NOT RECOMMENDED FOR NEW DESIGNS
USE GBL4005-BPC01~GBL410-BPC01 Series
MCC
GBL4005
THRU
GBL410
omponents
20736 Marilla Street Chatsworth
!"#
$ % !"#
R
Micro Commercial Components
Features
4.0 Amp
Glass Passivated
Single-Phase
Rectifiers
50 to 1000 Volts
Marking : type number
x
•
•
•
•
•
•
High case dielectric strength
Glass passivated chip junction
High surge current capability
Epoxy meets UL 94 V-0 flammability rating
Moisture Sensitivity Level 1
Lead Free Finish/RoHS Compliant (NOTE 3)("P" Suffix
designates RoHS Compliant. See ordering information)
Halogen free available upon request by adding suffix "-HF"
•
Maximum Ratings
•
•
•
O
O
Operating Temperature: -55 C to +150 C
Storage Temperature: -55OC to +150OC
UL Recognized File # E165989
Maximum
MCC
Recurrent
Maximum
Part Number Peak Reverse RMS Voltage
Voltage
GBL4005
50V
35V
GBL401
100V
70V
GBL402
200V
140V
GBL404
400V
280V
GBL406
600V
420V
GBL408
800V
560V
GBL410
1000V
700V
Maximum DC
Blocking
Voltage
50V
100V
200V
400V
600V
800V
1000V
Electrical Characteristics @ 25°C Unless Otherwise Specified
Maximum Average
Forward Current
Peak Forward Surge
Current
Rating for fusing
Maximum
Instantaneous
Forward Voltage
Maximum DC
Reverse Current At
Rated DC Blocking
Voltage
Typical Junction
Capacitance
GBL4005-404
GBL406-410
Typical thermal
resistance per leg
IF(AV)
O
(1)
IFSM
4.0 A
3.0A
150A
I2t
93A2sec
VF
1.0V
t<8.3ms
IFM = 2.0A;
TA = 25OC
IR
5.0uA
500uA
TA = 25OC
TA = 125OC
CJ
RӰJA
RӰJL
95pF
40pF
22OC/W
3.5OC/W
TC = 50 C
TA = 40OC(2)
8.3ms, half sine
Measured at
1.0MHz, VR=4.0V
.)%
1
0
/
.
F
+
(
'
&
%
$
.)%-$
)$/*%)$
%1
?A>=:?A>=:
.768
.823
A;>>
.453
A97=
.740
.189
.209
A0 35
A?:?
A063
A098
A?9?
A106
A?<?
A031
A016
.026
A>=7
.146
)#$
%%
%)$
%1
<A>8<A>8
19.5
20.9
10.4
11.5
17.3
18.8
4.80
5.30
0.90
>A=8
1.60
=A50
>A?:
=A70
?A89
1.20
0.40
0.66
3.25
3.70
$#;:
Note:
1.Unit mounted on 3.0x3.0x0.11” thick(7.5x7.5x0.3cm)Al. plate
2.Unit mounted on P.C.B. at 0.375”(9.5mm) lead length and
0.5x0.5”(12x12mm) copper pads
3.High Temperature Solder Exemption Applied, see EU Directive Annex Notes 7
Revision: C
www.mccsemi.com
1 of 3
2016/09/21
MCC
Micro Commercial Components
GBL4005 thru GBL410
Fig. 2 -- Maximum Non-Repetitive Peak
Forward Surge Current Per Leg
60 Hz Resistive or Inductive Load
Heat-Sink Mounting
3.0 x 3.0 x 0.11" Thick
(7.5 x 7.5 x 0.3cm)
Aluminum Plate
4.0
3.0
2.0
P.C.B. Mounting
0.47 x 0.47" (12 x 12mm)
Copper pads with 0.375"
(9.5mm) lead length
1.0
Peak Forward Surge Current (A)
Average Forward Output Current (A)
Fig. 1 -- Derating Curves Output
Rectified Current
5.0
0
150
TJ = TJ max.
Single Sine-Wave
(JEDEC Method)
100
50
1.0 Cycle
0
0
50
100
1
150
10
Fig. 4 -- Typical Reverse Leakage
Characteristics Per Leg
100
Instantaneous Reverse Current (A)
Instantaneous Forward Current (A)
Fig. 3 -- Typical Forward Voltage
Characteristics Per Leg
10
1
0.1
TJ = 25°C
Pulse width = 300µs
1% Duty Cycle
0.01
0.4
0.6
0.8
1.0
1.2
1.4
500
100
0.1
TA = 25°C
0.01
0
1.6
100
50 — 400V
600 — 1000V
100
60
80
100
100
10
1
0.1
0.01
0.1
1
10
100
t, Heating Time (sec.)
Reverse Voltage (V)
Revision: C
40
Fig. 6 -- Typical Transient Thermal
Impedance Per Leg
Transient Thermal Impedance (°C/W)
TJ = 25°C
f = 1.0MHz
Vsig = 50mVp-p
10
20
Percent of Rated Peak Reverse Voltage (V)
1,000
1
50 — 400V
600 — 1000V
1
Fig. 5 -- Typical Junction Capacitance
Per Leg
0.1
TA = 125°C
10
Instantaneous Forward Voltage (V)
10
100
Number of Cycles at 60Hz
Ambient Temperature (°C)
Junction Capacitance (pF)
R
www.mccsemi.com
2 of 3
2016/09/21
MCC
R
Micro Commercial Components
Ordering Information :
Device
Packing
Part Number-BP
Bulk: 4.4Kpcs/Carton
Note : Adding "-HF" suffix for halogen free, eg. Part Number-BP-HF
***IMPORTANT NOTICE***
Micro Commercial Components Corp. reserves the right to make changes without further notice to any product herein to
make corrections, modifications , enhancements , improvements , or other changes . Micro Commercial Components
Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it
convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all
risks of such use and will agree to hold Micro Commercial Components Corp . and all the companies whose products are
represented on our website, harmless against all damages.
***LIFE SUPPORT***
MCC's products are not authorized for use as critical components in life support devices or systems without the express written
approval of Micro Commercial Components Corporation.
***CUSTOMER AWARENESS***
Counterfeiting of semiconductor parts is a growing problem in the industry. Micro Commercial Components (MCC) is taking
strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. MCC strongly encourages
customers to purchase MCC parts either directly from MCC or from Authorized MCC Distributors who are listed by country on
our web page cited below. Products customers buy either from MCC directly or from Authorized MCC Distributors are genuine
parts, have full traceability, meet MCC's quality standards for handling and storage. MCC will not provide any warranty
coverage or other assistance for parts bought from Unauthorized Sources. MCC is committed to combat this global
problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized
distributors.
www.mccsemi.com
Revision: C
3 of 3
2016/09/21