SL Power LS15 Series line splitter Datasheet

LS15
Series Line Splitter
PoE
1 Year Warranty
• Power over Ethernet (PoE)
• Converts POE to Separate Power and Data Lines
• High Efficiency: 90%, 24V unit
• Industry Leading Small Profile; 3”x 2.1”x 1”
• Meets IEEE 802.3AF
• Full Thermal Protection
• Short Circuit & Overload Protection
• Input Shutdown
• UVLO / OVLO
• Surge Protection
International Safety Standard Approvals
Specifications
General Specifications
Output Specifications
Line and Load
Voltage Regulation
+/-1% V-out
Transient Response
1% of V-out
(50%-100% load deviation)
Overvoltage Protection
Transorb protected
Output Connection
Standard
Output Noise
1% of V-out, 20MHz BW
Input Specifications
Input
Input Current
Overload Protection
Reset power
to start unit
Input Surge
Input Undervoltage
Efficiency
5V
12V
24V
Measured from Data/Power
pins of RJ45 connector,
to.output of std Switchcraft
712A conn.
87% min.
88% min.
90% min.
Switching Frequency
200kHz +/- 1%
Recovery time
100Usec to 1% V-out
(SR= 1a/10Usec)
I-overload
120% ± 5%
36-57 Vdc
Short Circuit
When Iin > 450mA for
75mSec, input latches off
Auto recovery when short
is removed
Thermal Shutdown
Internally protected against
over-temp conditions.
Approvals and
Safety Standards
TUV Pending
Case and Dimension
3.0L x 2.1W x 1.0H (in)
Weight
58g (2.05oz)
Input Connector
Standard RJ45 connector
Transorb protected
Turn on
Turn off
In Midspan
configuration
33-42Vdc
30-34Vdc
Environmental Specifications
Operating temperature
-40°C to +60°C
Storage Temperature
-40°C to +85°C
Max ambient
operating Temp
60*C @ Full load
SL Power Electronics Corp • 6050 King Drive • Ventura, CA 93003 • Phone:805.486.4565 • Fax:805.487.8911 • Email:[email protected] • www.slpower.com
LS15
Series Line Splitter
PoE
Ault Part Number
For the most current data and application support visit www.slpower.com
Output
Voltage
Output Current
Per IEEE 802.3AF*
Output
Power
Efficiency
(with cable)
LS15-05
5 V DC
2.00 A
10.0 W
480 mV
LS15-12
12 V DC
0.90 A
10.8 W
480 mV
LS15-24
24 V DC
.475 A
11.4 W
480 mV
Notes
* Power limited per Input requirements of IEEE802.3af Table 33-12. I-port Max=350mA @V-port=37V./ I-port Max=260mA @V-port=57V
Higher outputs available for non-compliant systems
Outline Configuration
2 of 3
SL Power Electronics Corp. • 6050 King Drive • Ventura, CA 93003 • Phone:805.486.4565 • Fax:805.487.8911 • Email:[email protected] • www.slpower.com
LS15
Series Line Splitter
PoE
Data/Power in & Data Out Connection
Power Out Connection
87654321
Standard RJ45 Jack
Configuration- For 802.3af compliant units
Pin
Mode A
1
Pos Vport, Neg Vport
2
Pos Vport, Neg Vport
3
Neg Vport, Pos Vport
Mode B
4
Pos Vport, Neg Vport
5
Pos Vport, Neg Vport
6
Description
Switchcraft RAPC 712A connector
or equivalent
Pinout Code
Center contact: positive
Suggested Mating
Switchcraft 760 plug or equivalent
Description
12”, 18AWG Cable w Switchcraft S760
connector or equivalent
Pinout Code
Center contact: positive
Suggested Mating
Switchcraft 722A plug or equivalent
Description
12”, 18AWG Cable w Switchcraft 760
connector or equivalent
Pinout Code
Center contact: positive
Suggested Mating
Switchcraft 712A plug or equivalent
Neg Vport, Pos Vport
7
Neg Vport, Pos Vport
8
Neg Vport, Pos Vport
3 of 3
SL Power Electronics Corp • 6050 King Drive • Ventura, CA 93003 • Phone:805.486.4565 • Fax:805.487.8911 • Email:[email protected] • www.slpower.com
Data Sheet © 2007 SL Power Electronics Corp. The information and specifications contained in this data sheet are believed to be correct at time of publication. However, SL Power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice.
Rev. 04/19/07
Similar pages