AP2004 PWM BUCK CONTROLLER General Description Features • • • • • • • • • • The AP2004 integrates Pulse-Width-Modulation (PWM) control circuit into a single chip, mainly designs for power-supply regulator. All the functions include an on-chip 1.25V reference output, an error amplifier, an adjustable oscillator, a soft-start, UVLO, SCP circuitry, and a push-pull output circuit. Switching frequency is adjustable by trimming CT. During low VCC situation, the UVLO makes sure that the outputs are off until the internal circuit operates normally. PWM Buck Control Circuitry Operating voltage can be up to 27V Under voltage Lockout (UVLO) Protection Short Circuit Protection (SCP) Soft-start circuit Variable Oscillator Frequency -- 300Khz Max 1.25V voltage reference Output 8-pin SOP package Lead Free Finish/ RoHS Compliant for Lead Free and “Green” products (Note 1) SOP-8L: Available in “Green” Molding Compound (No Br, Sb) Applications • • • • Backlight inverter LCD Monitor CDROM, XDSL Product DC/DC converters in computers, etc. Ordering Information AP 2004 X X X Device (Note 2) AP2004S Package Lead-Free Packing S: SOP-8L L : Lead Free G : Green -U : Tube -13 : Taping Package Packaging Quantity Code S SOP-8L Tube Part Number Suffix 100 -U 13” Tape and Reel Quantity Part Number Suffix 2500/Tape & Reel -13 Note: 1. RoHS revision 13.2.2003. Glass and High Temperature Solder Exemptions Applied, see EU Directive Annex Notes 5 and 7. 2. Pad layout as shown on Diodes Inc. suggested pad layout document AP02001, which can be found on our website at http://www.diodes.com/datasheets/ap02001.pdf. AP2004 Rev. 2 1 of 8 www.diodes.com DECEMBER 2006 © Diodes Incorporated AP2004 PWM BUCK CONTROLLER Pin Assignments ( Top View ) ° OUT 1 VCC COMP FB 2 7 3 6 4 5 8 GND CT SS SCP SOP-8L Pin Descriptions Name Description CT Timing Capacitor FB Voltage Feedback SS Soft-Start. COMP Feedback Loop Compensation OUT PWM Output GND Ground VCC Supply Voltage SCP Short Circuit Protection Block Diagram VCC 1.25V CT SS 2.5V Internal use Bandgap Reference Oscillator UVLO VCC MAX.300KHz Iss PWM Amplifier FB + + - OUT Error Amplifier COMP 1.5V 0.7V + + SCP AP2004 Rev. 2 2 of 8 www.diodes.com GND DECEMBER 2006 © Diodes Incorporated AP2004 PWM BUCK CONTROLLER Absolute Maximum Ratings Symbol PD VCC VI VO ISOURCE ISINK TOP TST Parameter Rating 600 28 20 VCC-1.0V 200 200 -20 to +85 -65 to +150 Power dissipation at 25°C Supply voltage Amplifier input voltage Collector output voltage Source current Sink current Operating junction temperature range Storage temperature range Unit mW V V V mA mA o C o C Recommended Operating Conditions Symbol Min. Max. Unit Supply voltage 3.6 27 V VI Amplifier input voltage 1.05 1.45 V VO Collector output voltage Vcc-1.5 V IFB Current into feedback terminal 45 µA RF Feedback resistor 100 CT Timing capacitor 100 6800 pF Oscillator frequency 10 300 KHz VCC FOSC AP2004 Rev. 2 Parameter 3 of 8 www.diodes.com kΩ DECEMBER 2006 © Diodes Incorporated AP2004 PWM BUCK CONTROLLER Electrical Characteristics (T A = 25ºC, VCC = 6V, f = 200 Khz) Reference (REF) Symbol Parameter Comp connect to FB VREF Output voltage change with temperature Under voltage lockout (UVLO) Symbol Parameter VUT Upper threshold voltage (VCC) VLWT Lower threshold voltage (VCC) VHT Hysteresis (VCC) Short-circuit protection (SCP) control Symbol Parameter VIT Input threshold voltage VSTB Standby voltage VLT Latched input voltage ISCP Input (source) current Comparator threshold voltage VCT (COMP) Oscillator (OSC) Symbol Parameter FOSC Frequency Standard deviation of frequency ∆FOSC Frequency change with voltage Error-amplifier Symbol Parameter VIO Input offset voltage IIO Input offset current IIB Input bias current Common-mode input voltage VCM range Open-loop voltage AV amplification GBW Unity-gain bandwidth CMRR Common-mode rejection ratio VOH Max. output voltage VOL Min. output voltage IOI Output (sink) current (COMP) Output (source) current IOO (COMP) AP2004 Rev. 2 Conditions Min. 1.225 Typ. 1.25 -0.1 -0.2 Max. 1.275 ±1 ±1 Unit V % % Min. Typ. 2.9 2.4 500 Max. Unit V V mV Min. 0.60 100 Typ. 0.67 130 50 -15 Max. 0.75 160 100 -20 Unit V mV mV µA TA = -20ºC ~ 25ºC TA = 25ºC ~ 85ºC Conditions IO(REF) = 0.1mA TA = 25ºC Conditions TA = 25ºC No pull up No pull up VI = 0.7V, TA = 25ºC -10 1.5 Conditions CT = 270 pF CT = 270 pF VCC = 3.6V ~ 20V Min. Conditions VO (FB) = 1.25V VO (FB) = 1.25V VO (FB) = 1.25V Min. VCC = 3.6V ~ 20V 1.05 RF = 200 kΩ Typ. 200 10 1 Typ. 160 70 V Max. Unit KHz % Max. ±6 ±100 500 Unit mV nA nA 1.45 V 80 dB 1.5 80 VID = -0.1V, VO = 1.25V 0.5 1.6 MHz dB V V mA VID = 0.1V, VO = 1.25V -45 -70 µA 60 Vref-0.1 1 4 of 8 www.diodes.com DECEMBER 2006 © Diodes Incorporated AP2004 PWM BUCK CONTROLLER Electrical Characteristics (Continued) Output section Symbol ILEAK IDRV VSAT Parameter Conditions VT100 Total device Symbol ICCA Soft Start Symbol Min. Typ. Max. Unit 10 µA Leakage current VO = 25V Sink current VIN = 20V 200 mA Source current VIN = 20V 200 mA Output saturation voltage IO = 10 mA 1.0 VO = 6V 120 ISC Short-circuit output current PWM comparator Symbol Parameter VT0 (TA = 25ºC, VCC = 6V, f = 200 Khz) Conditions Input threshold voltage at f = 10 KHz (COMP) Min. CT Maximum duty cycle Parameter Conditions Average supply current Conditions V mA Typ. Max. Unit 0.6 0.7 V 1.2 1.3 Min. Typ. Max. Unit 6 10 mA Typ. Max. Unit CT = 270pF Parameter 1.5 Min. V VSS Soft-start Voltage 2.3 V ISS Constant Charge Current 20 µA Typical Application Circuit R3 1K~30K Vcc = 12V C2 10nF Optional Q1 1 OUT GND 8 2 VCC CT 7 3 COMP SS 6 FB SCP 5 4 P mos AF9435P AF4835P 5A C1 470uF L1 22uH R1 9K Output 5V/5A C4 50nF Optional C3 470uF R2 3K C4 270pF C5 50nF C6 220nF ⎛ ⎝ Vout=Vref ⎜1 + R1 ⎞ ⎟ R2 ⎠ Step-Down DC/DC converter AP2004 Rev. 2 5 of 8 www.diodes.com DECEMBER 2006 © Diodes Incorporated AP2004 PWM BUCK CONTROLLER Typical Characteristics REFERENCE OUTPUT VOLTAGE vs. POWER-SUPPLY VOLTAGE AVERAGE SUPPLY CURRENT vs. POWER-SUPPLY VOLTAGE 5 Icc-Average Supply Current (mA) VrefReference Output Voltage (V) 1.26 1.255 1.25 1.245 1.24 1.235 1.23 1.225 1.22 4 8 12 16 20 24 4 3 2 1 0 28 0 4 Vcc-Power Supply Voltage (V) AVERAGE SUPPLY CURRENT vs. AMBIENT TEMPERATURE VCT (V) ICC - Average Supply Current (mA) 6 5 4 3 2 -25 0 25 50 75 0 100 tscp-SCP Time-out Period (ms) fosc - Frequency (KHz) 300 250 200 150 100 50 28 VCT(min) VCT(max) 100 200 300 30 25 20 15 10 5 1100 1600 2100 2600 3100 3600 4100 4600 5100 5600 6100 6600 0 45 90 135 180 225 270 315 360 405 450 495 Cscp - SCP Capacitance (nF) CT-Timing Capacitor (pF) AP2004 Rev. 2 24 SCP TIME-OUT PERIOD vs. SCP CAPACITANCE 35 0 600 20 Frequency (KHz) OSCILLATOR FREQUENCY vs. TIMING CAPACITANCE 100 16 1.6 1.4 1.2 1 0.8 0.6 0.4 0.2 0 TA - Ambient Temperatrure(℃) 350 12 VCT vs. Frequency 7 -50 8 Vcc - Power-Supply Voltgae (V) 6 of 8 www.diodes.com DECEMBER 2006 © Diodes Incorporated AP2004 PWM BUCK CONTROLLER Typical Characteristics (Continued) 30 SOFT-START TIME (Ts) vs. SOFT-START CAPACITOR (Css) Ts (mS) 25 20 15 10 5 0 25 50 75 100 125 150 175 200 Css (nF) Marking Information (1) SOP-8L (Top view) 5 8 Part Number Logo Blank : Lead - Free Package G : Green AP2004 YY WW X X 4 1 AP2004 Rev. 2 7 of 8 www.diodes.com ~ SOP Internal code Xth week: 01~52 Year: "01" =2001 "02" =2002 DECEMBER 2006 © Diodes Incorporated AP2004 PWM BUCK CONTROLLER Package Information (All Dimensions in mm) 0.254 0.08/0.25 5.79/6.20 3.70/4.10 (1) Package Type: SOP- 8L (JEDEC Small Outline Package) Gauge Plane Seating Plane 0.38/1.27 Detail "A" 7°~9° 0.20typ 1.75max. 1.30/1.50 0.35max. 45° 0.3/0.5 1.27typ 7°~9° Detail "A" 3.70/4.10 4.80/5.30 IMPORTANT NOTICE Diodes Incorporated and its subsidiaries reserve the right to make modifications, enhancements, improvements, corrections or other changes without further notice to any product herein. Diodes Incorporated does not assume any liability arising out of the application or use of any product described herein; neither does it convey any license under its patent rights, nor the rights of others. The user of products in such applications shall assume all risks of such use and will agree to hold Diodes Incorporated and all the companies whose products are represented on our website, harmless against all damages. LIFE SUPPORT Diodes Incorporated products are not authorized for use as critical components in life support devices or systems without the expressed written approval of the President of Diodes Incorporated. AP2004 Rev. 2 8 of 8 www.diodes.com DECEMBER 2006 © Diodes Incorporated