APPLIED POWER CONVERSION Division of TECHNOLOGY DYNAMICS INC. NTDM-HS SERIES 1500W-6000W N+1 REDUNDANT HOT SWAP POWER SYSTEMS 5.25” x 19” x 17.75” APPLICATIONS The NTDM-4HS Series of Hot Swap Rack Power Supply systems offer (N+1) redundant or high power paralleled outputs of 2 modules per enclosure. This series is especially suitable for critical telecom and wireless systems or where bulk power is required. Modules may be removed while system is active for ease of replacement resulting in no down time. STANDARD FEATURES • MTBF > 150.000 Hours • LED Indicators (Each Module): Output Power Good; Input Power Good • Tightly Regulated • Equipped with Isolation Diodes for Redundancy/Parallel Operation • Circuit Breaker Input • OV/OL/OT Protection Main Output • Floating Connectors for Hot Swap Insertion • Remote Sensing Post Isolation Diodes • Sturdy Fold Down Handle AVAILABLE OPTIONS • Power Factor Correction • Militarized Version: MIL-STD-810 • Low Voltage Battery Disconnect (LVBD) for Battery Back-Up Operation • Terminal Block Input • 3 Phase Input • 400 Hz Operation • Circular Connector Type MS-3102 • Militarized Version: MIL-STD-461 SPECIFICATIONS A ELECTRICAL: Input: (1500W) Module 85-132 - 175-265VAC, 47-63 Hz (2000-3000W) Module 220VAC 1Phase or 115/208 3Phase Regulation: Line ± .3% Load ± 2% Ripple: 1% Peak to Peak, Not to Exceed 200mV Efficiency: 80% Typical Hold Up Time: 20ms Min. In Rush Current: 60A max ½ Cycle/Module Protections: OV,OL & OT MECHANICAL & ENVIRONMENTAL Operational Temperature: 0˚C to + 50˚C Standard -40˚C to + 60˚C Optional Storage Temperature: 0˚C to + 85˚C Cooling: Internal DC Fan Weight: Modules (15 lbs) Each, Rack (24.5 lbs) Size: 5.25”(H) x 19” Std. Rack (W) x 17.75” (L) AS 9100 Design Excellence since 1976! Certificate No: US008267-1 MODEL SELECTION 1500 WATT MODULES 2000 WATT MODULES Max. Volts/Amps Per Module System Model 2 Modules 3000 WATT MODULES 2500 WATT MODULES Max. Volts/Amps Per Module System Model 2 Modules Max. Volts/Amps Per Module 12V@125A NTDM-HS-12-250 15V@100A NTDM-HS-15-200 24V@62A NTDM-HS-24-124 24V@83A NTDM-HS-24-166 24V@104A NTDM-HS-24-208 24V@125A NTDM-HS-24-250 28V@54A NTDM-HS-28-108 28V@71A NTDM-HS-28-142 28V@89A NTDM-HS-28-178 28V@107A NTDM-HS-28-208 48V@31A NTDM-HS-48-62 48V@41A NTDM-HS-48-82 48V@52A NTDM-HS-48-102 48V@62A NTDM-HS-48-124 110@14A NTDM-HS-110-28 110V@18A NTDM-HS-110-36 110V@22A NTDM-HS-110-44 110V@27A NTDM-HS-110-54 Max. Volts/Amps Per Module CONSULT FACTORY CONSULT FACTORY 3000W PARALLEL/1500 REDUNDANT System Model 2 Modules 4000W PARALLEL/2000 REDUNDANT System Model 2 Modules CONSULT FACTORY 6000W PARALLEL/3000 REDUNDANT 5000W PARALLEL/2500 REDUNDANT Note: Model information assumes a fully populated rack (2 modules). SFX. Options Designations -TBC Terminal Block Covers -MIL Ruggedized/Militarized -LVBD Battery Back-Up -PFC Power Factor Correction -3PH 3 Phase Input -4HZ 400 Hz Operation -EMI Additional EMI Filtering -MTR Meter (Volt/Amp) on Each Module Low Voltage Battery Disconnect The LVBD module adds a new dimension to battery backup power supplies. The power supply simultaneously charges the battery and powers the load. If the AC power fails, the battery continues to support the load. However, when the battery voltage drops below a predetermined level, the LVBD module disconnects the battery from the load, thereby protecting the battery from the damaging effects of complete discharge. MECHANICAL OUTLINE J1 INPUT CONNECTOR ITT CONNECTOR P/N MS3102R24-10P LOGIC CONNECTOR DAM-15S 427.74mm/16.84" 133.10mm 5.24" E1 J2 LOGIC E2 94.84mm 4.847" OUTPUT 31.24mm 1.23" J1 INPUT 37.69mm 1.926" 87.63mm 3.45" 41.91mm 1.65" 217.42mm/8.56" 331.22mm/13.04" REAR VIEW NAMEPLATE POSITIVE OUTPUT 1/4-20 STUD X 1.75 LG NEGATIVE OUTPUT 1/4/-20 STUD X 1.75 LG TOP VIEW CIRCUIT BREAKERS AIR CIRCUIT BREAKER MODULE #1 TECHNOLOGY DYNAMICS INC. 100 SCHOOL ST. BERGENFIELD, NJ 07621 USA AIR AIR INLET MODULE #2 TECHNOLOGY DYNAMICS INC. 100 SCHOOL ST. BERGENFIELD, NJ 07621 USA AIR FLOW 133.10mm 5.24" CHASSIS SLIDE CENTER LINE INPUT GOOD 44.07mm 2.252" OUTPUT GOOD INPUT GOOD ADJUSTMENTS O.L. ADJ VOLT ADJ OUTPUT GOOD ADJUSTMENTS O.L. ADJ O.V. ADJ VOLT ADJ O.V. ADJ 482.60mm/19.00" 450.85mm/17.75" FRONT VIEW SIDE VIEW ADJUSTMENTS CHASSIS SLIDE(BOTH SIDES) Rev. A SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE TECHNOLOGY DYNAMICS INC. 100 School Street, Bergenfield, NJ 07621 Phone: (201) 385-0500, Fax: (201) 385-0702 www.technologydynamicsinc.com