EDI8L3265C 64Kx32 SRAM Features T NO 64Kx32 CMOS High Speed Static RAM 64Kx32 bit CMOS Static Random Access Memory Array The EDI8L3265C is a high speed, high performance, four megabit density Static RAM organized as a 64Kx32 bit array. Four Byte Selects, two Chip Enables, Write Control, and Output Enable provide the user with a flexible memory solution. The user may independently enable each of the four bytes, and, with minimal additional peripheral logic, the unit may be configured as a 128Kx16 array. Fully asynchronous circuitry is used, requiring no clocks or refreshing for operation and providing equal access and cycle times for ease of use. The EDI8L3265C, allows 2 megabits of memory to be placed in less than 0.990 square inches of board space. The EDI8L3265C can be upgraded to 128K, 256K or 512Kx32 in the same footprint using the EDI8L32128, EDI8L32256 or the EDI8L32512C. (See page 6 for upgrade paths). Fast Access Times: 12*, 15, 20, and 25ns Individual Byte Selects D DE EN M M CO RE User Configurable Organization with Minimal Additional Logic Master Output Enable and Write Control TTL Compatible Inputs and Outputs Fully Static, No Clocks Surface Mount Package 68 Lead PLCC, No. 99 (JEDEC-M0-47AE) Small Footprint, 0.990 Sq. In. Multiple Ground Pins for Maximum Noise Immunity Single +5V (±5%) Supply Operation * Advance Information Note: Solder Reflow temperatures should not exceed 260°C for 10 seconds. Pin Configurations and Block Diagram Pin Names Address Inputs Chip Enables (one per word) Byte Selects (One per Byte) Master Write Enable Master Output Enable Common Data Input/Output Power (+5V±5%) Ground No Connection R FO AØ-A15 EØ-E1 BSØ-BS3 W G DQØ-DQ31 VCC VSS NC W NE GN SI DE Notes: 1. See page 6 for upgrade paths. March 1997 Rev. 4 ECO #8302 1 White Electronic Designs Corporation (602) 437-1520 www.whiteedc.com EDI8L3265C 64Kx32 SRAM Absolute Maximum Ratings* Recommended DC Operating Conditions Voltage on any pin relative to VSS Operating Temperature TA (Ambient) Commercial Industrial Storage Temperature Power Dissipation Output Current. Junction Temperature, TJ -0.5V to 7.0V Parameter Supply Voltage Supply Voltage Input High Voltage Input Low Voltage 0°C to + 70°C -40°C to +85°C -55°C to +125°C 3.0 Watts 20 mA 175°C Sym Min VCC 4.75 VSS 0 VIH 2.2 VIL -0.3 Typ 5.0 0 --- Max Units 5.25 V 0 V VCC+0.5 V 0.8 V AC Test Conditions Input Pulse Levels Input Rise and Fall Times Input and Output Timing Levels Output Load *Stress greater than those listed under "Absolute Maximum Ratings" may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions greater than those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability. VSS to 3.0V 5ns 1.5V Figure 1 (note: For TEHQZ,TGHQZ and TWLQZ, CL = 5pF) DC Electrical Characteristics Parameter Sym Conditions Operating Power Supply Current Standby (TTL) Supply Current Full Standby Supply Current CMOS Input Leakage Current Output Leakage Current Output High Volltage Output Low Voltage ICC1 ILI ILO VOH VOL W= VIL, II/O = 0mA, Min Cycle E ³ VIH, VIN £ VIL or VIN ³ VIH, f=ØMHz E ³ VCC-0.2V VIN ³ VCC-0.2V or VIN £ 0.2V VIN = 0V to VCC V I/O = 0V to VCC IOH = -4.0mA IOL = 8.0mA Output High Z High Z High Z Dout Din Power ICC2,ICC3 ICC1 ICC1 ICC1 ICC1 ICC2 ICC3 Min 2.4 Max 12ns* 15ns 20/25ns 500 460 420 Unit ns mA 60 60 60 mA 20 20 20 mA ±10 ±10 ±10 ±10 ±10 ±10 0.4 0.4 0.4 µA µA V V *Typical: TA = 25°C, VCC = 5.0V *Advanced Information Capacitance Truth Table E H L L L L W X H X H L G BSØ-3 Mode X X Standby H X Output Disable X H Output Disable L L Read X L Write (f=1.0MHz, VIN=VCC or VSS) Parameter Address Lines Data Lines Write & Output Enable Lines Chip Enable Lines X Means Don't Care Sym CA CD/Q W, G Max 20 10 16 E, BS 9 These parameters are sampled, not 100% tested. White Electronic Designs Corporation (602) 437-1520 www.whiteedc.com 2 Unit pF pF pF bF pF EDI8L3265C 64Kx32 SRAM AC Characteristics Read Cycle Parameter Read Cycle Time Address Access Time Chip Enable Access Time Byte Select Access Time Chip Enable to Output in Low Z (1) Byte Select to Output in Low Z Chip Disable to Output in High Z (1) Byte Select to Output in High Z Output Hold from Address Change Output Enable to Output Valid Output Enable to Output in Low Z (1) Output Disable to Output in High Z(1) Symbol 12ns* JEDEC Alt. Min Max TAVAV TRC 12 TAVQV TAA 12 TELQV TACS 12 TBLQV TBA 12 TELQX TCLZ 3 TBLQX TBLZ 3 TEHQZ TCHZ 7 TBHQZ TBHZ 7 TAVQX TOH 3 TGLQV TOE 5 TGLQX TOLZ 2 TGHQZ TOHZ 4 15ns Min Max 15 15 15 15 3 3 8 8 3 6 2 5 20ns Min Max 20 20 20 20 3 3 10 10 3 8 2 8 25ns Min Max 25 25 25 25 3 3 10 10 3 10 0 10 Units ns ns ns ns ns ns ns ns ns ns ns ns Note 1: Parameter guaranteed, but not tested. * Advanced Information Read Cycle 1 - W High, G, E Low Read Cycle 2 - W High 3 White Electronic Designs Corporation (602) 437-1520 www.whiteedc.com EDI8L3265C 64Kx32 SRAM AC Characteristics Write Cycle Symbol 12ns* 15ns 20ns JEDEC Alt. Min Max Min Max Min Max TAVAV TWC 12 15 20 TELWH TCW 8 9 15 TELEH TCW 8 9 15 Byte Select to end of Write TBLWH TBW 8 9 15 Address Setup Time TAVWL TAS 0 0 0 TAVEL TAS 0 0 0 Address Valid to End of Write TAVWH TAW 9 10 15 TAVEH TAW 9 10 15 Write Pulse Width TWLWH TWP 9 10 15 TWLEH TWP 9 10 15 Write Recovery Time TWHAX TWR 0 0 0 TEHAX TWR 0 0 0 Data Hold Time TWHDX TDH 0 0 0 TEHDX TDH 0 0 0 Write to Output in High Z (1) TWLQZ TWHZ 0 5 0 6 0 7 Data to Write Time TDVWH TDW 5 6 8 TDVEH TDW 5 6 8 Output Active from End of Write (1) TWHQX TWLZ 2 2 2 Parameter Write Cycle Time Chip Enable to End of Write Note 1: Parameter guaranteed, but not tested. * Advanced Information Write Cycle 1 - W Controlled White Electronic Designs Corporation (602) 437-1520 www.whiteedc.com 4 25ns Min Max Units 25 ns 20 ns 20 ns 20 ns 0 ns 0 ns 15 ns 15 ns 15 ns 15 ns 0 ns 0 ns 0 ns 0 ns 0 10 ns 12 ns 12 ns 2 ns EDI8L3265C 64Kx32 SRAM Write Cycle 2 - E Controlled T NO BSx, D DE EN M M CO RE Ordering Information Industrial (-40°C to +85°C) Commercial (0°C to 70°C) Part Number EDI8L3265C12AC* EDI8L3265C15AC EDI8L3265C20AC EDI8L3265C25AC Speed (ns) 12 15 20 25 Package No. 99 99 99 99 Part Number EDI8L3265C15AI EDI8L3265C20AI EDI8L3265C25AI Speed (ns) 15 20 25 Package No. 99 99 99 *Advanced Information Package Description R FO Package No. 99 68 Lead PLCC JEDEC M0-47AE W NE GN SI DE 5 White Electronic Designs Corporation (602) 437-1520 www.whiteedc.com EDI8L3265C 64Kx32 SRAM EDI MCM-L Upgrade Path White Electronic Designs Corporation (602) 437-1520 www.whiteedc.com 6