RoHS FR101-107 FAST RECOVERY RECTIFIER VOLTAGE RANGE CURRENT FEATURES D T ,. L 50 to 1000 Volts 1.0 Ampere Low cost construction DO-41 .034(0.9) Fast switching for high efficency. DIA. .028(0.7) Low reverse leakage 1.0(25.4) High forward surge current capability MIN High temperature soldering guaranteed: o 260 C/10 seconds/0.375 ＂ (9.5mm)lead length at 5 lbs (2,3kg) tension .205(5.2) .165(4.2) MECHANICAL DATA IC Case: Transfer molded plastic Epoxy: UL94V-0 rate flame retardant C O .107(2.7) DIA .080(2.0) 1.0(25.4) Polarity: Color band denotes cathode end Lead: Plated axial lead ,solderable per MIL-STD-202E method 208C Mounting position: Any Weight: 0.012 ounce,0.33 gram R T O N MIN Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS o Ratings at 25 C ambient temperature unless otherwise specified. Single phase,half wave,60Hz,resistive or inductive load. C E L For capacitive load derate current by 20%. Maximum Repetitive Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage FR 101 FR 102 V RRM 50 100 200 V RMS 35 50 70 140 100 200 SYMBOLS V DC FR 103 FR 104 FR 105 FR 106 FR UNITS 107 400 600 800 1000 280 420 560 700 V olts V olts 400 600 800 1000 V olts Maximum Average Forward Rectified Current E o 0.375”(9.5mm) lead length at T A =75 C I (AV) 1.0 A mp I FSM 30 A mps 1.3 V olts Peak Forward Surge Current J E 8.3ms single half sine-wave superimposed on rated load (JEDEC Method) Maximum Instantaneous Forward Voltage at 1.0A Maximum DC Reverse Current at rated DC blocking voltage W VF o T A =25 C o T A =100 C 5.0 IR Maximum Reverse Recovery Time(NOTE3) o T j=25 C t rr Typical Junction Capacitance(NOTE1) CJ Typical Thermal Resistance(NOTE2) R Operating and Storage Temperature Range A mps 100 150 JA T J ,T STG 250 500 nS pF 15 50 O -65 to +150 NOTES: 1.Measured at 1.0 MHz and applied reverse voltage of 4.0 Volts. 2.Thermal Resistance from Junction to Ambient at 0.375”(9.5mm) lead length,P.C.board mounted. 3.Reverse Recovery Test Conditions:I F =0.5A,I R =1.0A,I rr =0.25A. WEJ ELECTRONIC CO. Http:// www.wej.cn E-mail:[email protected] C/W O C RoHS FIG.2-MAXIMUM NON-REPETITIVE PEAK DERATING CURVE FORWARD SURGE CURRENT Single Phase Half Wave 60Hz 0.4 Resistive or Inductive Load 0.2 0.375 ＂(9.5mm) Lead Length 0 0 25 50 75 100 125 150 8.3ms Single Half Sine-Wave CURRENT,(A) 0.8 0.6 30 PEAK FORWARD SURGE 1.0 (JEDEC Method) T j=Tjmax 20 10 1 Cycle 175 0 o AMBIENT TEMPERATURE,( C) 1 2 FORWARD CHARACTERISTICS IC N R T (A) 1.0 0.8 1.0 O C E L o T j=25 C Pulse Width=300us 1% Duty Cycle 0.6 1.2 1.4 1.6 1.8 8 10 O 20 40 60 80100 10 o Tj=50 C 1.0 o Tj=25 C 0.1 2.0 0 E CHARACTERISTICS (uA) 10 INSTANTANEOUS REVERSE CURRENT, 100 0.01 C 6 FIG.4-TYPICAL REVERSE 20 0.1 4 NUMBER OF CYCLES AT 60 Hz FIG.3-TYPICAL INSTANTANEOUS INSTANTANEOUS FORWARD CURRENT, D T ,. L FIG.1-TYPICAL FORWARD CURRENT 1.2 (A) AVERAGE FORWARD CURRENT, FR101-107 20 INSTANTANEOUS FORWARD VOLTAGE,(V) 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE,(%) FIG.5-TYPICAL JUNCTION CAPACITANCE J E JUNCTION CAPACITANCE,(pF) 100 W 10 1 FIG.6-TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC 50 NONINDUCTIVE Trr (-) (+) D.U.T. 25 Vdc (approx.) 1 NON INDUCTIVE o 1.0 PULSE GENERATIOR (NOTE 2) (+) (-) Tj=25 C f=1MHz Vsig=50mVp-p 0.1 +0.5A 10 NONINDUCTIVE 0 -0.25A OSCILLOSCOPE (NOTE 1) -1.0A 10 100 NOTES: 1.Rise Time=7ns max.Input Impedance= 1 megohm.22pF 2.Rise time=10ns max.Source Impedance= 50 ohms 1cm SET TIME BASE FOR 50/100ns/cm REVRESE VOLTAGE,(V) WEJ ELECTRONIC CO. Http:// www.wej.cn E-mail:[email protected]