GSIB405 THRU GSIB4100 SINGLE PHASE GLASS PASSIVATED BRIDGE RECTIFIER Voltage: 50 to 1000V 4.0A Current: Features GSIB-3S Glass passivated chip junction Ideal for printed circuit board High surge current capability High case dielectric strength Mechanical Data Terminal: Plated leads solderable per MIL-STD 202E, Method 208C Case: UL-94 Class V-0 recognized Flame Retardant Epoxy Polarity: Polarity symbol marked on body Mounting position: any Dimensions in millimeters MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half -wave, 60HZ, resistive or inductive load rating at 25°C, unless otherwise stated, for capacitive load, derate current by 20%) Symbol GSIB4 05 GSIB4 10 GSIB4 20 GSIB4 40 GSIB4 60 GSIB4 80 GSIB4 100 units Maximum repetitive peak reverse voltage Vrrm 50 100 200 400 600 800 1000 V Maximum RMS voltage Vrms 35 70 140 280 420 560 700 V Maximum DC blocking voltage Vdc 50 100 200 400 600 800 1000 V If(av) 4.0 2.3 A Ifsm 130 A Vf 0.95 V I2t 60 A2Sec Ir 10.0 250 µA (Note2) (Note1) Rth(ja) Rth(jc) 26.0 5.0 ℃/W Operating junction and storage temperature range Tj, Tstg -55 to +150 ℃ Maximum average forward Tc = 100℃(Note 1) Rectified output current at Ta = 25℃(Note 2) Peak forward surge current single sine-wave superimposed on rated load (JEDEC Method) Maximum instantaneous forward voltage drop per leg at 2.0A Rating for fusing (t < 8.3ms) Maximum DC reverse current at rated DC blocking voltage per leg Maximum thermal resistance per leg Ta = 25°C Ta = 125°C Note: 1. Unit case mounted onAl plate heatsink 2. Unit case mounted on P.C.B. with 0.5 x 0.5” (12 x 12mm) copper peads and 0.375”(9.5mm) lead length 3. Recommended mounting position is to bolt down on heatsink with silicone thermal compound for maximum heat transfer with #6 screw Rev.A8 www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES GSIB405 THRU GSIB4100 Rev.A8 www.gulfsemi.com