AC-DC 165 Watts xppower.com IFC165 Series • Small Size - 3.0” x 5.0” x 1.25” • High Power Density • Active PFC Meets EN61000-3-2, -3 • Single, Dual, Triple & Quad Outputs • High Efficiency - up to 90% • Overvoltage and Overcurrent Protection • Power Fail Detect Specification Input Input Voltage Input Frequency Input Current Inrush Current Power Factor Earth Leakage Current Input Protection General • • • • • • • 90-264 VAC 47-63 Hz 2.2 A max at 100 VAC 33 A at 115 VAC, 66 A at 230 VAC 0.90 minimum 0.75 mA max at 240 VAC Internal 3.15 A fuse Output Voltage Output Voltage Trim Initial Set Accuracy Minimum Load Start Up Delay Start Up Rise Time Hold Up Time Line Regulation Load Regulation Over/Undershoot Transient Response • • • • • • • • • • • Ripple & Noise Overvoltage Protection Overtemperature Protection Overcurrent Protection Short Circuit Protection Temperature Coefficient Remote Sense Current Share • • • See table Not user adjustable ±5% maximum 5 W minimum load required 1.5 s max at 90 VAC 0.2-20 ms 22 ms min See table and note 1 See table and note 2 <10% at turn on/off 5% max. deviation, recovery to within 1% in 500 µs for a 25% load change 1% pk-pk or 50 mV, whichever is greater 113-145% Vnom, recycle input to reset Shuts down at 120˚C, recycle input to reset 150% max, auto recovery (hiccup mode) Trip and restart (hiccup mode) 0.04% / ºC Efficiency Isolation Switching Frequency Power Density Signals Output 1 • • • • Compensates for up to 0.5 V drop • IFC165PSXX models only - up to 4 supplies to share within 10% MTBF • 85% typical • 3000 VAC Input to Output 1500 VAC Input to Ground 500 VAC Output to Ground • 86 kHz typical • 8.8 W/In3 • Power Good - On = Logic High AC OK - On = Logic Low (PS12, PS24 & PS48 only) Green LED for AC OK (PS12, PS24 & PS48 only) • 200 kHrs per Bellcore Environmental Operating Temperature • -25 ºC to +70 ºC, derate linearly from 100% at 50 ºC to 50% at 70 ºC Cooling • 12 CFM airflow required for full power Operating Humidity • 85% RH, non-condensing Storage Temperature • -40 ºC to +85 ºC Operating Altitude • 3000 m Shock • 15 G pk Vibration • 2.4 G, 5 Hz to 500 Hz, 3 axis EMC & Safety Emissions Harmonic Currents Voltage Flicker Radiated Immunity EFT/Burst Surge Dips & Interruptions Safety Approvals • • • • • • • EN55022, level A conducted EN61000-3-2 EN61000-3-3 EN61000-4-3, level 3 Perf Criteria B EN61000-4-4, level 3 Perf Criteria B EN61000-4-5, level 3 Perf Criteria B EN61000-4-11. 30% 10 ms, 60% 100 ms, 100% 5000ms, Criteria A, B, B • EN60950, UL60950, CSA950 per cUL Vnom +5.0 V +12.0 V +24.0 V +48.0 V +5.0 V +3.3 V Output 1 Imax 33.0 A 13.7 A 6.9 A 3.4 A 21.0 A 16.0 A Reg(1) ±3% ±3% ±3% ±3% ±4% ±2% Vnom +12.0 V +12.0 V +12.0 V +12.0 V +12.0 V +5.0 V Output 2 Imax 1.0 A 1.0 A 1.0 A 1.0 A 6.0 A 20.0 A Reg(1) ±5% ±5% ±5% ±5% ±5% ±4% Vnom Output 3 Imax Reg(1) Vnom Output 4 Imax Reg(1) -12.0 V +12.0 V 1.0 A 6.0 A ±5% ±5% -12.0 V 1.0 A ±5% Model Number IFC165PS05 IFC165PS12 IFC165PS24 IFC165PS48 IFC165PT31 IFC165PQ40 Notes 1. 2. 3. 4. Total regulation includes tolerance, line regulation and load regulation. 5 W minimum load on any combination of outputs required to maintain regulation. Maximum output power not to exceed 165 W with 12 CFM forced air or 70 W with convection cooling. For IFC165PT31 and PQ40, the maximum output power of Output 1 and 2 combined is 100W with 12CFM of forced air cooling or 40W with convection cooling. With convection cooling, the -12V output can deliver a maximum output of 0.6A. Mechanical Details PS12/24/48 Models 5.00 (127.0) 4.55 (115.5) 0.16 (4 places) Conn Pin 1 J1 2 3 J2 3.00 (76.2) TOP 2.55 (64.8) Pin 1 J3 Pin 1 J1 Pin 1 J4 Safety ground connection point Pin 1 J2 PT31/PQ40 Models 5.00 (127.0) 4.55 (115.5) 0.16 (4 places) 3.00 (76.2) TOP J2 2.55 (64.8) J3 Pin 1 J1 Pin 1 Safety ground connection point PS05 Model Pin 1 J3 J4 1 2 3 4 5 6 7 8 9 10 11 12 13 14 1 2 3 4 5 6 1 2 PS05 PS12 Neutral Neutral Connector Pinouts PS24 PS48 Neutral Neutral PT31 PQ40 Neutral Neutral Line Line Line Line Line Line +5 VDC +5 VDC +5 VDC RTN RTN RTN +12 V +12 V +12 V RTN RTN RTN +24 V +24 V +24 V RTN RTN RTN +48 V +48 V +48 V RTN RTN RTN -12 V +12 V N/A N/A N/A RTN RTN RTN RTN RTN +5 V +5 V +5 V +5 V -12 V +12 V +3.3 V +3.3 V +3.3 V RTN RTN RTN RTN RTN +5 V +5 V +5 V +5 V N/C AC OK AC OK AC OK PG PG PS OK PG PG PG N/A +3.3 V RS PG CS CS CS -R Sense -R Sense V1 Sense+ +R Sense +R Sense +R Sense 0V Sense- -R Sense -R Sense -R Sense CS RTN RTN RTN +12 V +12 V +12 V +12 V RTN RTN RTN RTN 5.00 (127.0) 4.55 (115.5) 0.16 (4 places) PS05 LED J1 3.00 (76.2) TOP 2.55 (64.8) Pin 1 J2 J2 Molex Mating Connectors PS12, 24, 48 PT31, 40 Housing 09-50-8031 90-50-8033 09-50-8031 Pins 08-52-0113 08-52-0113 08-52-0113 Housing Terminal Block 09-50-8143 09-50-8141 Pins N/A 08-52-0113 08-52-0113 Housing 22-01-3037 22-01-3037 22-01-3037 Pins 08-50-0114 08-50-0114 08-50-0114 Housing 22-01-3027 22-01-3027 N/A Pins 08-50-0114 08-50-0114 N/A Terminal 1 J1 J4 Safety ground connection point Pin 1 J3 J3 Pin 1 J4 Hardware shown for reference only - not included 1.25 31.75) 1.00 (25.4) SIDE END 0.06 (1.52) 0.19 (4.83) The maximum width for the screw head is 0.28 (7.1) #6 or M3 screws recommended. 0.25 inch hex or round stand-offs recommended Notes 1. All dimensions in inches (mm). 2. Weight 0.57 lb (260 g) approx. 27-Jun-05 AC-DC IFC165 Models and Ratings