Emerson Network Power DS1500-3 Distributed power system Datasheet

Embedded Power for
Business-Critical Continuity
Rev. 01.11.06
DS1500-3
1 of 4
DS1500-3
1500 Watts 12V
Distributed Power System
Distributed Power Bulk Front-End
Total Output Power: 1500 Watts
+12vdc Main Output;
+3.3vdc Stand-by Output
Wide Range Input voltage: 90 - 264VAC
180 - 264vac 1500w
90 - 264vac 910W
Electrical Specifications
Special Features
• Active Power Factor Correction
• EN61000-3-2 Harmonic
Compliance
• Active AC Inrush Control
• 2U X 3U Form Factor 7.5" long
• 15W/ in3
• +12vdc Output
• +3.3vdc Stand-By
• Hot Plug Operation
• N + 1 Redundant
• Internal OR'ing Main and Stand-by
• Active Current Sharing
• Internal Cooling Fans
(60mm x 38mm)
• I2C Communication Interface Bus
• EERPOM for FRU Data
• Green LED Status, Power OK
• Amber LED Status, Power Failed
• Internal Fan Speed Control
• Fan Fail Output Signal
• INTEL, SSI Std. Logic Timing
• INTEL, SSI Std. FRU Data Format
• AC shutdown <85VAC or 170VAC
• One Year Warranty
Safety
UL/cUL 60950 (UL Recognized)
1st edition (UL)60950-1-03 CSA
NEMKO+ CB Report EN60950
EN60950
CE Mark
China CCC
CB Test Report
Input
Input range
Frequency
Inrush current
90-264 VAC, 910w
180 - 264 vac, 1500w
47-63 Hz, single phase AC
Efficiency
35A maximum inrush current
>80% typical at full load, high line
Conducted EMI
FCC Subpart J EN55022 Class A
Radiated EMI
FCC Subpart J EN55022 Class A
Power factor
0.99 typical
Leakage current
0.75mA @ 240VAC
Hold up time
12ms minimum
Output
Main DC voltage
+12v @ 74A (90VAC) or 123A (180VAC)
Stand-By
+3.3vsb @ 7A
Adjustment range
Factory Set, no pot adjustments
Regulation
Over current
Under voltage
+12vdc; ±3%; +3.3vsb; ±3%
+12vdc; 110 - 130%
latches off if overcurrent lasts over 1.5 seconds,
otherwise it is auto recovery.
+3.3vsb, 7A - 105% - 130%
+12vdc; 13.7v ±7%
+3.3vsb; 4.0v ±7%
+12vdc; 11.0 - 11.4vdc
Turn-on delay
+12vOutput Rise Time
<3 Second max
5 - <200mS, Monotonic Rise
I Share 12V
15% from 50 - 100% load
Over voltage
Embedded Power for
Business-Critical Continuity
Rev. 01.11.06
DS1500-3
2 of 4
Logic Control
PS_ON
POK
PS FAIL
AC OK
PRESENT
FAN FAIL
PS_KILL
An active low signal that turns on the 12vdc power rail. When this signal
High, or left open, the 12vdc output turn off. The 3.3Vsb output remains on.
Is a power good signal to be pulled low by the power supply to indicate that
all the outputs are within regulation limits of the power supply. (turn-on
delay 100 - 500mS)
In the event of a power supply failure (OVP at any output, UV at any output,
OTP or other electrical failure), this signal shall go to a High state.
High when AC is not OK, Low if AC is OK
Low i f PSU is Present, High if not Present; Pull high in system.
Low if one or both fans have failed
This pin shall quickly turn off the power supply and prevent arching of
the DC output contacts.
Environmental Specifications
Operating temperature:
-10° to 50°C ; 50% power derating at 70°C
Storage temperature:
Altitude, operating 10,000ft.
-40°C to +85°C
Electromagnetic
EN61000-3-2, -3-3
susceptibility / Input transients: EN61000-4-2, 4.3, 4-4, -4-5, 4-11 Level
EN55024:1998
RoHS, RS5
Humidity:
5 to 95% RH, non-condensing
Shock and vibration specificatons complies with Astec Std. Specifications, Q3205
MTBF (Demonstrated)
500K Hrs at full load, 50°C
Anti-smoke Emission
Due to internal overload or internal failures
Fan life:
70,000 hrs @ 40°C
Ordering Information
Output
Nominal Output
Voltage Set Point
Set Point
Tolerance
Total
Regulation
Minimum
Current
Maximum
Current
Output Ripple
P/P
Main (>90VAC)
12.00vdc
±0.2%
±3%
0A
74A
120mV
Main (180VAC)
12.00vdc
±0.2%
±3%
1.0A
123A
120mV
Std-By
3.3vdc
±1%
±3%
0.5A
7.0A
50mV
Embedded Power for
Business-Critical Continuity
Rev. 01.11.06
DS1500-3
3 of 4
AIRFLOW DIRECTION
190.5
7.5"
(162.9)
65.5
2.58"
19.3
AC CABLE
RETAINER
BLACK
3D VIEW
HF GREEN
EMI CLIP
LAIRD 771062031
7.2
0.283"
165.6
6.52"
MODEL LABEL
(2X) EMI CLIP
LAIRD 77-020
71.1
2.80"
143.3
5.65"
(4X) EMI CLIP
LAIRD 77-020
124.45
4.90"
STATUS
LED
INDICATORS
AC INLET 15A C14
TYCO P/N 1-1450330-8 OR
FCI P/N 51939-055
NOTE: Dimensions given in mm and inches.
Power Supply Condition
No AC power to all PSU
No AC power to this PSU only (includes No
output, over voltage, over temperature)
AC present / Standby Output On
Power supply DC outputs ON and OK
Power supply failure (over current)
Power Supply LED's
PWR
FAIL
(green)
(amber)
Off
Off
OFF
On
Blinking
ON
OFF
Off
Off
Blinking
Embedded Power for
Business-Critical Continuity
DC Output Connector Pinout Assignment
Astec Power
Rev. 01.11.06
DS1500-3
4 of 4
5810 Van Allen Way
Carlsbad, CA 92008
USA
Telephone: +1 760 930 4600
Facsimile: +1 760 930 0698
Technical Support: +1 888 41 ASTEC
or +1 407 241 2752
Male connector as viewed from the rear of the supply
P1 - Unit
FCI Power blade FCI p/n
51939-055
P1 - Mate
Mating Connector
(System side)
FCI Power blade
Part number 51915-023
AC Input Connector
EN60320 Type C14
Pin
Signal Name
PB P1
PB P2
PB P3
PB P4
PB P5
PB P6
PB P7
PB P8
A1
A2
A3
A4
A5
A6
A7
B1
B2
B3
B4
B5
B6
B7
C1
C2
C3
C4
C5
C6
C7
D1
D2
D3
D4
D5
D6
D7
+12V
+12V RETURN
(Pre-mate)
+12V
+12V RETURN
(Pre-mate)
+12V
+12V RETURN
(Pre-mate)
+12V
+12V RETURN
(Pre-mate)
+3V3 STAND-BY
+3V3SB RETURN
PS_PRESENT ( Power Supply Seated) - (short pin)
POK (Output Power Ok)
PS FAIL (Failure Signal)
SPARE
SPARE
+3V3 STAND-BY
+3V3SB RETURN
PSON (Power Enable Signal)
PSKILL (Power Supply Fast Shutdown) - (short pin)
SDA (I2C Data Signal
A2 (I2C Address BIT 2 Signal)
FAN FAIL (Fan Fail Signal)
+3V3 STAND-BY
+3V3SB RETURN
AC OK (AC Input Present)
+12V RMT SENSE
+12V RMT SENSE RETURN
A1 (I2C Address BIT 1 Signal)
+3V3 STAND-BY RMT SENSE Return (-)
+3V3 STAND-BY
+3V3SB RETURN
12IS (+12V Current Share)
SPARE
SCL (I2C Clock Signal)
A0 (I2C Address BIT 0 Signal)
+3V3 STAND-BY RMT SENSE (+)
Waterfront Business Park
Merry Hill, Dudley
West Midlands, DY5 1LX
United Kingdom
Telephone: +44 (0) 1384 842 211
Facsimile: +44 (0) 1384 843 355
Units 2111-2116, Level 21
Tower 1, Metroplaza
223, Hing Fong Road
Kwai Fong, New Territories
Hong Kong
Telephone: +852 2437 9662
Facsimile: +852 2402 4426
For global contact, visit:
www.astecpower.com
[email protected]
While every precaution has been taken to ensure
accuracy and completeness in this literature, Astec
Power assumes no responsibility, and disclaims
all liability for damages resulting from use of this
information or for any errors or omissions.
Printed in US A
Emerson Network Power.
The global leader in enabling
business-critical continuity.
AC Power
Connectivity
DC Power
Embedded Power
Inbound Power
Integrated Cabinet Solutions
Outside Plant
Precision Cooling
Site Monitoring and Services
EmersonNetworkPower. com
Emerson Network Power and the Emerson
Network Power logo are trademarks and
service marks of Emerson Electric Co.
©2006 Emerson Electric Co.
Similar pages