ILPA120JU SERIES 120W Water-Proof Constant Current LED Driver – – – – – – – 3 Year Warranty Wide Input Voltage 90 to 305VAC, 47 to 63Hz Constant Output Current Available From 350mA To 4200mA Over Voltage, Short Circuit, Lighting, and Over Temperature Protection High Efficiency (up to 92%) Active Power Factor Correction (PFC) (99% typical) IP67 Waterproof Rating, Metal Housing Comply with UL8750 (Class 2) & EN61347 Safety Regulation Approvals: Single Output Part Number ILPA120JU-S490ST ILPA120JU-S420ST ILPA120JU-S350ST ILPA120JU-S315ST ILPA120JU-S280ST ILPA120JU-S245ST ILPA120JU-S210ST ILPA120JU-S175ST ILPA120JU-S140ST ILPA120JU-S105ST ILPA120JU-S070ST ILPA120JU-S045ST ILPA120JU-S035ST Output Current Range (Min. / Typ. / Max.) 4655 / 4900 / 5145 mA 3990 / 4200 / 4410 mA 3325 / 3500 / 3675 mA 2992 / 3150 / 3307 mA 2660 / 2800 / 2940 mA 2327 / 2450 / 2572 mA 1995 / 2100 / 2205 mA 1662 / 1750 / 1837 mA 1330 / 1400 / 1470 mA 997 / 1050 / 1102 mA 665 / 700 / 735 mA 427 / 450 / 473 mA 332 / 350 / 368 mA Output Voltage Range (Min. / Max.) 14 / 24 VDC 17 / 28 VDC 20 / 34 VDC 23 / 38 VDC 26 / 43 VDC 29 / 49 VDC 34 / 57 VDC 41 / 68 VDC 52 / 86 VDC 68 / 114 VDC 103 / 171 VDC 160 / 266 VDC 206 / 343 VDC Efficiency (220VAC, Full Load) 90.5% 90.5% 90.5% 90.5% 91% 91% 91% 91% 91% 91% 92% 92% 92% Over Voltage Protection (Min. / Typ. / Max.) 28 / 31 / 34 VDC 33 / 36 / 40 VDC 40 / 44 / 48 VDC 45 / 49 / 54 VDC 51 / 56 / 61 VDC 58 / 64 / 69 VDC 68 / 74 / 80 VDC 81 / 88 / 96 VDC 103 / 112 / 121 VDC 136 / 148 / 160 VDC 205 / 222 / 240 VDC 319 / 346 / 374 VDC 411 / 446 / 480 VDC Max. Output Power 120W 120W 120W 120W 120W 120W 120W 120W 120W 120W 120W 120W 120W Electrical Characteristics Parameter Input Voltage Input Frequency Output Power Range Input Current (Low Line) Input Current (High Line) High Line Inrush Current Power Factor Correction Efficiency Line Regulation Load Regulation Over Voltage Protection Over Temperature Protection Short Circuit Protection Output Overshoot / Undershoot Start Up Time Ripple & Noise (Peak to Peak) Test Conditions Operating Voltage Max. Unit 305 VAC 63 Hz Vin=90 to 305VAC 120 W Io=Full load, Vin=115VAC 1.30 A Io=Full load, Vin=230VAC 0.60 A Io=Full load, 25°C, Cool start, Vin=230VAC 65 A Vin=110VAC 96 99 % Io=Full Load, Vin=220VAC 88 92 % Io=Full Load 1 % Vin=230VAC 5 % Latch mode. The power unit shall return to normal operation only after the power is turn-on again. (Please refer to output table.) 110 °C No damage shall occur when any output operating in a short circuit condition. The power supply shall be self-recovery when the fault condition is removed. When power on or off 10 % Io=Full Load, Vin=100VAC 0.6 1 S Measured by 20 MHz bandwidth oscilloscope and the output paralleled a 0.1 uF ceramic capacitor and a 10 uF electrolytic capacitor. Min. 90 47 0 Typ. 5 % Vo Conditions Parameter Test Conditions Min. Operating Temperature Humidity: 10% RH to 100% RH Storage Temperature Humidity: 5% RH to 100% RH MTBF: Operation temperature at 25°C, calculated per MIL-HDBK-217F Life Time at 25°C ambient temperature -35 -40 0.46M 0.08M Typ. Max. Unit 70 85 °C °C Hours Hours Approvals and Compliance Parameter EMI EMS Safety UL/c-UL, CE Waterproof Standards EN55015 EN61000-3-2, EN61000-3-3, EN61000-4-2, EN61000-4-3, , EN61000-4-4, , EN61000-4-5, EN61000-4-6, EN61000-4-8, EN61000-4-11, EN61547 UL8750 Compliant to UL1310 ClaST 2, UL1012, UL935, CSA-C22.2 No. 0, CSA-C22.2 No. 107.1, CSA-C22.2 No.250.0, EN61347-1,EN61347-2-13 IP67 Rating Mechanical Parameter Specification Dimension, 194x67.5x37mm (7.64x2.66x1.46 inches) Net Weight 1000g approx.