vdc 9.0- 36.0 9.0- 36.0 9.0- 36.0 9.0- 36.0 9.0- 36.0 9.0- 36.0 9.0- 36.0 9.0- 36.0 9.0- 36.0 9.0- 36.0 18.0- 72.0 18.0- 72.0 18.0- 72.0 18.0- 72.0 18.0- 72.0 INPUT CURRENT N.L. F.L. (mA) 50 900 50 1070 50 1050 50 1050 50 1050 50 450 50 535 50 525 50 525 50 525 46 220 46 260 46 255 46 255 46 255 OUTPUT★ VO1(Vdc) 3.3V 5.0V 9.0V 12.0V 15.0V 3.3V 5.0V 9.0V 12.0V 15.0V 3.3V 5. 0V 9.0V 12.0V 15.0V INPUT Vdc 9.0- 36.0 9.0- 36.0 9.0- 36.0 9.0- 36.0 9.0- 36.0 9.0- 36.0 9.0- 36.0 9.0- 36.0 18.0- 72.0 18.0- 72.0 18.0- 72.0 18.0- 72.0 INPUT CURRENT N.L. F.L. (mA) 50 910 50 1070 50 1070 50 1040 50 455 50 535 50 535 50 520 46 220 46 260 46 260 46 255 OUTPUT (Vdc) ★ +VO1★ -VO2 ║ +3.3V -3.3V +5.0V -5.0V +12.0V -12.0V +15.0V -15.0V +3.3V -3.3V +5.0V -5.0V +12.0V -12.0V +15.0V -15.0V +3.3V -3.3V +5.0V -5.0V +12.0V -12.0V +15.0V -15.0V OUTPUT VO1(A) 2.50A 2.00A 1.10A 0.83A 0.67A 2.50A 2.00A 1.10A 0.83A 0.67A 2.50A 2.00A 1.10A 0.83A 0.67A CASE SIZE DM1A DM1A DM1A DM1A DM1A DM1A DM1A DM1A DM1A DM1A DM1A DM1A DM1A DM1A DM1A DUAL OUTPUT MODEL NO. HDM11-12D-D03 HDM11-12D-D05 HDM11-12D-D12 HDM11-12D-D15 HDM11-24D-D03 HDM11-24D-D05 HDM11-24D-D12 HDM11-24D-D15 HDM11-48D-D03 HDM11-48D-D05 HDM11-48D-D12 HDM11-48D-D15 Symbols: "★" OVP built-in. OUTPUT (A) +VO1 -VO2 1.25A 1.25A 1.00A 1.00A 0.42A 0.42A 0.33A 0.33A 1.25A 1.25A 1.00A 1.00A 0.42A 0.42A 0.33A 0.33A 1.25A 1.25A 1.00A 1.00A 0.42A 0.42A 0.33A 0.33A CASE SIZE DM1A DM1A DM1A DM1A DM1A DM1A DM1A DM1A DM1A DM1A DM1A DM1A "║" Double Feedback. MECHANICAL DIMENSIONS: MM [INCHES] WEIGHT: 20.0g (0.71 Oz.) PIN ASSIGNMENT PIN NO. PIN# 1. PIN# 2. PIN# 3. PIN# 4. PIN# 5. PIN# 6. SINGLE Remote ON/OFF - INPUT/-Vin + INPUT DC-COM NO PIN VO1 DERATING CHART CASE SIZE: DM1A -22- DUAL Remote ON/OFF - INPUT/-Vin + INPUT - VO2 DC-COM +VO1