H HiTRON ON-BOARD DC-DC CONVERTER HALF-BRICK BASE PLATE POWER MODULES INDUSTRIAL GRADE 100-150 WATTS SINGLE & DUAL OUTPUT HDH100-24B OR 48B-S & D SERIES FEATURES: SINGLE & DAUL OUTPUT WIDE 2:1 INPUT RANGE 1500VDC ISOLATION STANDARD HALF-BRICK PACKAGE HIGH-EFFICIENCY POWER MODULE UNDER-VOLTAGE LOCKOUT DESIGNED TO MEET INTERNATIONAL SAFETY STANDARDS SPECIFICATION INPUT SPECIFICATION OUTPUT SPECIFICATION Input Range: Wide 2:1 Input DC Range 18-36Vdc. or 36-72Vdc Input Voltage: Nominal 24Vdc.or 48Vdc. Input Current: Typical 6.85A full load and 0.06A no-load @ 24Vdc nominal input. Typical 2.65A full load and 0.03A no-load @ 48Vdc nominal input. Input Fuse: Use external fuse. Inrush Current: 8A @ 24Vdc/4A @ 48Vdc Input Filter: Pi-Network for EMI suppression. Under-Voltage Protection (UVP): Lock-out activated at 17.8 Vdc input @ 24Vdc nominal input. 34-35.5Vdc@ 48Vdc nominal input Input Reflected Ripple Current: 28.4mA pk-pk @24 Vdc. Isolation Voltage: 1,500Vdc input-output. Remote On/Off: TTL/CMOS-Compatible input control. Positive Logic version for Standard set up: ON(Enable)=Open(or 2.5-5.0Vdc above-Vin) OFF(Disable)=Short(or 0-0.8Vdc above-Vin) Negative Logic version option available by adding a “N” suffix to the end of Model #. Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Output Wattage: 100-150W typical continuous. Line Regulation: Various with input & output voltages. ± 0.1% typical. Load Regulation: Various with output voltages. Single O/P: ±1.0% typical. Dual O/P: ±1.0% typical. Noise & Ripple: Typical 120mV, peak to peak. 1% rms. OVP: Built-in. Adjustability: Maybe external trimmed with fixed resistor or trimpot. Overload Protection (OLP): Fully protected against overload and short circuit. OLP set at typical 130% max. load. Remark :Logic input voltage reference to -Vin. Consult the factory for special OLP setting. GENERAL SPECIFICATION Efficiency: 83.8-87% typical, various with input. Switching Frequency: Fixed frequency 330K Hz. Circuit Topology: Forward Circuit. Transient Response: Peak deviation <220mV and recovers within 1mS after 25% load-change. Safety Standard: IEC60950 Class I. Case: Aluminum base plate with metal standoffs. Power Density: 36.0 Watts / Cubic inch. Industrial Grade. Operating Temperature: -40 to +100°C (base plate). Power derating details; please refer to the Derating Chart. Storage Temperature: -55 to +125 °C. Temperature Coefficient: ± 0.02%/°C. Humidity: Up to 95% RH, Non-Condensing. Cooling: At least 100LFM moving air is recommended for full load > 0°C in a confined area. Air flow vs. power derating details please refer to the Derating Chart. NOTE: (1) All measurements are at nominal input, full load, and +25°C unless otherwise spec. (2) Line Regulation measured from High to Low Lines at full load. (3) Load Regulation measured from Full-Load (F-L) to Half-Load(H-L)at nominal input. (4) Correct fuse size by calculating the max. DC current drain at low Line input & adding 20-25% for desired fuse size. Due to requests in market and advances in technology, specifications subject to change without notice. -37- INPUT/OUTPUT & VOLTAGE/CURRENT RATINGS CHART SINGLE OUTPUT INPUT Vdc Range Nominal MODEL NO. HDH100-24B-S018300 HDH100-24B-S025300 HDH100-24B-S033300 HDH100-24B-S050250 HDH100-24B-S120120 HDH100-24B-S150100 HDH100-48B-S018300 HDH100-48B-S025300 HDH100-48B-S033300 HDH100-48B-S050250 HDH100-48B-S120120 HDH100-48B-S150100 18-36Vdc 18-36Vdc 18-36Vdc 18-36Vdc 18-36Vdc 18-36Vdc 36-72Vdc 36-72Vdc 36-72Vdc 36-72Vdc 36-72Vdc 36-72Vdc OUTPUT VO1 ★@ # MIN. TYP. VOLT. 24Vdc 24Vdc 24Vdc 24Vdc 24Vdc 24Vdc 48Vdc 48Vdc 48Vdc 48Vdc 48Vdc 48Vdc 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 1.8Vdc 2.5Vdc 3.3Vdc 5.0Vdc 12.0Vdc 15.0Vdc 1.8Vdc 2.5Vdc 3.3Vdc 5.0Vdc 12.0Vdc 15.0Vdc 30A 30A 30A 25A 12A 10A 30A 30A 30A 25A 12A 10A DUAL OUTPUT INPUT Vdc Range Nominal MODEL NO. HDH100-24B-D025B HDH100-24B-D033B HDH100-24B-D033C HDH100-24B-D050C HDH100-24B-D050D HDH100-48B-D025B HDH100-48B-D033B HDH100-48B-D033C HDH100-48B-D050C HDH100-48B-D050D 18-36Vdc 18-36Vdc 18-36Vdc 18-36Vdc 18-36Vdc 36-72Vdc 36-72Vdc 36-72Vdc 36-72Vdc 36-72Vdc 24Vdc 24Vdc 24Vdc 24Vdc 24Vdc 48Vdc 48Vdc 48Vdc 48Vdc 48Vdc MIN. 2.0A 2.0A 2.0A 2.0A 2.0A 2.0A 2.0A 2.0A 2.0A 2.0A OUTPUT VO1 ★@ TYP. VOLT. MAX. 18A 17A 17A 14A 14A 18A 17A 17A 14A 14A 2.5Vdc 3.3Vdc 3.3Vdc 5.0Vdc 5.0Vdc 2.5Vdc 3.3Vdc 3.3Vdc 5.0Vdc 5.0Vdc 25A 24A 24A 20A 20A 25A 24A 24A 20A 20A MIN. 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A OUTPUT VO2 ★@ TYP. VOLT. MAX. 18A 18A 15A 15A 12A 18A 18A 15A 15A 12A 1.8Vdc 1.8Vdc 2.5Vdc 2.5Vdc 3.3Vdc 1.8Vdc 1.8Vdc 2.5Vdc 2.5Vdc 3.3Vdc 25A 25A 20A 20A 18A 25A 25A 20A 20A 18A Symbols: "★" OVP built-in. "#" Remote sensing. "@" Adjustable. Remarks: Peak output, less than 60Sec. With duty cycle <10%. MECHANICAL DIMENSIONS: MM [INCHES] SINGLE O/P PIN ASSIGNMENT PIN NO. SINGLE +Vin PIN# 1. Remote PIN# 2. ON/OFF CASE PIN# 3. -Vin PIN# 4. PIN# 5. DC COM. PIN# 6. -SENSE PIN# 7. VO1 ADJ. PIN# 8. +SENSE VO1 PIN# 9. PIN# 10. ------- WEIGHT: 73.0g (2.6 Oz.) DUAL O/P DERATING CHART DUAL +Vin Remote ON/OFF CASE -Vin VO2 DC COM VO2 ADJ. VO1 DC COM VO1 ADJ. -38-