UNISONIC TECHNOLOGIES CO., LTD FC8779 Preliminary CMOS IC SILICON MONOLITHIC INTEGRATDE CIRCUIT DESCRIPTION Single-Phase Full-Wave Motor Driver for Fan Motor. FEATURES * Soft switched drive * Built-in Lock Protection and Auto Restart Function * FG Output * Include Hall Bias Circuit * Thermal shut-down circuit ORDERING INFORMATION Ordering Number Lead Free Halogen Free FC8779L-SM1-R FC8779G-SM1-R www.unisonic.com.tw Copyright © 2013 Unisonic Technologies Co., Ltd Package Packing MSOP-8 Tape Reel 1 of 4 QW-R502-981.a FC8779 CMOS IC PIN CONFIGURATION OUT2 1 8 GND H+ 2 7 OUT1 HB 3 6 VCC H- 4 5 FG FC8779 PIN DESCRIPTION PIN NO 1 2 3 4 5 6 7 8 Preliminary PIN NAME OUT2 H+ HB HFG VCC OUT1 GND DESCRIPTION H-bridge output connection. Hall Input+ Hall Bias Hall InputFG signal output terminal Supply Voltage H-bridge output connection. Power GND. BLOCK DIAGRAM 150kΩ VCC 500Ω OSC OUT2 + GND Lock Detection Control TSD H+ + H- - HB OUT1 500Ω Hall Bias 150kΩ FG + UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 2 of 4 QW-R502-981.a FC8779 Preliminary CMOS IC ABSOLUTE MAXIMUM RATING PARAMETER SYMBOL RATINGS UNIT Supply Voltage VCC 7 V Power Dissipation (Note 2) PD 585 mW Output Current (Note 3) IOMAX 1000 mA FG Signal Output IFG 5 mA FG Signal Output Voltage VFG 7 V Operating Temperature TOPR -40~+105 °C Storage Temperature TSTG -55~+150 °C Junction Temperature TJMAX 150 °C Notes: 1. Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. 2. To use at temperature above TA=25°C reduce 4.68mW/°C (On 70.00mm×1.6mm glass epoxy board). 3. This value is mot to be over Pd, VCC=4.0V~6.0V At VCC=2.2V~4.0V, output current tolerance reduces. OPERATING CONDITIONS PARAMETER SYMBOL RATINGS Operating Supply Voltage Range VCC 2.2~6.0 Hall Input Voltage Range VH 0.4~VCC-1.1 Notes: 1. This product is not designed for production against radioactive rays. 2. This document may be strategic data subject to COCOM regulations. UNIT V V ELECTRICAL CHARACTERISTICS (Unless otherwise specified TA=25°C, VCC=5V) PARAMETER Supply Current Input Offset Voltage Output Voltage Input-Output Gain FG Low Voltage Input Hysteresis Voltage Lock detection ON Time Lock Detection OFF Time Hall Bias Voltage SYMBOL ICC VHOFS VO GIO VFGL VHYS TON TOFF VHB TEST CONDITIONS IO=250mA upper and lower total TYP 5 45 0.32 48 ±5 0.35 3.5 1.1 ±10 0.50 5.0 1.3 IFG=3mA IHB=-5mA UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw MIN MAX 8 ±6 0.49 51 0.3 ±15 0.65 6.5 1.5 UNIT mA mV V dB V mV sec sec V 3 of 4 QW-R502-981.a FC8779 Preliminary CMOS IC TYPICAL APPLICATION CIRCUIT UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 4 of 4 QW-R502-981.a